Ideal Pet DDXLW Instructions / Assembly
Contents
1. Use pliers to break off a single level at a time starting at top bottom then sides Start at corner and bend metal inward toward center in 2 intervals Caulking is recommended under ouside frame Place inside frame C with flap into opening from inside of door hold in place insert binder posts D through outside frame then install screws E and tighten until snug Do not over tighten If screw extended past outer edge of post remove screw cut off accordingly then re insert 6 LOCKING YOUR PET DOOR Slide self locking cover F into guide channels located on both sides of pet door opening NOTE UNEVEN SURFACED DOORS If your door has an uneven surface after cutting the rough opening build up the lowest area with wood frame thick enough to make an even door surface If both sides of your door are uneven repeat the process for the other side Installation In Walls And Other Types Of Doors The pet door can be installed in walls steel doors storm doors and Bel Aire doors however additional materials such as wood framing plaster touch up paint longer frame screws and additional tools may be required Walls Once an opening has been made in a wall it will be necessary to build a frame to cover the exposed area between wall surfaces Use wood screws to attach interior and exterior frame to wall surfaces When cutting through walls extreme caution must be used so as not to cut any concealed electrical wires gas lines or wa2. Deluxe Pet Door Installation Instructions TOOLS REQUIRED FOR INSTALLATION Scissors Hammer and Awl or Nail Drill and 3 8 Drill Bit Sabre Saw Phillips Screwdriver Safety Goggles 1 DETERMINE TEMPLATE PLACEMENT Using scissors cut template supplied in box along dotted lines as indicated Center template width in middle of door tape in place Position the top of the template 2 taller than your pet s shoulder Important Under no circumstances should the bottom edge of the rough opening be less than 3 from the bottom edge of the wood door 2 OUTLINE PET DOOR OPENING With template taped in place use a pencil to draw around the inside edge of template onto door Use a nail or awl to mark inside edge corner holes and outer hardware drill holes 3 DRILLING HOLES Drill four 3 8 diameter individual holes the inside edge comer locations will serve as a guide Next Drill the four 3 8 diameter outer door hardware holes 4 Cutting the opening Begin with one of the inside edge corner holes Next Using a sabre saw carefully cut along the pencil line 5 ASSEMBLY amp ADJUSTMENT See Diagram 1 Insert outside frame A no flap into opening from outside Make certain frame is flush with door surface No adjustment is necessary if frame does not extend beyond inside opening If part of the outside frame Diagram 1 extends into inside remove break off levels on outside frame B as required
3. ter pipes Steel Doors To create an opening in a steel door use a jigsaw with a metal cutting blade to cut the opening starting at pre drilled comer holes Storm Doors or Bel Aire Doors 1 2 thickness or less Starting at any pre drilled comer hole cut out rough opening use tin snips for storm doors Break off levels 1 amp 2 B as required See Diagram 1 As with any home improvement project if you do not have the tools or skills to properly install your pet door we suggest using a professional handyman or licensed contractor
Download Pdf Manuals
Related Search