Zinsser 2810 Use and Care Manual
Contents
1. and slip for easy positioning e Extended open time for trouble free booking and double cutting e Non staining easy clean up e Spreads and flows easily Ideal for pasting machines e Mold amp mildew resistant adhesive PRODUCTS SKU Container Size 02901 1 Gallon 02900 5 Gallon PRODUCT APPLICATION SURFACE PREPARATION Surfaces must be clean dry sound and free of dust grease wax oil old wallcovering adhesive mold and mildew and other residue Inspect the surface for paint bonding loose wallcoverings damaged wallboard or plaster Remove old or loose wallcovering and residual wallcovering adhesive with DIF Wallpaper Stripper Repair unsound surfaces Seal loose paint or damaged drywall and cured skim coats with Gardz High Performance Sealer as needed WALLCOVERING ADHESIVE PRODUCT APPLICATION cont Prime all surfaces including oil based paints oil based primers for painted surfaces and latex or oil based stain kill coatings with an acrylic primer Use ShieldZ Universal ShieldZ Universal Plus or ShieldZ Clear Acrylic Wall Size Mold amp Mildew Eliminate pre existing mold and mildew by washing the affected area with a solution of cup of Clorox bleach to 1 gallon of water Wear protection to prevent skin and eye contact Quickly wash off any solution that comes in contact with your skin Do not add ammonia or other cleaning agents to the bleach solution Rinse surface with clean water A2. installation and hang according to manufacturer s instructions Form GDH 154 Rev 082713 TECHNICAL DATA SUREGRIP 134 CLAY STRIPPABLE WALLCOVERING ADHESIVE PRODUCT APPLICATION cont APPLICATION Use only when temperature is between 50 100 F 10 38 C and the relative humidity is less than 85 Adhesive is ready to use Do not dilute Mix thoroughly before application Apply an even coat using a roller brush or pasting machine to the back of the wallcovering Make sure sufficient adhesive is on edges Avoid contact with the surface of embossed or delicate wallcovering Book and hang wallcovering according to the manufacturer s instructions COVERAGE One gallon of adhesive will hang up 6 double rolls or 310 square feet Spread rate may differ with various backings DRY TIME Drying time will vary depending on the wallcovering types temperature ventilation and humidity of the room CLEAN UP Remove excess adhesive on or around the wallcovering immediately with clean water Additional effort may be required if adhesive is allowed to contact the surface of embossed or textured vinyl Close container tightly after each use TOOL CLEAN UP Clean tools with warm water STORAGE Protect from freezing Always keep the container tightly closed and store in a cool dry place at temperatures between 40 100 F 4 38 C Form GDH 154 Rev 082713 ZINSSER TECHNICAL DATA SUREGRIP 134 CLAY STRIPPA
3. BLE WALLCOVERING ADHESIVE PHYSICAL PROPERTIES SureGrip 134 Clay Strippable Wallcovering Adhesive Resin Type Clay based Wallcovering Adhesive Solvents Water Appearance Light Tan Odor Mild Solids by Weight 44 46 Volatile Organic Compounds lt 10 g l 0 083 Ibs gal Practical Coverage at Recommended DFT assumes 15 material loss 310 sq ft gal Depending on porosity and application method Dry Times at 70 80 F 21 27 C and 50 Relative Humidity Drying time will vary depending on the wallcovering type temperature ventilation and humidity in the room Shelf Life 1 year Flammability Non flammable Flash Point gt 200 F 93 C Safety For additional information see MSDS The technical data and suggestions for use contained herein are correct to the best of our knowledge and offered in good faith The statements of this literature do not constitute of our materials are beyond our control we c will be limited to replacement of defective materials All technical information is subject to change without notice a warranty express or implied as to the performance of these products As conditions and use an guarantee these products only to conform to our standards of quality and our liability if any ge RUST OLEUM BRANDS Rust Oleum Corporation Form GDH 154 11 Hawthorn Parkway Phone 877 385 8155 Rev 082713 Vernon Hills Illinois 60061 www rustole
4. llow surface to dry thoroughly before applying wallcovering Drywall Wipe down with a damp cloth to remove residual joint compound dust prior to priming No primer is required when hanging strippable fabric backed vinyl wallcovering over bare drywall However adhesive must fully cure approximately 4 6 weeks prior to stripping If uncertain priming is always recommended to ensure proper performance Plaster New plaster must age at least 90 days before hanging wallcovering Prime prior to installation Glossy Surfaces Glossy paint paneling metal glass plastic etc should be primed with ShieldZ Universal ShieldZ Universal Plus or ShieldZ Clear Acrylic Wall Size prior to wallcovering installation Metal surfaces should be primed with rust inhibiting Bulls Eye 1 2 3 Primer Existing Vinyl Wallcovering This product is not intended for hanging wallcoverings over existing vinyl wallcoverings without the use of a primer For hanging directly over vinyl without priming use SureGrip 127 Vinyl over Vinyl Wallcovering Adhesive according to label directions For hanging lightweight wallpaper or borders directly over unprimed vinyl use SureGrip Universal Adhesive or SureGrip Border Adhesive for Wallpapered Surfaces Textile and Delicate Wallcoverings Take special care to keep the adhesive off the face of textile or delicate wallcovering Some wallcovering can be stained by water alone Test for stain resistance prior to
5. po TECHNICAL DATA SUG 14 SUREGRIP 134 CLAY STRIPPABLE ZINSSER QUALITY SINCE 1849 DESCRIPTION AND USES SureGrip 134 Clay Strippable Wallcovering Adhesive is a commercial grade ready to use clay based formulated with a high solids low moisture content for installing medium to heavyweight vinyl or non vinyl materials up to 40 oz commercial grade types Il and III and special wallcoverings such as flexible wood fabric backed foil and Mylar SureGrip 134 is a non dilution clay formula designed to flow easily through pasting machines without the need to add water and offers excellent wet tack for easy positioning of heavy materials It is suitable for use with moisture sensitive wallcoverings to prevent bubbling seam curling and edge lifting SureGrip 134 is easy to clean up and will allow fabric backed and other strippable types of wallcoverings applied over primed or bare drywall to strip easily SureGrip 134 is not recommended for hanging lightweight wallpaper or delicate wallcoverings such as silk burlap grass cloth strings or fabric that may stain easily It is not intended for use to hang borders or wallcoverings over existing vinyl wallcovering without the use of a primer See Existing Vinyl Wallcovering under Application in next column for recommendations PERFORMANCE CHARACTERISTICS e For use with all wallcovering types heavy commercial vinyl to delicate materials e Excellent wet tack
6. um com An RPM Company
Download Pdf Manuals
Related Search