Sea Gull Lighting 8231-12 Installation Guide
Contents
1. TO WHITE HOUSE WIRE BLACK PARALLEL WIRE SQUARE amp RIDGED Note When parallel wire is used the tracer wire is square shaped or ridged and less tracer wire is round in shape or smooth Seen best when viewed from wire end To separate wires grasp the ends of each wire and pull apart B Take your fixture wire s from group A and place evenly against the black wire from the outlet box DO NOT twist wires together before using wire connectors C Fit a wire connector not supplied over the wires and thread the connector clockwise until you feel a firm resistance D Gently try to remove the wires from the connector If you can remove the wires carefully re do steps B and C as above and check again for a firm connection E Connect the fixture wire from group B to the white wire from the outlet box in the same manner GROUND INSTRUCTIONS Connect the ground wire from the fixture bare metal or green insulated wire to the ground wire from the power supply bare metal or green insulated wire using a small wire connector not supplied NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES Slide fitter E onto post Secure in place2. ordered from place of purchase Be sure to use exact wording from illustration when ordering parts BEFORE YOU BEGIN Carefully remove the fixture from the carton and check that all parts are included as shown in Figure 1 Be careful not to misplace any of the screws or parts which are needed to install this fixture INSTALLATION STEP 1 Install glass panels A inside of cage D if applicable Installation And Safety Instructions HC 279 102908 Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM IMPORTANT SAFETY INSTRUCTIONS O S5 FNAL ROOF B CAGE SCREWS CHIMNEY F GLASS PANELS A COAN FITTER E FIGURE 1 FIGURE 1 NOT INCLUDED INSTALLATION continued HC 279 FINAL ASSEMBLY STEP 2 Make sure no bare wires can be seen outside wire connectors A Take note of the color of the wire s on your fixture Identify which STEP 5 group your fixture wire s falls into and connect the wires according to the directions below Install candle covers if applicable STEP 6 Install lamp STEP 7 Install chimney F if applicable STEP 8 Place roof B onto cage D and secure in place with cage screws C Thread finial G onto mounting nipple protruding through i 4 GROUP A GROUP B CONNECT TO BLACK HOUSE WIRE CONNECT
3. SeaGulllighting e Be sure the electricity to the system you are working on is turned off either the fuse removed or the circuit breaker set at off e Use of other manufacturers components will void warranty listing and create a potential safety hazard e If you are unclear as to how to proceed contact a qualified electrician e You don t need special tools to install this fixture e Be sure to follow the steps in the order given e Read instructions carefully e Proper wiring is essential for the safe operation of this fixture e Do not install on a post or a pole that results in a vertical rise of 25 feet or higher e Save these instructions THERE IS A VARIATION IN ALL CASTINGS IN SOME CASES THE GLASS PANELS MAY BE SLIGHTLY LOOSE WHEN INSTALLED YOU MAY WANT TO TAPE IT IN PLACE TWO 7 SIDED TAPE HAS BEEN SUPPLIED FOR THIS PURPOSE REMOVE PROTECTIVE PAPER FROM EACH SIDE OF TAPE PLACE ON UPPER END OF GLASS INSTALL AND PRESS AGAINST CASTING CAUTION FIXTURES WITH PHOTO CELLS SHOULD BE MOUNTED AT LEAST 48 FROM ALL SIDES TO AVOID REFLECTION OF LIGHT BACK ota peewee CAUSING THE PHOTO CELL TO MALFUNCTION OR CLEANING To clean wipe fixture with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts Parts for this fixture can be
Download Pdf Manuals
Related Search