Minka Lavery 4930-284 Instructions / Assembly
Contents
1. the ceiling junction box as you are holding the fixture assembly toward the ceiling 6 Finishing mounting the fixture pan I by placing it over both HEX NUTO mounting screws F so that the screws protrude through the CRP key holes in the steel pan I Rotate the pan I until the oe screws are seated in the slots of the key holes and tighten the screws with a screwdriver 7 Thread the Nipple M into the Coupling J The lower nipple length could be adjusted and secured by adjusting the location of the hex nut on the Nipple M to install the lower parts of the fixture 8 Install the light bulbs in accordance with the fixture s specifications DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE FLAT WASHER N 9 Insert the glass shade L plastic washer H Flat Washer N Fig 2 over the center nipple M in that order then secure with hex FIXTURE 7 FIXTURE FIXTURE nut O WIRES WIRES WIRES 10 Insert the bottom cap P on to the center nipple M and peda as nae thread the finial Q onto the center nipple M until snug EWR _ Ground Your installation is now complete Return power to the junction box to test the fixture eee douse SURE WIRES WIRES WIRES Black White Green Hot Neutral Ground american lighting C N US association Intertek2. INSTALLATION INSTRUCTIONS For Fixture 4930 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR PREPARING THE FIXTURE FIG 1 1 Shut off the power supply at the fuse box or circuit breaker If Fig 1 necessary remove the old fixture from ceiling including the mounting hardware Set A A 010 2 Carefully remove the fixture from the carton and check that all Greet eee 2 OUTLET BOX A parts are included as show in Figure 1 Mounting screws 2 tt suppey WRES RENAT o ae MOUNTING THE FIXTURE FIG 2 IA o ae 3 Thread the 2 mounting screw F about 1 4 into the i ee pre drilled holes in the Crossbar G spaced the same Pe ae a OUTLET BOX SCREWS E distance apart as the holes in the fixture See Fig 1 4 Attached the Cross bar G to the outlet box using the 2 Outlet STEEL PAN D Box Screws E The side of the Cross bar G marked GND must face out amp ____ SOCKET K 5 While holding the steel pan I towards the Crossbar G COUPLINGO NIPPLE WITH HEX NUTM connect the electrical wires as shown in figure 2 If your outlet has a ground wire green or bare copper connect the fixture Ground Wire to it Otherwise connect the fixture ground wire directly to the crossbar using the green screw provided Make ee sure that all wire connectors are secured Tuck the wire os harsh tae connections neatly into
Download Pdf Manuals
Related Search