Anchor 600355NOR Installation Guide
Contents
1. Fresco Fire Pit Kit with Insert LI ANCHOR BUILD SOMETHING BEAUTIFUL yok sz Ys Rules for r Sa O perat ti ON Read and understand before assembly and use of fire pit Always use in accordance with all e Care should be taken to make sure all applicable local and state fire codes combustible material is far enough away from the fire ring not to ignite it Failure to follow these instructions could result in a hazardous fire causing property Avoid using softwoods such as pine or PE cedar because they are likely to throw damage or physical injury sparks hardwoods are recommended Caution For outdoor use only Keep children and pets away from the fire Use the fire ring on stone dirt or sand surfaces m eaa ring while it is in use e For adult use only do not allow children e Exercise the same precautions you would to use the fire ring with any open fire e Do not use on lawns wooden decks Do not wear flammable or loose clothing concrete or asphalt when tending an open fire Do not use fire ring indoors or under a e Avoid touching surfaces as they will be patio roof extremely hot e Do not use in windy conditions e Assure the fire is completely extinguished e Do not leave fire unattended at any time before leaving fire ring e Do not use under tree branches trellis or e Any modifications to this appliance may overhangs of any kind including covered be dangerous and are not permitted N flamma2. ble liquids such as oe aa E a aa preva nce e Tape Measure e Garden Rake e Rubber Mallet gasoline alcohol diesel fuel kerosene or e Marking Paint for yards e Level e Concrete Adhesive e Chalk for marking patios e Paver Base e Caulking Gun charcoal lighter fluid to light or relight fires Fresco Fire Pit Kit with Insert Assembly Instructions Always use in accordance with all applicable local and state fire codes 1 If putting your fire pit on a lawn mark a 53 inch diameter circle and remove all sod and roots inside the circle Dig approximately 2 inches deep If putting your fire pit on a patio mark the circle with chalk and skip ahead to step 4 4 Place 19 wall block units on top of paver base Lay them tightly together to form the circle Level each stone front to back and side to side Make sure each stone is even with the previously leveled block Use a rubber mallet to level o e e o e e e J e e e 7 After the 2nd layer is finished install the 3rd by placing the center of each block in line with the joint of the blocks below When the 3rd course is all lined up glue the blocks one at a time as in step 6 2014 Anchor Block Company 5959 Baker Road Suite 390 Minnetonka MN 55345 www anchorblock com 2 Check the level of the soil inside the circle in all directions Remove soil from the high spots to bring it close to level a eeeoeoodeed0e8080 5 After the Ist course
3. is set and leveled start the 2nd course by placing the center of the top block in alignment with the joint between the blocks below Continue this all the way around the circle 8 Next lower the fire pit liner inside the blocks The outside flange of the liner should be centered and rest on the inside edge of wall block units 3 Add 1 5 2 inches of paver base to your circle and rake it level Using a tamper pack the entire area of paver base until firm Make sure the surface is level before laying blocks 6 Once the 2nd course is all lined up carefully remove one block ata time and apply two thick beads of concrete adhesive to the center of the blocks Reinstall the block and push down firmly Continue for all remaining blocks on 2nd course 9 After the adhesive cure time has lapsed pour lava rock into the fire pit until the level reaches the bottom of the fire ring liner My ANCHOR BUILD SOMETHING BEAUTIFUL 14 0332 1 02 14
Download Pdf Manuals
Related Search