APEC Water Systems CS-2500 Instructions / Assembly
Contents
1. fabricated and or installed in the manner recommended by APEC in the Installation Instruction amp Owner s Manual Manual Repair or Replacement Repair or replacement during this one 1 year warranty shall include reasonable labor charges necessary to repair or replace the de fective Product but shall not include freight charges or any other local labor charges from third parties other than APEC unless APEC expressly approves such charges in writing During the entire one 1 year warranty APEC s obligation to repair or replace shall further be limited to repair or replacement with the styles models products colors etc of the Product that are available at the time of the repair or replacement and shall be limited to the repair or replacement of only the specitic Product that tails due to a manufacturing detect Any repaired or replaced product shall also remain subject to the original one 1 year warranty trom the date of the original purchase and any repair or replacement shall not extend the original warranty period in any manner or start a new warranty period Conditions of Validity of this Limited Product Warranty Even though the Product has extremely high endurance for operating conditions such as pH maximum TDS temperature and opti mum water pressure THIS LIMITED PRODUCT WARRANTY SHALL ONLY BE VALID IF 1 The replaceable filters are changed and maintained on a regular basis as directed in the Manual Moreover d2. spills hold the filter in an upright position Lay the old tilter on a towel to absorb any water that drips Out Hold on to the new filter with the label side facing you and align the two teeth indent to the two teeth on the cap Atter the tilter and the cap is align gently push up and turn Clockwise until it locks in place Gently pull down to make sure the filter is secure in place Turn on feed water Check for leaks Turn on the cold water Slowly turn on your taucet and let it flush the Cold water supply Turn new system for up to 5 counter clockwise to minutes allow the raw water to enter the system End Filter Change Section LIMITED PRODUCT WARRANTY Scope APEC takes pride in selling a superb line of products including this water filtration system Product As such APEC expressly warrants to the original purchaser that for a period of one 1 year from the date of purchase the Product will be reasonably free of detects in materials and workmanship Within that one 1 year period trom the original purchase APEC will at its option repair or replace the Product without charge or refund the cost of the Product if the Product tails or does not perform as warranted solely due to a manufacturing detect within the warranty period subject to the limitations and exclusions set forth in this Limited Product Warran ty This Limited Product Warranty only applies when the Product is used stored handled
3. turn on your faucet and let it flush the Cold water supply Turn new system for up to 5 counter clockwise to minutes allow the raw water to enter the system Congratulations You have successfully installed the APEC Water Filtration System End Installation Section SYSTEM MAINTENANCE The system requires very little maintenance Just change the filter cartridges regularly as indicated on the filter label Replacement time may vary based on the condition of source water Keep the system indoors away from extreme heat or cold temperatures and run the system within its reasonable output capacity i e allow the system to rest at least a few hours a day To properly maintain your APEC water filtration system please use only genuine APEC Water replacement filters at www FreeDrinkingWater com filters Filter Change Instruction Locate the Cold water supply valve under the kitchen sink the round or oblong handle on the right side Turn off the incoming cold water completely by turning the shut off handle clockwise Note Ifthe cold water shut off valve cannot turn off the water the main water supply to the house must be shut off for the installation Turn the faucet handle to the ON position of cold water side to release the remaining water and reliet the built up pressure inside the system Hold on to the system and remove the tilter by turning Counterclockwise and gently pull down to remove the fil ters To prevent
4. CS 2500 Water Filtration System INSTALLATION INSTRUCTION amp OWNER S MANUAL APEC WATER fy ae FREE DRINKING WATER com Sey ey Cr All Rights Reserved APEC Water Systems Thank you for choosing APEC reverse osmosis systems You now own the finest water filter in America Please read and become familiar with instructions and parts needed before proceeding with the installation BEFORE INSTALLATION Inspect the system Please take the system and all the components out of the box Inspect the system and all the connection fittings carefully make sure nothing is damaged during shipping It any part is cracked or bro ken please do not proceed with the installation and contact APEC or your distributor for an exchange or diagnosis Recommended tools list Variable speed drill Adjustable wrench pliers Phillios screwdriver Utility knite or scissors Tetlon tape Operating Parameter Operating pressure 100psi maximum Feed water temperature 35 100 degree F 2 37 degree C Do not connect this unit to hot water source Install the system in a sheltered environment avoid exposure to hot and cold weather or under direct sun light General Installation Operation Maintenance Requirements Installation needs to comply with state and local laws and regulations System must be installed indoor away trom possible environmental damage Do not use with water that is microbiologically unsafe or of unknown quali
5. e manufacturing defects at the time of installation 6 Damage caused by freezing tlood tire or Act of God CONDITIONS THAT RENDER THIS LIMITED PRODUCT WARRANTY VOID THIS LIMITED PRODUCT WARRANTY SHALL BE VOID IF 1 The Product is not operated in compliance with normal municipal water conditions tor which the particular model of this Product is intended 2 The person seeking to invoke the warranty is not the original purchaser That is this Limited Product Warranty only extends to original purchasers 3 The is purchased used That is this Limited Product Warranty only covers new products 4 The Product is purchased trom someone other than APEC or one of APEC s authorized dealers This is because unless the Product was sold by APEC or one ot its authorized dealers APEC cannot verity or guarantee the integrity or authenticity of the Product General Conditions The warranties set forth herein are the only warranties made by APEC in connection with the product APEC cannot and does not make any implied or express warranties with respect to the product and disclaims all other warranties includ ing but not limited to any warranty of merchantability or fitness for a particular purpose Products sold by APEC are sold only to the specifications specifically set forth by APEC in writing Other than the limited product warranty set forth herein APEC makes no other warranties express or implied APEC s sole obligation under this warra
