Fypon PB5X5A Installation Guide
Contents
1. esive as a filler Then sand the joint and touch up with paint e The best time of year to repair separated joints is during cold temperatures when moulding is fully contracted General Installation Notes Any adhesives sealants fillers or paint used must be compatible with the material that is being installed see manufacturer s recommendations in the Finishing and Adhesives section below Always use corrosion resistant mechanical nails or screws along with manufacturer s recommended adhesive product when installing all Fypon products This combination provides a secure long lasting bond Countersink all fasteners about s and fill with product compatible filler Exterior installations should be finished using a manufacturer s recommended caulk to prevent water infiltration behind siding windows and doors Some exterior installations in particular new construction before siding is applied may require a J channel and or flashing to prevent water infiltration Installers must determine which installation technique is best for the specific situation Finishing and Adhesives Polyurethane PUR Fypon polyurethane products are factory primed Depending on product location always use interior exterior grade PUR compatible adhesives sealants and fillers when installing Fypon products Consult the manufacturer s recommendations for your particular climate and the substrate you are installing to Cellular PVC Depending on product locatio2. n always use interior exterior grade PVC compatible adhesives sealants and fillers when installing Fypon products Consult the manufacturer s recommendations for your particular climate and the substrate you are installing to If painting is desired a 100 acrylic latex paint with a Light Reflectance Value LRV of 55 or higher must be used Applying paint with an LRV of 54 or lower will void the warranty IMPORTANT Please read these installation guidelines thoroughly before beginning installation Please note that these guidelines are provided only to assist with the installation of Fypon moulding and millwork products Modified procedures may be required in order to meet specific situations unique applications and local building codes The manufacturer does not under any circumstances warrant the installation of its products Be sure to wear appropriate protective clothing gloves and safety glasses when working with any tools Installer should check for and relocate all electrical wiring within the proposed installation area as needed be sure to disconnect all electric power before working with any electrical wiring and follow all applicable local electrical codes and safety procedures Fypon Ltd 1750 Indian Wood Circle Maumee Ohio 43537 1 800 446 3040 www fypon com
3. sas i YPON INSTALLATION INSTRUCTIONS i e Page 1 of 1 Fypon products can be cut and trimmed with typical woodworking tools They are installed similar to any premium wood trim with a couple of important rules to keep in mind Materials needed e Safety glasses e Tape measure e Hammer or Pneumatic Nailer e Nail Countersink e Corrosion Resistant Fasteners e Caulk Gun e Polyurethane Compatible Adhesive e Polyurethane Compatible Filler e Sandpaper e Pencil e Latex Paint Job site Fabrication of Stock Size e The urethane foam used in Fypon products will expand during hot temperatures and contract during cold temperatures To minimize the effects of expansion and contraction it is very important to install moulding as tightly as possible We recommend cutting moulding 1 4 longer for each 10 of length to insure a snug fit Also use butt joints on all seams and mitered joints at the corners to insure a tight fit e Itis very important to use adhesive on all joints covering the joint completely and along the back of the moulding will ensure the highest quality installation e Mouldings should be installed on solid backing material Fasten mouldings in place every 16 or less Repair Tip e To repair a butt joint that has separated due to insufficient or no adhesive applied drive wood shims into the joint and below the surface of the millwork This will open up the separation and stabilize it Leaving shims in place fill the gap with adh
Download Pdf Manuals
Related Search