Minka Lavery 4138-84 Instructions / Assembly
Contents
1. Ground HOUSE WIRES JOUSE WIRES Black Hot l 1 HOUSE wires White Neutral Green or Bare Copper Ground american cf US Teast LisTeD eola2. INSTALLATION INSTRUCTIONS FOR 4138 AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER READ AND SAVE THESE INSTRUCTIONS PREPATION Fig 1 1 Shut off the power at the fuse box or circuit breaker box If necessary remove the old fixture including the mounting hardware 2 Carefully remove the new fixture from the carton and check that all parts are included as shown in the illustration ASSEMBLING THE FIXTURE Fig 1 3 Determine the desired hanging height and thread rods G H I J onto the nipple K Carefully pass the wires through each rod as you assemble Please remove the nipple if installing with one 6 or one 12 rod only 4 Loosen the screws D Size 5 32 0 4 L and remove the canopy C 5 Slip the canopy C over the rod G and thread the nipple F into the rod G MOUNTING THE FIXTURE Fig 1 6 Raise the mounting strap A to the junction box not provided then secure with the junction box screws B Size 8 32 0 6 L the side of the mounting strap marked GND must face out 7 Install the fixture body into the mounting plate A by tilting at a slight angle so that the hanger ball E slips into the mounting plate A as shown Align the notch in the hanger ball E to the tab on the mounting plate A to prevent the fixture from turning CONNECTING THE WIRES Fig 2 8 At this point connect the electrical wi
3. res as shown in figure 2 making sure that all wire connectors are secured If your outlet has a ground wire green or bare copper connect the ground wires from the hanger ball and mounting plate to it Otherwise connect the ground wire from the hanger ball directly to the mounting plate ground wire and secure with the wire connectors provided After wires are connected tuck them carefully into the ceiling junction box COMPLETING THE INSTALLATION Fig 1 9 Raise the canopy C to the mounting strap A and align the mounting screws D to the slots L Then turn canopy C clockwise until mounting screws D are in the narrow part of slots L Tighten mounting screws D with a screwdriver 10 Install the light bulbs Included in accordance with the fixture s specifications DO NOT EXCEED THE MAXIMUM WATTAGE NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE Note Press spring coupling M by hand and adjust to the desired length of steel wire N Your installation is now complete Return power to the outlet box and test the fixture Set LTG BKT 10 Mounting strap Ground screw Mounting screws 2 Junction box screws 2 ee sJ K I Fig 2 i i To Sr U2 U2 FIXTURE FIXTURE FIXTURE WIRES 1 WIRES 1 WIRES Black White Green or Bare 1 Copper
Download Pdf Manuals
Related Search