Wayne-Dalton GSM-12 User's Manual
Contents
1. You can reach us Toll Free 1 800 676 7734 for Consumer Assistance 3 or online at www waynedalton com Accessing Battery Protective Cover Compartment To gain access to the Battery LE Compartment simple remove the Protective Cover Stand off the rear of the GSM 12 unit to expose the Battery Compartment Battery Installation To gain access to the Battery slide the cover off the back of the GSM 12 To preserve battery life the 9v Battery 9v Battery of the GSM 12 is shipped with the Battery reversed Flip the Battery 180 from its original package position and re insert Slide the Battery Cover back on and replace the Protective Cover Stand NOTE Insure correct Polarity and when inserting battery AS r 4 1 iP 4 You can reach us Toll Free 1 800 676 7734 for Consumer Assistance or online at www waynedalton com Data Cable Connection Insert the Data Cable into the Communications Port on top of the GSM 12 Place the other end of the Communication Port Data Cable in the Communications Port of the Wayne Dalton remote radio receiver sold separately Protective Cover Stand The protective cover of the GSM 12 has a built in Stand which provides hands fre2. You can reach us Toll Free 1 800 676 7734 for Consumer Assistance 13 or online at www waynedalton com FCC and IC Statement 14 FCC and IC Statement FCC Regulatory Information This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation IC Regulatory Information Operation is subject to the following two conditions 1 this device may not cause interference and 2 this device must accept any interference including interference that may cause undesired operation of the device NOTE This equipment has been tested and found to comply with limits for Low Power Devices pursuant to FCC Rules and Regulations IC Rules and Regulations and CE Directives and Standards These limits are designed to provide reasonable protection against harmful interference This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try and correct the interf
3. a Message 1 will be displayed if this is a new device NEW LEARN ID XXX b Message 2 will be displayed if this device had been previously added DUPLICATE ID XXX 5 If a transmission is not received within 30 seconds the GSM 12 will display a time out message LEARN TIME OUT 6 To cancel the Listen Mode press MENU NO The display will indicate this action LEARN CANCELLED NEW LEARN ID XXX uonelado DUPLICATE ID XXX LEARN TIME OUT LEARN CANCELLED You can reach us Toll Free 1 800 676 7734 for Consumer Assistance 7 or online at www waynedalton com Erasing Individual Devices From The GSM 12 Erasing Individual Devices From The GSM 12 ERASE DEVICE NO YES 1 Press the MENU NO button until the display indicates the Erase Device operation ID XXX YYYYYYY NO ERASE YES ERASE DEVICE NO YES ID XXX ERASE NO UNDO YES a Pressing the ON YES button will display information about an added device ID XXX YYYYYYY NO ERASE YES NOTE X is the memory location of the device NOTE Y is the serial number of the device 3 Use the UP and DOWN buttons to search through the memory to find the device to erase When the device to be erased has been found press the ON YES button A confirmation message will be displayed before permanently erasing the device ID XXX ERASED NO UNDO YES a To permanently erase the device press the MENU NO button b To restore or undo the erase operation
4. ETC OR ATTEMPT TO USE THE PRODUCTS FOR OTHER THAN THE CUSTOMARY USAGE OR FOR THEIR INTENDED PURPOSES THE ABOVE WARRANTY DOES NOT COVER NORMAL WEAR OR ANY DAMAGE BEYOND MANUFACTURER S CONTROL OR REPLACEMENT LABOR CLAIMS FOR DEFECTS IN MATERIAL AND WORKMANSHIP COVERED BY THIS WARRANTY SHALL BE MADE IN WRITING WITHIN THE WARRANTY PERIOD TO THE DEALER FROM WHOM THE PRODUCT WAS PURCHASED MANUFACTURER MAY EITHER SEND A SERVICE REPRESENTATIVE OR HAVE THE PRODUCT RETURNED AT THE MANUFACTURER S OPTION IF JUDGED BY MANUFACTURER TO BE DEFECTIVE IN MATERIAL OR WORKMANSHIP THE PRODUCT WILL BE REPLACED OR REPAIRED AT THE OPTION OF THE MANUFACTURER AT NO CHARGE TRANSPORTATION CHARGES AND FIELD LABOR CHARGES ARE NOT COVERED BY THIS LIMITED WARRANTY THE REMEDIES OF BUYER SET FORTH HEREIN ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER REMEDIES THE LIABILITY OF MANUFACTURER WHETHER IN CONTACT TORT UNDER ANY WARRANTY OR OTHERWISE SHALL NOT EXTEND BEYOND ITS OBLIGATION TO REPAIR OR REPLACE AT ITS OPTION ANY PRODUCT OR PART FOUND BY MANUFACTURER TO BE DEFECTIVE IN MATERIAL OR WORK MANUFACTURER SHALL NOT BE RESPONSIBLE FOR ANY DIRECT INDIRECT SPECIAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY HAVE OTHER RIGHTS WHICH MAY VARY FROM STATE TO STATE HOWEVER SOME STATES DO NOT ALLOW LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS OR THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGE
