Henry 12107 Instructions / Assembly
Contents
1. Barrel Gun Cut spout about 1 2 from top of tube Puncture inner seal Insert cartridge and attach nozzle Use 2 hole nozzle for 2 1 2 wall base 3 hole nozzle for 4 wall base and 5 hole nozzle for 6 wall base Skeleton Gun Cut spout near tip to produce 1 8 bead Puncture inner seal and insert cartridge Use two 1 8 beads for 2 1 2 wall base 3 beads for 4 wall base and 5 beads for 6 wall base Be sure to use enough adhesive Immediately place wall base and roll toward previously installed section using a hand roller Clean Up Remove wet adhesive residue with a clean white cloth dampened with soapy water Use mineral spirits for dried adhesive residue carefully following warnings on the container Warranty 10 Year Limited Warranty For complete warranty details please contact our Customer Service Center 1 800 232 4832 Notes Do not reuse container Dispose of container and adhesive residue in accordance with federal state and local waste disposal regulations Do not flush adhesive down drains KEEP OUT OF REACH OF CHILDREN e Freeze thaw stable to 10 F 12 C Avoid low temperatures or multiple freeze thaw cycles Shelf life is one year if unopened e VOC content 0 g L calculated amp reported SCAQMD 1168 PRECAUTIONS May be mildly irritating to eyes and skin May cause allergic respiratory reaction May cause allergic skin reaction Carefully read and follow all cautions and warnings o2. HENRY 440 Cove Base Adhesive Description HENRY is a high performance wet set adhesive for installing rubber and vinyl cove base Use For Commercial and residential installations of rubber and vinyl cove base Bonds To Structurally sound clean smooth dry wall surfaces Glazed or metal surfaces must be abraded Refer to the cove base manufacturer s specific recommendations for suitable substrates Preparation e Acclimate the installation area adhesive and flooring in an enclosed building at a minimum of 65 F 18 C for at least 48 hours before during and for 48 hours after installation e Substrate must be sound smooth flat clean dry and free of excess moisture and alkali Remove dirt wax grease paints oils sealers curing compounds and all foreign matter that would interfere with proper adhesion Installation Follow the flooring manufacturer s guidelines for layout and design Stir any liquid found on the surface into the adhesive and apply adhesive to the cove base or to the wall using the proper trowel Stay 1 8 away from the top and bottom of the cove base to prevent the adhesive from oozing Place cove base into position Butt the joints neatly Using a hand roller roll toward the previously installed section 11 oz or 30 oz cartridge Directions Packaged in a dual purpose cartridge for your convenience may be applied with standard closed barrel gun or open barrel skeleton gun Closed
3. n label or refer to Material Safety Data Sheet for all warnings and additional product information www wwhenry com Made in USA by The W W Henry Company Aliquippa PA 15001 1 800 232 4832 www wwhenry com HT106 09 11
Download Pdf Manuals
Related Search