Whynter T-1 User's Manual
Contents
1. and when re inserted the indicator should go green If the WATERTANK indicator stays red or red orange this could mean that the internal water level detector is not operating correctly Remove the Water Tank and check that the black float in the transparent level indicator on the rear right hand side of the tank is free i e that the float is not stuck at the bottom of the detector If the float is stuck gently tap the indicator to free the float Replace the Water Tank For the T 1A model in Direct Water Supply mode users do not need to remove the water tank The unit will automatically draw the water supply into the water tank The unit will stop drawing water once the water tank is filled At this point you may choose to shut off the water mains or leave it on Once the water tank has been filled you will be able to select your ice size and start the ice making cycle If you have chosen to leave the water mains on the unit will start to draw water into the tank again once it is empty A low water level indicator float will be apparent if the water supply has been interrupted Then the machine may also be operated in manual mode The ice cube size S small of the SELECT button should be illuminated red as this is the default setting If it isn t press the S button to illuminate it Press and hold down for two seconds the START button on the Function Display The appliance will start with the water pump cooling fan and compressor starting2. to operate Looking through the right hand side of the window in the cover water will be seen entering the water tray After approximately 12 minutes ice cubes will be deposited in the Ice Cube Drawer and the appliance will beep four times Do not attempt to remove ice T 1 Version 08 05 Appliance Operation Continued cubes until after the four beeps have finished otherwise the appliance will beep continuously and the cubes may be deposited into the Ice Drawer recess rather than the Ice Drawer itself If the appliance does beep continuously ensure the Ice Cube Drawer is fully in its recess The appliance will continue to produce ice cubes at approximately 12 minute intervals Some variation in cube size can be expected however such variation should be minimized once the appliance has stabilized Variables such as water temperature and ambient temperature can affect ice cube size When the Ice Cube Drawer is full the appliance will detect this and beep 10 times The S M and L lights will flash for 5 minutes and if the Ice Cube Drawer is not emptied the appliance will go into sleep mode Emptying the Ice Cube Drawer and replacing it in its recess will re start the ice making process If the Ice Cube Drawer is not emptied the cubes will melt and the water will drain back into the Water Tank When sufficient cubes have melted the ice making process will re start again autom
3. HOME ICE MACHINE USER INSTRUCTION MANUAL MODEL SNO T 1 T 1A D zZ www whynter com Introduction This instruction manual covers the operation of versions of the Whynter SNO Home Ice Machine Model T 1 and T 1A Please read these instructions carefully and retain them for future reference The appliance must be connected to a nominally 110V AC 60Hz earthed electrical supply and be protected with a fuse The Home Ice Machine produces 12 ice cubes every cycle of 12 to 18 minutes approximately depending on which size of cube is selected It is equipped with a clear Function Display panel which includes SELECT buttons for ice cube size selection S small M medium and large START and STOP buttons and a WATERTANK condition monitor which gives a visual warning when the appliance is running low on water The unit has a separate mains electricity ON OFF switch in the lower right hand side panel is recommended that the appliance is operated with small cube size whenever conditions permit The T1 A unit has a dual mode design Standard and Direct Water Supply mode In Direct Water Supply mode the machine can be connected directly to a mains water supply This added function allows the water tank to automatically refill when empty T 1 Version 08 05 Parts Overview T 1 Version 08 05 Referencing images on Page 3 Ice Cube Drawer Water Tank Water Lev