5. S SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU You can reach us Toll Free 1 800 676 7734 for Consumer Assistance 15 or online at www waynedalton com
6. Wayne Wayne Dalton Corp P O Box 67 Mt Hope OH 44660 www wayne dalton com Gate System Master Controller for use with Wayne Dalton Remote Radio Receivers Models GSM 12 Operating Instructions and Owner s Manual Copyright 2005 Wayne Dalton Corp Part No 323375 New 06 09 05 Table of contents PackagelContent a aa 2 Safety Informations esee eeaeee a E A E e E E E E E a ate 3 esnaera a creer ie eta a oe cee ne en eee anes Sani a Ree ae acon eee ea 4 5 Operations ee e e E Was E ae eee Gea mk Ole a ea dea es 6 12 Mamtenanc e co ccocdc conn Dd OOo OOO ODO OU OO ODDO O DODD DODO ODO NOON OOOO OOO DD ODOODADDODODDDDNODN 13 Service Trouble ShOOUunG ssi 6 6S Sie see seas cene o o 13 RACEN E NEENA E T A e cures gee ties 14 Warranty eee a E e E E E E E O E a E 15 Package Contents a Manual Protective Cover Data Cable 2 You can reach us Toll Free 1 800 676 7734 for Consumer Assistance or online at www waynedalton com Definition of Symbol Warning Safe Operation Precautions WARNING To prevent electrical shock and or fire hazards do not connect the GSM 12 to any device other than a Wayne Dalton remote radio receiver WARNING To reduce the risk of severe or fatal injury 1 READ and follow all instructions 2 Observe all warnings notices and notes in these instructions SAVE THESE INSTRUCTIONS
7. e operation To use the built in stand pull the Stand out from the rear of the GSM 12 You can reach us Toll Free 1 800 676 7734 for Consumer Assistance 5 or online at www waynedalton com UOI EWIOJU Jeaus g uol e19dO Activating the GSM 12 1 Press and release the ON YES button GSM 12 VX XX PRESS MENU a The Display will indicate the Model and Version numbers GSM 12 VX XX PRESS MENU NOTE X is the version number Programing Learning Devices to the GSM 12 LEARN DEVICE 1 Press the MENU NO button until the NO YES display indicates the Learn Device operation WAIT LEARN DEVICE LISTENING NO YES 2 Press the ON YES button If the receiver is initializing the display will indicate a wait message WAIT a When the receiver is ready to receive device signals the display will indicate a ready message You can reach us Toll Free 1 800 676 7734 for Consumer Assistance or online at www waynedalton com Programing Learning Devices to the GSM 12 Continued 3 Press and hold the transmitter button you would like to program learn to the GSM 12 4 Once the GSM 12 has received the transmission two possible messages will be displayed
8. erence by on or more of the following measures reorient or relocate the receiving antenna increase the separation between the equipment and receiver connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experience radio TV technician for help WARNING Changes or modifications to this receiver not expressly approved by Wayne Dalton Corp could void the user s authority to operate this equipment You can reach us Toll Free 1 800 676 7734 for Consumer Assistance or online at www waynedalton com GSM 12 LIMITED WARRANTY THE MANUFACTURER WAYNE DALTON CORP WARRANTS ALL COMPONENTS OF THE GSM 12 FORA PERIOD OF 90 DAYS FROM THE TIME OF INSTALLATION AGAINST DEFECTS IN MATERIALS AND WORKMANSHIP PROVIDED IT IS PROPERLY INSTALLED USED MAINTAINED AND SERVICED UNDER NORMAL USE AND SERVICE THIS LIMITED WARRANTY EXTENDS ONLY TO THE ORIGINAL PURCHASER THIS LIMITED WARRANTY IS NOT TRANSFERABLE NO EMPLOYEE DISTRIBUTOR OR REPRESENTATIVE IS AUTHORIZED TO CHANGE THE FOREGOING WARRANTIES IN ANY WAY OR GRANT ANY OTHER WARRANTY ON BEHALF OF MANUFACTURER THE MANUFACTURER SHALL NOT BE RESPONSIBLE FOR ANY DAMAGE RESULTING TO OR CAUSED BY ITS PRODUCTS BY REASON OF INSTALLATION IMPROPER STORAGE UNAUTHORIZED SERVICE ALTERATION OF PRODUCTS NEGLECT OR ABUSE ANY ACTS OF NATURE BEYOND MANUFACTURER S CONTROL SUCH AS BUT NOT LIMITED TO LIGHTNING POWER SURGES WATER DAMAGE
