Waring WPM25 User's Manual
Contents
1. WARING PRO PROFESSIONAL POPCORN MAKER 5 comm Waring Ori mege p P jakar ees 5 WPM25 For your safety and continued enjoyment of this product always read the instruction book carefully before using IMPORTANT SAFEGUARDS When using any electrical appliance basic safety precau tions should always be followed including the following 1 READ ALL INSTRUCTIONS BEFORE USING YOUR POPCORN MACHINE 2 Do not touch hot surfaces Always use handles or knobs to operate 3 To avoid any risk of electrical shock do not immerse cord or plug into water or other liquid 4 This appliance should not be used by or near children or individuals with certain disabilities 5 UNPLUG MAIN POWER CORD FROM OUTLET WHILE NOT IN USE AND BEFORE CLEANING 6 Allow HOT parts to cool down before maneuvering and cleaning 7 Do not operate the appliance with damaged cord or plug or after the appliance malfunctions or has been damaged in any matter Send the unit to the nearest authorized service center for examination repair or adjustment ONLY technicians should open up the unit 8 The use of any accessories or attachments not recommended by the manufacturer may cause injury 9 Do not pop the kernels with a dry kettle without oil 10 Do not immerse popping kettle into water 11 Kettle surface is2. Before using the unit please check carefully to be sure voltage 120V 60 Hz is suitable to your home Clean the internal surface of the kettle with warm sudsy water rinse well and dry with a clean cloth Wipe down inner and outer housing with damp cloth Main unit has a 2 function switch as follows POP to turn heater stirrer and light on OFF to turn power off Insert the internal plug into the socket see figure 4 previous page Plug the power cord into an electric outlet Before pouring oil or popcorn lift lid up using the lid tab Turn the switch to the POP position The stirrer will begin to rotate in the kettle Let the stainless steel kettle preheat about 2 to 3 minutes Add oil 1 tablespoon of vegetable corn peanut or safflower oil Immediately add 3 cup of corn kernels Note 1 3 measuring cup included and close lid to the kettle Caution Lid might be hot it is recommended to use an oven mitt Popcorn starts popping out through the lid after about 2 minutes Yields up to 8 cups per batch in less than 3 minutes When unit is finished popping you will no longer hear the corn popping immediately turn switch to the Off position and rotate the knob of the kettle down to release any remaining popcorn in the popper This will also stop the remaining popcorn from cooking any further and avoid possible burning Keep POP switch off if the unit is not continuously in use 12 Remove plug f
3. HOT and should NOT be touched during popping or just after use 12 Unplug allow to cool clean and cover the unit and store in a dry and safe place if not being used for a long time 13 Do not let power cord hang over edge of table or counter or touch any hot surfaces 14 Do not place the unit on or near a hot gas or electric burner or in a heated oven 15 Extreme caution must be paid when moving the appliance containing hot oil or other hot liquids 1 21 22 23 24 25 26 Turn ALL switches to OFF position before disconnecting power plug from the wall supply outlet Not recommended for outdoor use Do not use appliance for other than intended use To avoid overheating always add oil and then kernels before operating Extreme caution must be used when unloading popcorn Always place the unit over a countertop so that residual hot oil or water running out will not cause burns KEEP OUT OF REACH OF CHILDREN DO NOT CLEAN USING ANY ABRASIVE MATERIAL NEVER FORCE ANY PARTS OR BRACKETS INTO POSITION CAUTION A burn can result from misuse of this product Read popping instructions for proper operating procedure No parts are intended for dishwasher A popper that is plugged into an outlet should not be left unattended SAVE THESE INSTRUCTIONS FOR HOUSEHOLD USE ONLY POWER CORD INSTRUCTION A short power supply cord is provided to reduce the risk resulting from becoming intangled in or trippin
4. g over a longer cord Longer detachable power supply cords or extension cords are available and may be used if care is exer cised in their use If along detachable power supply cord or extension cord is used a The marked electrical rating of the extension cord should be at least as great as the electrical rating of the appliance b If the appliance is of the grounded type the extension cord should be a grounding 3 wire cord c The longer cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over unintentionally GL JEE E3 cd cD PARTS 3 a Se 000 Housing Kettle Lid and Stirrer Door removable Tray removable Light not shown oar WN Measuring Spoon and Cup 3 ASSEMBLING PROCEDURE FIGURE 1 FIGURE 2 Place door on hinges Hook the kettle onto the hanger of the main unit FIGURE 4 FIGURE 3 Finally insert the internal kettle plug into the socket hserktay on the inner top of the popcorn housing POPPING INSTRUCTIONS 1 2 10 Follow assembly procedure Make sure the popcorn maker is unplugged before you do any of the following
5. rom power supply if the unit is not being used 13 Repeat steps 8 to 10 for continuous popping CLEANING AND MAINTENANCE It is strongly recommended to clean the kettle frequently to avoid burning excess oil onto the bottom of the inner pot After using the popcorn machine let it cool and use a wet cloth to clean the main unit main body and door It is strongly recommended to wash and dry the tray after each use to avoid any bacteria buildup The light bulb is replaceable with a 120 volt 10 watt bulb QUICK CLEANING PROCEDURE Turn the POP control to Off Pour 4 to 6 ounces of water NO detergent is necessary into inner pot Switch to POP to boil the water and let the stirrer turn in order to remove excess oil stuck on the surface After cooling pour out the water into a deep bowl and discard after about 1 to 2 minutes of boiling CAUTION THE KETTLE IS HOT Or remove the kettle and clean it with a Scotch Brite scouring pad Do not immerse kettle or electrical plug in water Any other trademarks or service marks of third parties herein are the trademarks or service marks of their respective owners 2008 Waring Products Division of Conair Corporation 150 Milford Road East Windsor NJ 08520 www waringproducts com Printed in China WPM25 IB 08WR170
Download Pdf Manuals
Related Search