Mendocino 16712 Installation Guide
Contents
1. Home Depot Pergola Assembly Instructions N DESCRIPTION Quantity 6x6 Redwood Timber Post i ee Redwood Timber Header 3 2x6 Redwood Joist 6x6 Redwood Timber Knee Brace List of Tools required 2 People Drill 7 8 x 8 Drill Bit 3 16 x 4 Drill Bit 15 16 Driver or Wrench s 5 16 Driver Nails or Woodscrews Galvanized Hammer Framing Square Bubble Level Measuring Tape Pencil 8 4ft Long Scrap 2x4 for use as temporary bracing MENDOCINO 1 Layout Post Anchors On Level ground mark location of the 4x included post anchors Ensure that diagonal measurements are equal to maintain square dimensions s N f Fa N P sa P NX Pa s ZA Pa S Pi See gt 945 X XK A L i 4 3 A 2 Secure Post Anchors Install Post anchors in marked location Consult Simpson installation instructions for proper procedure MENDOCINO 3 Assemble Posts and Headers Kit will come with either 3x12 or 3x8 Headers depending on model Lay Header 2 out flat on the ground with notched side facing up Lay Posts 1 on header in mounting location Ensure equal 84 spacing between the entire length of the posts and use a framing square and bubble level to maintain square dimensions Mark hole locations on center of posts and drill through posts and header using 7 8 drill bit Soacing between holes must be at least 3 for stability Secure Head2. er onto posts using provided hardware Repeat for opposite side MENDOCINO 4 Hoist Assembled Posts and Headers into Anchors Prepare four scrap 2x4 to temporarily brace the posts after being hoisted into place Hoist one post and header structure upright and place bottom end of posts into anchors Use a level to ensure that posts are plumb and secure into anchors with choice of hardware Consult Simpson installation instructions for proper procedure Brace the posts laterally using 2x4 to keep them from falling over during assembly Secure the 2x4 braces to both the post and the ground N Repeat for opposite side i MENDOCINO 5 Assemble 2x6 Joists Place 2x6 Joists 3 into notches between headers and secure with woodscrews through predrilled holes MENDOCINO 6 Assemble 6x6 Knee Braces Secure 6x6 Knee Braces 4 to Headers and Joists with woodscrews Pre drilling pilot holes is recommended to prevent splitting Knee braces must be installed with at least two 6 screws per side through the Joists and three 8 screws into the Post for stability Pre drill the Knee Braces using a 3 16 diameter drill bit Place holes according to diagram below with at least 3 of screw through the brace to ensure stability MENDOCINO
Download Pdf Manuals
Related Search