House of Fara 59008 Installation Guide
Contents
1. How to Install House of Fara Crown Moulding Using Crown Blocks For this project you will need a drill with a 3 32 inch drill bit a hand or power saw measuring tape hammer 2 inch finishing nails pencil and safety glasses Crown blocks are the fastest easiest way to install crown moulding Crown blocks eliminate difficult 45 compound mitre cuts A 1 lt SS i N j lt 3 one s te S N al Va J 1 NS crown blocks A Start at a corner then work around the room installing the crown moulding and blocks as you come to them hole hole B Drill 3 32 holes in crown blocks This will prevent splitting C Position crown blocks 1 and 2 in opposite corners of the room Be sure each crown block is pressed tightly against the ceiling and corner D Nail pre drilled crown blocks in place with 2 finish nails E Measure the distance between the two crown blocks 1 and 2 F Cut crown moulding 3 in FIGURE 1 to fit the distance measured between 1 and 2 using simple straight cuts Note Be sure not to cut the crown moulding too short if the piece is too long it can always be trimmed G Nail the crown moulding in place with 2 finish nails Continue with the same procedure around the room
Download Pdf Manuals
Related Search