4. The appliance produces between 16 and 20 Kg of ice in a 24 hour period dependant on the water temperature T 1 Version 08 05 ONE YEAR LIMITED WARRANTY This WHYNTER portable ice maker is warranted to the original owner within the 48 continental states for one year from the date of purchase against defects in material and workmanship under normal use and service Should your Whynter ice maker prove defective within one year from the date of purchase return the defective part or the unit freight prepaid within two months of purchase after two months to one year customer will be responsible for freight cost to Whynters service department along with an explanation to Whynter s service department Please ship the Whynter ice maker in its original packaging material to avoid damage in transit Please retain original box and packaging material Under this warranty Whynter will repair or replace any parts found defective This warranty is not transferable After the expiration of the warranty the cost of labor and parts will be the responsibility of the original owner of the unit THIS WARRANTY DOES NOT COVER Acts of God such as fire flood hurricanes earthquakes and tornadoes Damage accidental or other wise to the ice maker while in the possession of a consumer not caused by a defect in material or workmanship Damage caused by consumer misuse tampering or failure to follow the care and special handling provisions in th
5. atically As water is drawn from the Water Tank the level will drop and eventually the WATERTANK indicator on the Function Display will turn from green to red or red orange indicating that the tank requires topping up It is not necessary to top up the tank immediately The ideal time to top up the tank is a couple of minutes after the water has stopped being pumped into the water tray This is because towards the end of the ice cube production cycle the water tray inverts and any unfrozen water in the tray drains back into the Water Tank If the Water Tank is removed for the purposes of topping up during this period then water will be deposited into the base of the appliance and then leak onto the surface on which the appliance is standing Topping up an appliance which has been running for a number of cycles the water level should be approximately 5mm 1 4 inch below the MAX line of the Water Level Indicator This is so that the Water Tank does not overflow after water tray inversion The appliance can be stopped at any time by pressing the STOP button on the Function Display If this is done the red START indicator will flash T 1 Version 08 05 After Use When the appliance is not to be used for some time for example for periods exceeding 48 hours it is recommended that it be disconnected from the electricity supply and any remaining ice cubes and water be removed Excess water in the Ice cube Drawer Water Tank and water tray sh
6. cube size is selected Always try small S ice cube selection as this may give cubes of sufficient size As with all electrical appliances if used outdoors ensure that it is protected from the elements and use an earth leakage contact breaker for safety Do not expose the appliance to rain and do not use it or store it where it could get damp or wet Do not put the appliance near heat sources In case of damage to the appliance or its lead we advise not using the appliance and to return it for authorized repair and parts replacement Using parts not recommended by the manufacturer can be dangerous Only use the appliance for its intended purpose the production of ice cubes The refrigerant gas used in the appliance R134a is chemical waste Disposal of the appliance must be done in a proper environmentally friendly way Inquire about proper disposal with your municipal waste processing department T 1 Version 08 05 Problems and Malfunctions If the indicator light on WATERTANK is illuminated red or red orange the water tank level is low and requires topping up If the and START indicator lights flash and the appliance beep then the Ice Cube Drawer is not positioned properly Remove the drawer and replace it in its recess There are a number of sensors associated with the Ice Cube Drawer and the Water Tank and faulty positioning of these units is the most common cause of malfunction Always ensure that the 6 Cube Drawer an
7. d the Water Tank are correctly positioned in their recesses If the M indicator is illuminated and the appliance beeps or the M indicator is flashing and the appliance is not beeping the ice cube production process is stuck It may be that ice cubes are stuck to the freezer element an ice cube is stuck in the mechanism or the ice cubes have fused into one large block of ice If this happens switch off the appliance unplug it from the mains supply open the cover and leave it open until all ice blockages melt Once everything has melted close the cover plug the appliance in to the supply switch on and press START In the event of any appliance stoppages malfunctions or indicator light sequences not already covered in these instructions switch the appliance off for one minute and then switch it on again This should clear any spurious faults For any faults which cannot be cleared and for further assistance and service the contact information is shown on the last page T 1 Version 08 05 Appliance Technical Data Voltage 110V AC 60Hz Maximum power 200W Water Tank capacity 3 8 liters 0 9 gallon approximately Ice Cube Size S Small Cycle time 12 minutes M Medium Cycle time 15 minutes L Large Cycle time 18 minutes Dimensions 350 x 350 x 422 mm 13 8 x 13 8 x 16 6 Net Weight 18 2 Kg 40 1 Lbs The number of ice cubes produced per cycle is 12 The lce Cube Container holds approximately 60 cubes or 1 kg of ice
