Van Mark USA1 Instructions / Assembly
Contents
1. ee UniStand ADJUSTABLE 0 Description Qty Required End Assembly Latch Plate C Model No USA1 Patent No 6 854 314 i Refers to the total amount of that part number in each product 24145 Industrial Park Dr Farmington Hills MI 48335 Toll Free No 1 800 Van Mark Toll Free Fax 1 888 Van Mark Phone No 1 248 478 1200 Area Fax No 1 248 478 1226 Web site www van mark com E Mail sales van mark com i 5 3 Products Engineered to Bring Out the Best in Your Work UniStandinst indd 16 md ee 042303 Rev 02 15 11 2002 2011 Van Mark Products Corp F551np Step 1 Remove and lay out contents of box Space the End Assemblies apart and install Cross Members by loosely thread ing T Knobs 1 for each end of cross member through holes and into threaded holes in End Assemblies Once both Cross Members are correctly in place tighten with T Knobs Note Do not over tighten T Knobs as stripping can occur Front Base Rail Edge Here gt Assembly Cross Pi Member SETUP Step 2 Insert Flat Washer 08 onto Axle Bolt 06 and extend through Wheel Thread Flange Nut 09 onto threads do not tighten leave loose allowing Wheel to turn Note Make sure Flange also faces Steel Leg Extend Axle Bolt threads through bottom hole in Leg Support and through top hole in End Assembly Next place Flat Washer 08 over Axle Bolt and tighten against Flange Nut with Nyloc Nut 07 Repeat same steps with opposite Wheel W2. hen properly installed wheels will rotate freely Mounting Surface Latch Plate Retainer Washer Assembly Step 3 Install Leg Support 11 to End Assembly 01 by aligning the center hole of the leg support with the top hole of the End Assembly Insert Hex Screw 10 through holes and tighten with Flange Nut 09 ae Support as shown below in Step 3 Use different combinations of hole align ments to suit your needs The Axle Hub of each Wheel extends out ward toward each Leg Support Properly installed each Wheel will spin freely Mounting Mark amp Il Series Brakes Step 1 Insert 3 8 Washer over threads on T Knobs Extend through slots in Latch Plate and thread into opening in rear of End Assembly leave loose with Latch Plate below mounting surface for now Step 2 Place the lip edge i of the Front Base Rail fully f into the opening in each Retainer as shown Lower Brake fully onto mounting surface Step 3 Extend each Latch Plate up and over the lip edge and firmly tighten each T Knob Brake should now be secured to Stand Check T Knobs often and tighten as needed Mounting Your Trim A Brake II or Trim A Table Insert front lip edge of Tool as described in Step 2 above With Tool centered End Rear View in Stand place Latch Plate in horizontal position and over rear lip edge of Tool Tighten each T Knob firmly
Download Pdf Manuals
Related Search