Sea Gull Lighting 59440BLE-15 Installation Guide
Contents
1. E sea gull lighting IMPORTANT SAFETY INSTRUCTIONS e Be sure the electricity to the system you are working on is turned off either the fuse removed or the circuit breaker set at off e Use of other manufacturers components will void warranty listing and create a potential safety hazard e f you are unclear as to how to proceed contact a qualified electrician e You don t need special tools to install this fixture e Be sure to follow the steps in the order given e Under no circumstances should a fixture be hung on house electrical wires nor should a swag type fixture be installed ona ceiling which contains a radiant type heating system e Read instructions carefully e Save these instructions NOTE FOR FIXTURES PROVIDED WITH 75 C OR 90 C SUPPLY WIRE WARNING ONLY THESE WARNINGS ARE PROVIDED ON THE LABEL AND ON THE FIXTURE CARTON RISK OF FIRE MOST DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60 C CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLING OUTLET BOX GROUND WIRE WIRE CONNECTOR MOUNTING BAR A NUT B OUTLET BOX eam CANOPY oS ee CENTER HOLE H A RETAINING SCREWS E NIPPLE C CAP NUT F gt VV VV Pr DIFFUSER G FIGURE 1 NOT INCLUDED Installation And Safety Instructions Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to this fixture Fill in Item Number on Car2. ton and File This Sheet For Future Reference ITEM HC 1502 121208 CLEANING To clean wipe fixture with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts Parts for this fixture can be ordered from place of purchase Be sure to use exact wording from illustration when ordering parts BEFORE YOU BEGIN Carefully remove the fixture from the carton and check that all parts are included as shown in figure 1 Be careful not to misplace any of the screws or parts which are needed to install this fixture INSTALLATION IMPORTANT DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX STEP 1 Secure mounting bar A to outlet box with outlet box screws not supplied Thread nut B on nipple C so that 3 threads are exposed above nut B Thread nipple C into mounting bar A and secure with nut B INSTALLATION continued HC 1502 FIXTURES WITH A ONE PIECE LAMP BALLAST COMBINATION lt gt STEP 2 A Use a listed wire connector to connect the fixture hot wire black wire or round and smooth tracer to the supply hot wire B Use a listed wire connector to connect the fixture common wire white wire or square and rigid to the supply common wire C Gently try to remove the wires from the connector If you can remove the wires caref
3. ully re do the wiring connection SELF gt BALLASTED LAMP I STEP 3 GROUNDING INSTRUCTIONS The green grounding screw is to be inserted into the hole with two raised dimples provided on the mounting bar A Wrap the ground wire from the fixture if supplied and the ground wire from the outlet box bare metal or green insulated wire around the green grounding screw on the mounting bar A if uninsulated wire is on the mounting bar A connect the ground wire from the fixture and the outlet box to it using a small SOCKET J gt wire connector not supplied NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES FIGURE 2 FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors STEP 1 After wires are connected tuck them carefully inside outlet box Raise canopy D to the ceiling allowing for nipple C to protrude through center hole H in canopy D Secure in place by threading cap nut F onto nipple C STEP 2 Install self ballasted lamps I by gently twisting into socket J STEP 3 Raise diffuser G so it fits inside of canopy D Finger tighten retaining screws E through canopy D in to diffuser G MARK MEANS LAMP CONTAINS MERCURY FOLLOW DISPOSAL LAWS SEE WWW LAMPRECYCLE ORG
Download Pdf Manuals
Related Search