8. e instructions Damage to the finish of the housing case or other appearance parts caused by wear 1 Filter 2 Damage caused by repairs or alterations of the unit by anyone other than authorized by the manufacturer 3 Freight and Insurance cost for the warranty service To obtain service or information contact Whynter Innovations Group via Email at service whynter com or call 866 WHYNTER T 1 Version 08 05
9. el Indicator Function Display Cover with Window On Off Switch Mains Water Input Mains Water Control Float Water Level Detector Water Tank Removable Lid Mains Lead Mains Lead Socket Detail of Function Display 6 WATERTANK T 1 Version 08 05 Preparing the Appliance for Use Unpack the appliance and place it on a sturdy level surface It is recommended that the packaging is retained for secure movement transport The appliance operates at its optimum performance in a normal room temperature of 68 F 20 C The refrigerant inside the appliance must have time to settle following transportation and a minimum stabilization period of three hours is recommended prior to switching on the appliance There are two ventilation grilles in the appliance cover one in the lower left hand side and one in the upper rear panel To ensure correct appliance operation these grilles must not be obstructed A gap of at least 10 cm 4 inches must be maintained between the appliance sides rear and top and other appliances or walls Remove the Water Tank the lower of the two removable drawers on the appliance front face and pour fresh drinkable mains tap water into the tank through the larger rectangular hole in the Water Tank lid and fill the tank up to the MAX line of the Water Level Indicator on the front right of the water tank Commercially bottled still drinking water may be used if desired Replace the Water Tank fully home into its reces
10. ould be removed using paper kitchen towels or similar product It is recommended that the appliance is cleaned on a regular basis perhaps once every three months or more frequently in areas where chalky deposits can be a problem Two cleaning solutions may be used One is one part vinegar to 10 parts water the other is 1 part bicarbonate of soda to 5 parts water In both cases the appliance should be allowed to complete one ice making cycle then left to stand for 6 hours before being thoroughly rinsed with fresh water and dried as detailed in the previous paragraph Solvents detergents and abrasives must not be used for cleaning The appliance exterior can be cleaned with a damp cloth and then polished with a soft dry lint free cloth T 1 Version 08 05 Hints and Tips Do not place the appliance on its side or upside down Pay particular attention to this when the appliance is being moved Ventilation grilles must not be obstructed Do not immerse the appliance in water or other liquids The appliance has internal moving parts Do not open the Cover when it is connected to the electricity supply and take particular care to prevent children from getting access to or playing with the appliance The ice making element gets very cold and touching them could result in ice burns Do not use water that is below 8 C 46 F as this may cause the ice cubes to fuse into one large block of ice particularly if medium M or large L ice
11. s Ensure the Ice Cube Drawer is fully home in its recess and the Cover with Window is closed as the freezing element gets very cold during operation For the T 1A please make sure to use a inch fitting for the mains water inlet to the drinkable mains water supply Please ensure that the hose connections are tightly connected to water mains and to the rear of the unit to avoid any leakage Note If a replacement hose is required a food grade hose is recommended T 1 Version 08 05 Appliance Operation Plug the appliance mains electricity lead in to a suitable supply and switch on the ON OFF Switch situated in the lower right hand side panel The ON OFF Switch is illuminated and will light up The appliance should be positioned for easy access to the ON OFF switch and mains plug to facilitate rapid switch off and appliance isolation when required For the T 1A model Direct Water Supply mode Please i connect a hose to the water mains and to the unit ii turn the unit on and iii turn on your water mains The appliance may beep several times whilst the internal components reset themselves If this does happen the beeping should last no longer than 20 seconds If beeping continues for a longer period withdraw both the Water Tank and the Ice Cube Drawer slightly and re insert them ensuring they are fully home within their recesses When the Water Tank is withdrawn the WATERTANK indicator should change from green to red or red orange
Download Pdf Manuals
Related Search