The Art of Storage RS2100 Instructions / Assembly
Contents
1. AGRAM Copyright 2008 Phone 1 800 474 66152. TOOLS REQUIRED IMPORTANT ASSEMBLY INSTRUCTIONS IMPORTANT WARNING philips head screwdriver 1 Never exceed maximum total load of 50Ibs 23 Kgs Read all instructions carefully prior to installing and using this Tape Measure 2 Before use thoroughly test the hoist fully weighted with Ceiling Hoist Improper installation can result in personal injury Stud locator for ceilings and the item intended to be stored to ensure the unit has been and or damage to property If in doubt have this item installed by ialis covered withdnywal installed securely and is functioning properly a professional The manufacturers and sellers of this item cannot 3 Do not cut the rope accept responsibility for any injury or damage caused by incorrect installation or improper use 1 Determine the correct distance between the two 2 Locate the ceiling joist Transfer the distance measurement pulley hooks e g handlebars to back of seat on bicycle Step 1 so that the pulley brackets line up the correct distance along the joist It is also possible to mount the pulley bracket first onto a board which can then be securely mounted to joists as illustrated 3 Securely tie a double knot in the end of the cord 4 Using the wood screws provided carefully mount each pulley bracket and feed the cord through the square hole on the end into the ceiling joist at the correct distance so the hooks will line up of the pulley unit that does not have the cord locking as me
3. asured in 1 Important ensure that at least 3 screws are securely mechanism The knotted end will then be between mounted into the joist on each pulley bracket Pre drilling 1 8 pilot the ceiling and pulley bracket Back Pulley holes will make this job easier Knot Non Locking Front Pulley 5 Thread the cord through the pulleys as shown Be sure to carefully 6 Mount the rope cleat at a safe height thread the cord down through both parts of the locking mechanism out of reach of small children and screw directly into a stud using two wood screws supplied USAGE INSTRUCTIONS Raising an item Ensure the hooks are properly located and the cord is not twisted before pulling on the cord The auto locking device will hold the item suspended with each pull Once hoisted to the correct height wrap the excess cord securely around the cleat Do not cut excess cord Lowering an item Pull the cord toward the rear pulley while maintaining tension on the cord This will release the auto locking mechanism so the weight of the item will now cause the item to lower Keeping the tension in this direction slowly let the cord out as the item lowers Once low enough remove it from the hooks and wrap the cord back on the cleat For hoisting some items like Kayaks it may be necessary in addition to use a suitable strap system with the hooks Delta Design Company 125 Washington St Unit 7 EL GRECO RS2100 l Foxborough MA 02035 USA ASSEMBLY DI
Download Pdf Manuals
Related Search