Phillips Manufacturing Company MBAVYL Instructions / Assembly
Contents
1. f HILLIP 9 Installation Recommendations MANUFACTURING CO Engineered to Perform STK gripSTIK Vinyl Max Flex Mini 3 8 Bullnose Archway Installation Recommendations Phillips recommends installation in accordance with applicable ASTM standards and using prevalent industry standards General Installation Guidelines Phillips grip STIK vinyl Max Flex Mini 3 8 Bullnose archway corner beads can be installed using a variety of methods The methods listed below are guidelines Phillips recommends Method 2 as it eases installation on curves and arches Some vinyl products require more detailed installation instructions than are listed here Method 1 Stapling 1 For Mini 3 8 radius Bullnose archway corner beads drywall does not need to be set back Install like regular not bullnose archway corner beads 2 For doors windows or special lengths cut the bead to length and dry fit a Prevent overlap of the mud flanges by snipping back b Dry fit the bead 3 Staple the solid mud flange every 6 10 with 1 2 crown staples Staple each flange segment on the notched mud flange with 1 2 crown staples 4 No primer is needed Finish as usual 5 For cold weather winter applications please refer to the installation recommendations in the Gypsum Association GA 220 06 of 40 F or warmer Method 2 Spray Adhesive gripSTIK Spray Adhesive Recommended _h Follow steps 1 and 2 above 2 Puta coa2. t of spray adhesive on the back of the bead and then on the drywall a Immediately apply bead to drywall and position in place b If the adhesive dries too long it will be hard to reposition c At some point the adhesive will lose tackiness and will not bond If this happens reapply adhesive to both surfaces 3 The rate at which the adhesive dries varies depending on heat and humidity Test in your conditions 4 Use handle of your taping knife or installation tool to apply pressure along both mud flanges Bond strength is greatly enhanced with this crucial step 5 Staple the solid mud flange to assist bonding between bead and wallboard every 6 10 with 1 2 crown staples Staple each flange segment on the notched mud flange with 1 2 crown staples Pressure the mud flanges again see step 4 No primer is needed Finish as usual For cold weather winter applications please refer to the installation recommendations in the Gypsum Association GA 220 06 of 50 F or warmer CO NI With Phillips gripSTIK vinyl beads and trims No mud additives needed No primer needed Made in the U S A Phillips is proud that all our beads trims and accessories are made in the United States of America p Version 1 0 Page 1 of 1 PHILLIPSmrc com 2012 Phillips Manufacturing Company E E
Download Pdf Manuals
Related Search