Home
        VIZIO VS-03R User's Manual
         Contents
1.        ATTY Y  aa Salle    amma  5       REPLACE  LID       Remote Control Battery      The remote control on the handle is powered by 2 AAA batteries  To change the batteries   remove battery cover  pull out old batteries  fig 17  and replace with new ones  Replace  battery cover     Looking After Your Vax    IMPORTANT  The Vax VS OSR is a very powerful vacuum cleaner  It will collect an extraordinary  amount of dust and dirt  especially during the first few applications of use  which will quickly  fill a paper dust bag or block the pores of a cloth dust bag  Excessive dust and dirt will also  contaminate the motor protection and air outlet filters    Any of these conditions usually result in a noticeable drop off in suction  or a possible motor  shut down due to thermostat activation    On such occasions  it will be necessary to replace the paper dust bag or wash and thoroughly dry  a cloth dust bag before reusing  and renew all filters to regain peak suction and performance        Your appliance is equipped with a dust bag  If you notice that the vacuum cleaner seems to be  less efficient than usual  check the dust indicator by selecting the maximum power and lifting  the cleaner tool off the floor  If the indicator turns red  change the bag     To change the dustbag    Turn off the appliance and unplug it  Lift up the catch to gain access to the dustbag compartment  and raise the cover  fig 13   Pull the handle up to remove the bag holder  fig  13a   The bag can  then be 
2. MODIFIED APRIL 2006 P N 73410    VAXCARE    Please register your warranty  Send in your completed Warranty Card     If you require any further assistance or advice about any  VAX please call VAXCARE on    1 300 36 4040  Australia   cost of a local call   and0800 800 900 nz    VAX Appliances  Australia  Pty Ltd    A C N  009099736    296 Victoria Road Malaga Western Australia 6090   EMAIL  vaxcare vax com au  WEBSITE  www vax com au       D AUST   amp  NZ BRANCHES    NSW ACT   Unit 2  239 Beaconsfield St   Milperra  NSW 2214  Telephone   02  9792 8900  Facsimile   02  9792 8911    VICTORIA TASMANIA  Unit 3  46 Burgess Road   Bayswater North  VIC 3153  Telephone   03  9761 7160  Facsimile   03  9761 7175    SOUTH AUSTRALIA   NORTHERN TERRITORY  Unit 3  75 77 Grange Road   Welland  SA 5007  Telephone   08  8340 2222  Facsimile   08  8346 7933       QUEENSLAND  186 Kerry Road   Archerfield  QLD 4108  Telephone   07  3216 7350  Facsimile   07  3216 7375    WESTERN AUSTRALIA  296 Victoria Road   Malaga  WA 6090  Telephone   08  9247 8100  Facsimile   08  9247 8192    VAX APPLIANCES  NEW ZEALAND   27 Clemow Drive   Mt Wellington  Auckland  Telephone   09  5736220  Facsimile   09  5736224  Email  vaxnz vax co nz       Vaxcare   AUST  1300 36 4040  NZ  0800 800 900    Vax       Wwww vax com au    Vax    2000 WATT    VS 03R      Please read carefully before using your VS O03R   Always fully extend mains cable before use        Operating Instructions    Congratulations on the purchase o
3. amage caused by incorrect use  of the cleaner    7  Never put the hose or nozzle near your  eyes or ears     10     11   12     Never operate your VAX with wet hands  or feet    Never leave the appliance running  unattended    This appliance is not intended for use  by young or infirm persons unless they  have been adequately supervised by a  responsible person to ensure that they  can use the appliance safely    Young children should be supervised  to ensure that they do not play with the  appliance    Never use your VAX without a dust bag   Never alter the specification or modify  your VAX in any way     To Change the Filters       Motor Protection Filter   Fig 15 The filter is located in the dust bag compartment and protects the motor from dust  To  reach this filter  lift up the grill which secures it and replace it with a new one   We recommend changing the filter after 5 bag changes or when it appears soiled     Attention  Do not use the vacuum cleaner without the motor protection filter     Air outlet filters    Fig 16 To remove the filters first remove the filter cover  Remove both filter cartridges   On each individual cartridge remove holding bracket  Replace used filter medium with  new   the gauze side first  Reassemble and replace filter cover     We recommend replacing the air outlet filters after one month   s use  Thereafter   replace every 4 6 months  after 5 bag changes  when appearance is soiled or if a loss  of suction is experienced  whichever is sooner  
4. f your  VAX VS O8R cylinder cleaner  To get the best  performance from this product please read  and retain these instructions     Check whether the voltage indicted on the  rating plate is the same as the voltage of  your local mains  This product is intended for  home use only     When using electrical appliances  in order to  reduce the risk of fire  electric shock  and or  injury to persons  basic safety precautions  should be followed  These include     1  This vacuum cleaner is not intended for  cleaning wet or damp flooring  Water  entering the motor unit can cause  permanent damage putting the cleaner  out of operation  This is not covered by  the warranty    2  To avoid damage to the dust bag or the  cleaner mechanics  never use your VAX  to remove sharp articles such as broken  glass or hot  volatile or explosive articles  such as ash  burning cigarette butts   etc    3  Incase the cleaner is used to remove very  fine particles such as fine sand  cement  or other like substances  the pores of the  dust bag can become clogged  In that  case  replace the dust bag and the filters  even if the dust bag is only partly filled   4  If your VAX fails to operate  never attempt  to repair it yourself as repairs carried out  by an unauthorised or inexperienced  person may cause injury to you or  damage to your VAX    5  Have your VAX serviced by an authorised  VAX Service Agent using only genuine  VAX replacement parts    6  The manufacturer shall not be held liable  for any d