6. epending on local water input water quality regular maintenance may need to be increased 2 The Product is operated within the contines of the following standard operating conditions Water Pressure Water Temperature Water Filtration System 20 100 psi 35 100 F Any information or suggestion by APEC with respect to the Product concerning applications specitications or compliance with codes and standards is provided solely for your convenient reference and is made without any representation as to accuracy or suitability You must verity and test the suitability of any information with respect to the Product for your specitic application Non Covered Defects THIS LIMITED PRODUCT WARRANTY DOES NOT COVER DEFECTS CAUSED BY 1 Improper storage installation maintenance handling use and or alterations of the Product including but not limited to non compliance with the installation maintenance and standard operation conditions stated in the Manual and this Limited Product Warranty 2 Unreasonable use unintended use or misuse of the Product for something other than its intended purpose as a reverse osmosis system 3 Use of replacement parts filters membranes or other accessories that are not sold or manufactured by APEC for use with this particular Product 4 Damage not resulting from manufacturing defects that occur while the Product is in the original purchaser s possession 5 Installation of the Product with known or visibl
7. nty shall be repair or replacement of a non conforming product or parts of the product or at the option of APEC return of the product and a refund of the purchase price Buyer assumes all risk whatsoever as to the result of the use of the product purchased whether used singularly or in combination with any other products or substances No claim by the buyer owner of any kind including claims for indemnification shall be greater in amount than the purchase price of the products in respect to which damages are claimed In no event shall APEC be liable to buyer owner in tort contract or otherwise for any special indirect incidental consequential reliance statutory special punitive or exemplary damages including but not limited to lost profits loss of use loss of time inconvenience damage to good will or reputation or loss of data even if advised of the possibility of such damages or such damages could have been reasonably foreseen in connection with arising out of or as a result of the sale delivery servicing use or loss of use of the products sold hereunder or for any liability of buyer to any third party with respect thereto Obtaining Warranty Coverage or General Inquiries If coverage is available you may obtain coverage under this Limited Product Warranty by providing APEC with proof of original purchase and that you are the original purchaser For service under this Limited Product Warranty you must notity APEC by phone a
8. t 1 800 880 4808 by email at techsupport treedrinkingwater com or in writing at 1320 S Johnson Dr City of Industry CA 91745 In making the claim please provide your name address phone number a description of the product involved and an explanation of the detect Advanced Purification Engineering Corp 1320 S Johnson Drive City of Industry CA 91745 For questions or comments please visit our website at FreeDrinkingWater com For technical support contact us at Techsupport freedrinkingwater com 1 800 880 4808
9. turning the shut oft handle clockwise Note Ifthe cold water shut off valve cannot turn off the water the main water supply to the house must be shut off for the installation 2 Turn the taucet handle to Disconnect the existing the ON position to release fittings and hose from the the remaining water cold water supply valve to the taucet Step 2 Mounting the Bracket Hold the system with the filter label side facing you Look on top of the cap to make sure the arrow is pointing towards your right That arrow indicates the water flow direction Screw the bracket to the top of the system cap with the front end facing the same side as the filter label Please use the front holes for the two screw holes on the backside With the appropriate nails or hanger mount the system to the wall Make sure to mount the system close enough to connect to both the cold water valve and connector to the faucet Leave minimum 6 inch of space underneath the filter for filter change Connect one end of the lst water Connect one end of the 2nd water supply line to the side of the cap that supply line to the side of the cap that indicate IN and connect the other indicate OUT and connect the other end of the same water supply line to end ot the same water supply line to the cold water valve the sink taucet cold water input Step 4 System Start Up J Turn on feed water Check ali Turn on the cold water Slowly
10. ty without adequate disintection before or atter system Systems certitied tor cyst reduction may be used on disinfected water that may contain filterable cysts Copyright This manual is copyrighted by APEC Inc Under the copyright laws this manual may not be reproduced in any torm in whole or part without the prior written consent of APEC Inc Manual print ver 1 0 2015 May Components included with the system Make sure you have all these parts before starting installation Filter x 1 Bracket Mounting Screw x 4 gt me KE FN J 3 8 Water S upply Line x 2 INSTALLING THE SYSTEM Space Make sure there is sufficient space under the counter for installation The system is best installed under the kitchen sink But if that is not feasible you can install the system anywhere where there is a cold water supply with suffi cient water pressure Note System is primary used as a POU point of use system It is not recommended to connect it on a location that has multiple outlets Mounting Recommend mounting the system on the wall please leave minimum 6 inch of space underneath the filter to make sure filter cartridge can be taken down easily for filter replacement Step 1 Disconnecting the Existing Cold Water Supply Line Locate the Cold water supply valve under the kitchen sink the round or oblong handle on the right side Turn off the incoming cold water completely by
Download Pdf Manuals
Related Search