9. nce or online at www waynedalton com 11 uonelado Turning Off GSM 12 1 Press the MENU NO button until the TURN UNIT OFF display indicates the Turn Off operation TURN UNIT OFF NO YES a Pressing the ON YES button will turn off the GSM 12 b The controller is equipped with an auto shut off mechanism After 5 minutes of inactivity the GSM 12 will automatically turn off 12 You can reach us Toll Free 1 800 676 7734 for Consumer Assistance or online at www waynedalton com Maintenance While the GSM 12 is maintenance free periodic cleaning of the receiver case is suggested To clean the GSM 12 use a soft cloth to remove any dirt and dust Service Unit contains no user serviceable parts Contact your dealer or Wayne Dalton customer support for additional information Service Trouble Shooting Battery Replacement Slide off battery cover Replace battery being careful to match positive symbols on Circuit Boards with battery Slide battery cover back into place NOTE Dispose of dead battery properly Trouble Shooting Symptom Possible Solution Displays appears DIM Check Battery Difficulty in programing learning Insure controller is not near any devices metal Possible near by radio interference Can not transfer device Make sure cable is correct and information between controller and connected securely Possible gate receiver near by radio interference can cause slower transfer
10. ommunication cable from the GSM 12 to the Remote Radio Receiver SENDING 2 Press the MENU NO button until the SENDING DONE display indicates the Send To Receiver CHECKING COMM operation SEND TO RECEIVER COMM ERROR NO YES 3 Pressing the ON YES button will display transfer operation activity SENDING a When transfer operation is complete the GSM 12 will display SENDING DONE b If the communication cable is not connected or the connection is not correct the GSM 12 will display CHECKING COMM c Then after two seconds the GSM 12 will display COMM ERROR 10 You can reach us Toll Free 1 800 676 7734 for Consumer Assistance or online at www waynedalton com Transfering Radio Remote Receiver Devices to GET FRM RECEIVER Controller NO 1 Connect the Data Cable from the GSM 12 RECEIVING to the Remote Radio Receiver RECEIVING DONE 2 Press the MENU NO button until the display indicates the Get From Receiver CHECKING COMM operation COMM ERROR GET FRM RECEIVER NO YES 3 Pressing the ON YES button will display transfer operation activity RECEIVING a When transfer operation is complete the GSM 12 will display RECEIVING DONE b If the communication cable is not connected or the connection is not correct the GSM 12 will display CHECKING COMM c Then after two seconds the GSM 12 will display COMM ERROR You can reach us Toll Free 1 800 676 7734 for Consumer Assista
11. press the ON YES button c An UP arrow in the top left display indicates more devices to view d A DOWN arrow in the top left display indicates there is a previous device to view 8 You can reach us Toll Free 1 800 676 7734 for Consumer Assistance or online at www waynedalton com Erasing All Devices From The GSM 12 1 Press the MENU NO button until the ERASE ALL display indicates the Erase All operation NO YES ERASE ALL ERASE ALL NO YES uoljesadoO 2 Pressing the ON YES button will display confirmation message before erasing all devices ERASE ALL NO SURE YES a To permanently erase all devices press the ON YES button b To cancel the erase all operation press the MENU NO button Retrieving Free Storage GET FREE MEMORY 1 Press the MENU NO button until the NO YES display indicates the Get Free Memory operation XXX RECORDS FREE GET FREE MEMORY NO YES a Pressing the ON YES button will display how many devices can be added to the GSM 12 XXX RECORDS FREE You can reach us Toll Free 1 800 676 7734 for Consumer Assistance 9 or online at www waynedalton com Transfering Controller Devices to Radio Remote H SEND TO RECEIVER Receiver ae 1 Connect the c
Download Pdf Manuals
Related Search