The Fix-A-Fence TFAF1 Installation Guide
Contents
1. needed If attaching to a metal pole use the supplied Tek screws drill with 3 8 inch nut driver required You re done Figure1 Figure 2 Figure 3 Figure 4 Figure 5 Channel Brace Pipe Section Le 4 Lifetime guarantee on The Fix A Fence product only Additional Pipe Sections Can be Purchased Separately In colder climates we reccomend belling the bottom of the hole See illustration J2. Always wear proper safety equipment such as gloves and eye protection Supplied Tools Needed The Fix A Fence channel brace Ratchet or drill Wheelbarrow or 5 Gallon bucket The Fix A Fence pipe section 7 16 inch socket wood Level 3 qty 5 16 x 3 inch lag screws 3 8 inch nut driver metal Measuring tape 3 qty 14 x 1 inch Tek screws Post hole digger or shovel 1 Remove blue cap from pipe section Insert pipe section into channel brace coupling and LEGEND rotate clockwise until it stops you should make 3 5 full rotations These are tapered threads and tighten quickly 2 Measure 8 inches out from the bottom edge of the damaged post this marks the center of the hole to be dug 3 Using your mark prepare a hole 18 inches deep and 6 inches in diameter See Figure 1 4 Place the assembled Fix A Fence in the hole keeping the base against the bottom of the post See Figure 2 5 Mix the 60 Ib bag of concrete according to the manufacturers instructions 6 Fill the hole with concrete to the base of the channel brace Maintain the center line of the Fix A Fence and the post See Figure 3 7 Plumb Fix A Fence with a level keeping the base of The Fix A Fence against the bottom of the post See Figure 4 8 Allow concrete to set according to manufacturers instructions 9 Once the concrete has set pull the fence post firmly against The Fix A Fence and install supplied lag screws starting at the top No pre drilling is
Download Pdf Manuals
Related Search