Wheelzbarrow WB-COMP-001 Instructions / Assembly
Contents
1. Slide the right side of the tube handle into left side of tube handle Now rotate right side of tube handle on right wheelbarrow handle Tap tube handle until completely in place Step 3 Drill a 1 8 pilot hole into wheelbarrow handles through holes at each end of tube handle Make sure tube handle is fully onto wheelbarrow handles Step 4 Screw wood screws N into 1 8 pilot holes BRAKE AND HITCH INFORMATION To tighten or loosen brake handle movement tighten or loosen nut on this screw To release brake pull handle towards you until handle is away from brake stop and then push handle down CROSSBAR BRAKE STOP Attaching Hitch LEFT LEG 5 8 AXLE FRONT TIRE U BOLT Note Brake shown in ON position For replacement parts or warranties visit www wheelzbarrow com or call 855 838 26462. pattern Retighten undercarriage nuts 4 WHEEL GUARD ASSEMBLY Step 1 Use two bolts M and two nuts O to attach wheel guard C to front of handles TIP Bolts should point to the inside of the handles Use a in wrench or socket to fully tighten wheel guard Leave the rest of the nuts and bolts loosely fastened 5 ATTACH FRONT WHEEL AXLE BRACKET Step 1 Loosely attach axle bracket E to bottom of handle using two bolts L and two nuts O O TIP Don t tighten the nuts at this time 6 FRONT WHEEL ASSEMBLY Step 1 Slide axle F through wheel G and through spacer P and then into attached bracket Step 2 Slide second spacer P and second axle bracket E over other end of axle Step 3 Loosely attach second axle bracket to handle using bolts L and nuts O Use a 2 in wrench or socket to fully tighten all nuts O TIP To keep wheel from sliding side to side after assembly push axle brackets toward each other prior to tightening REAR WHEEL ASSEMBLY Step 1 Slide cotter pin R through the inner hole of axle Step 2 Slide Washer Q onto axle until touching pin Step 3 Next slide the wheel on axle until it reaches washer Step 4 Finally slide on another washer and insert cotter pin into outer hole Step 5 Repeat for the other side 8 EASY COMFORT GRIP ASSEMBLY Step 1 Place the left side of the tube handle 1 onto the left wheelbarrow handle Push it on partially Step 2
3. TM SIAE A DG NMONA ASSEMBLY INSTRUCTIONS Easy Comfort Grip x1 HARDWARE CONTENT TM 5 Yin Bolt x2 i 2 84 in Bolt x2 is Spacer x2 EXPLODED VIEW Read all instructions prior to assembly Tools Required e in wrench or 2 in deep drive socket e Flat head screwdriver e Phillips screwdriver e Drill and 18 bit WARNING Tire is not for highway service Do not over inflate tire Maximum tire inflation 30 psi Tire changing and or inflation can be dangerous and should be done only by trained personnel using proper INSTRUCTIONS RISER ASSEMBLY Step 1 Push bolts J through bottom of tray towards the front and through the wide side of the riser D Step 2 Push bolts K through bottom of tray towards the back and through the small side of the riser D Step 3 Arrange riser B so that wider side is facing the front of tray Slide over bolts Step 4 Repeat for second riser 0 TIP The riser will grab the bolts and hold them in place 2 ATTACH WOODEN HANDLES Step 1 Turn tray over Step 2 Place handles A over bolts and lower onto risers 3 ATTACH UNDERCARRIAGE Step 1 Attach undercarriage small slots facing back side of tray to four bolts using nuts O Wait to tighten in Step 6 Q TIP l Iftheboltholes don t line up to the four bolts loosen crossbar nuts and loosen axle u bolt nuts and align undercarriage to your wheelbarrow bolt
Download Pdf Manuals
Related Search