KOHLER K-T7751-3-CP Installation Guide
Contents
1. Installation Guide Triton Deck Mount Bath Faucet Trim K T7019 LIN oe 1011303 2 A Thank You For Choosing Kohler Company We appreciate your commitment to Kohler guality Please take a few minutes to review this manual before you start installation If you encounter any installation or performance problems please don t hesitate to contact us Our phone numbers and website are listed on the back cover Thank you again for choosing Kohler Company Before You Begin Turn off the main water supply Observe all local plumbing codes NOTE The valve is sold separately Please refer to the instructions packed with the valve for installation procedures Recommended Tools and Materials FS P C Assorted Tube Cutter Plumbers Screwdrivers Wrench Putty 1011303 2 A 2 Kohler Co For Tile Covered Deck Installation Only Spout Supply Brass k s 3 2cm Heel supply e gt No o Tile 7 H I Finish 0 Rough Deck Finished Deck 2 Rough Deck Install Sleeve Sleeve Screws 1 Install Spout Supply Tube Remove the plaster guard from the spout supply tube Cut the supply tube so 1 1 4 3 2cm remains above the rim finished deck or tile Ensure that all burrs are removed from the spout supply tube to prev2. e escutcheon onto the valve body Install the spline adapter halfway onto the valve stem spline Press the handle loosely onto the spline adapter and check alignment of the handle If alignment is needed remove the handle and reposition the spline adapter on the valve stem spline until proper handle alignment is achieved Secure the handle with the screw and press the plug button in place For vandal resistant installations insert the vandal resistant button and secure with vandal resistant screw Repeat for other handle Kohler Co 5 1011303 2 A 1011303 2 A 6 Kohler Co Kohler Co 7 1011303 2 A USA 1 800 4 KOHLER Mexico 001 877 680 1310 Canada 1 800 964 5590 kohler com THE BOI DIOOK OF KOHLER 2001 Kohler Co 1011303 2 A
3. ent damage to the O ring seal inside the sleeve For tile covered rough deck installation only Slide the brass washer furnished with the spout onto the spout supply tube with the flat side facing forward NOTE The washer is not needed for rim finished deck installations Install Sleeve ZI Loosen the setscrews in the sleeve Use a twisting motion to install the sleeve onto the spout supply line until it contacts the washer Align the sleeve so the setscrews are not facing directly forward or backward Tighten the setscrews Kohler Co 3 1011303 2 A Plumbers Putty Spout Supply 2 Install the Spout N CAUTION Risk of property damage Use care when installing the spout to prevent damage to the O ring on the outside of the sleeve Place a ring of plumbers putty or appropriate sealant around the underside of the spout according to the putty manufacturers instructions Carefully press the spout onto the sleeve until the spout base contacts the deck rim or tile Align the spout and tighten the setscrew Place O ring over plug button Insert plug button over the screw flush with the spout 1011303 2 A 4 Kohler Co Vandal Resistant Screw Plug Button i 7 Vandal Resistant 2 Button Red Blue Screw Handle Assembly Spline Adapter Valve Stem Spline Escutcheon Washer 3 Install Handles Install the washer into the base of the escutcheon and thread th
Download Pdf Manuals
Related Search