No Drilling Required GB32018-SS-NDR Installation Guide
Contents
1. Grab Bar Installation Instructions GB Series VE 1 Adapter Set 2 Adapters 3 2 adhesive tubes 3 Red Keys 6 Stainless screws 6 screw sleeves 1 alcohol cleaning pad 3 Align adapter and pre attach to bar with screws amp sleeves This steps provides for easy alignment and eliminates the need to measure from post to post Be sure to mark walls for desired height prior to pre setting to wall 4 Carefully remove cover ring from each side Foam ring will hold 5 Pierce adhesive tube with red key and then slide tube end into slit in tube adapters in place on wall and provide a border for the adhesive when Insert tube end firmly into center hole in adapter and slowly insert adhesive by inserted Press bar at desired location firmly for 5 seconds Remove bar turning red key Continue until all three vent holes show a white bead as Foam ring will hold adapter in desired position pictured Do not press on adapter after inserting glue 6 Allow adhesive to cure for 24 7 After adhesive has cured for 24 8 Attach bar to adapters using the screws amp sleeves included Make sure hours undisturbed Important not hours remove the three beads of to re attach in same position as originally set to be sure screws align to disturb the adapter after glue from the small vent holes properly Tighten firmly Slide cover ring over base and turn clockwise until inserting glue properly aligned and turn to lock in place Job complete Not inte2. nded for Sheetrock Plaster Wall Paper no drilling required or Painted Surfaces hie wieder
Download Pdf Manuals
Related Search