5. m cleaner  Slide the hook  attached to the large cleaning tool into the slot on the rear of the appliance  When  you have finished vacuuming  press pedal to stop the appliance then unplug it at  the mains  Press the pedal to automatically rewind the cord  See note fig 6     Fig 11  amp 12 You can move or store your appliance in a vertical position by sliding the hook on  extension tube into the clip on the underside of the appliance    This practical system allows you to carry the vacuum cleaner around in one hand  and provides minimum storage space        
6. ools brush should be raised   Press the rocker switch to lift the brush up     ON OFF  IAX       Getting started    Fully extend the mains cable but not beyond the yellow marker and plug it into a  standard domestic outlet    Fig 5 Press the foot pedal to start the vacuum cleaner  To stop it press the pedal again    Fig 6 Press the foot pedal to recoil the power lead  NOTE  Guide power cord with one hand   Rewind 1 1    metres of cord at a time  This will prevent the cord from whipping  which could cause damage or injury    Fig 7 The hose grip has buttons for control of suction power              remote control  Omin  Oauto  Omax                                     Fig 8 Vacuum power can be adjusted electronically by pressing one of the buttons on the  handle  fig  7     Auto   for normal vacuuming of carpets and hardfloors    Min   for curtains   soft furnishings    Max   for very dirty carpets or carpet with high pile     Using the accessories    Fig 9 Open the accessory storage compartment  fig  9a   These accessories can be fitted  directly to the tubes or onto the end of the flexible hose handle  The small cleaning tool  is used for upholstered furniture  The crevice nozzle is ideal for cleaning awkward places  such as behind radiators  skirting boards and hard to reach areas  The brush attachment  is designed for dusting        Fig 10 If you wish to pause briefly during vacuuming i e  to move a piece of furniture or  a rug  use the special parking position on your vacuu
7. t or Vax direct  Phone  Vaxcare or visit  www vax com au    VAXCARE Service  amp  Help  AUSTRALIA 1300 36 4040  NEW ZEALAND 0800 800 900    Any queries or concerns about using the  Vax  call VAXCARE    Please make a note of the serial number  and model number of the appliance before  calling     Aust only  Mon Fri  10 00am to 6 00pm  EST   Calls are charged at the local rate    An answerphone is available out of these  hours        There are over 300 approved Vax Service  Agents in Australia and New Zealand  For  the nearest Service Agent  please refer to  your Vax warranty or call VAXCARE or visit  WWW Vax cOom au       Technical Specification    Voltage  220 240V 50Hz   Wattage  2000W   Capacity  3 5 litres   Filters  Motor protection filter  Air outlet filter   Cord length  5 metres   Weight  10kg   Part No  73000    Subject to technical change without notice     How to Use Your Vax VS 03R       Assembling the Appliance    Fig 1 The telescopic extension tubes can be lengthened by pressing the button  amp  sliding the  inner tube to required length    Fig 2 To attach the flexible hose to the vacuum cleaner  push the connecting end of the flexible  hose into the attachment point on the vacuum cleaner           Adjusting the cleaning tool for carpets  amp  hard floors          Fig 3 Hard floor position  tiles  parquet floors  etc     The cleaning tools brush must be in the  lower position  Press on the rocker switch to lower it    Fig 4 Carpet or rug position   The cleaning t
8. unclipped and disposed of hygienically  fig 14   Do not forget to regularly change the  dust bag and filter  The efficiency of your cleaner and the life of the motor depends on it     Dustbag Indicator    When the indicator light comes on or when the suction power reduces substantially  this  indicates that you should change empty the dust bag     Attention  If after inserting a new dust bag  the indicator light stays on  this could be  for several reasons        Suction passages may be blocked   check flexible hose and extension tubes  suction  inlet  floor brushes and nozzles for obstruction     Check motor protection filter     Check to see if air outlet filter is dirty  Check carefully which of these causes is making the light go on and correct it so that the  vacuum cleaner can work normally     Do not work the vacuum cleaner with this indicator light on  as this could cause  irreparable damage to the motor     Motor Thermostat    IMPORTANT  The motor is equipped with a  thermal cut out  If for any reason  the vacuum  cleaner should over heat  the thermostat will  automatically turn the unit off  Should this  occur  unplug the vacuum cleaner from the  electrical outlet and turn the unit off  Remove  the dirt container and empty  Clean the filters   Allow the cleaner to cool for approximately  one  1  hour  To re start  plug into an electrical  outlet and switch back on     Replacement Bags  amp  Filters    Replacement bags and filters are available  from your Vax stockis
    
Download Pdf Manuals
 
 
    
Related Search
    
Related Contents
Untitled  No-breaks  Agenda - Tunivisions  Informe de actividades 2013  AGC-400-5  MV2 Series MV2 Series    Copyright © All rights reserved. 
   Failed to retrieve file