Viking EXTENSA 366D User's Manual
Contents
1. Viking Memory INSTALLATION GUIDE ACER Extensa 365 Series Model 367T 367D 366D LNC VIKING COMPONENTS SPEED POWER PERFORMANCE The Acer Extensa 365 Series Model 367T 367D 366D comes stan dard with 32MB 16MB soldered 16MB module of memory It can be expanded to a maximum of 80MB by installing the following Viking Components memory options into its one available expansion slot Viking P N AC80420 RAC80420 Manual No 1005246 Release 07 98 Rev A Description 16MB SDRAM Memory Module 32MB SDRAM Memory Module AC80421 RAC80421 64MB SDRAM Memory Module AC80422 RAC80422 Requires the removal of the standard memory module iat om E Ht iat A Caution Electro Static Discharge ESD can damage electronic components Before touching the memory module ensure that you are discharged of static elec tricity by touching a grounded metal object INSTALLATION INSTRUCTIONS 1 Turn the computer off and disconnect the AC power supply and any other cables from the unit Note If the unit appears to be powered down ensure that it is not in Suspend mode Holding Screws 2 Turn the computer upside down Remove the battery from the system If you are not familiar with this procedure please refer to your computer s Owner s Manual 3 Facing the front of the computer locate the memory expansion cover on the right side of the bottom panel Also locate the three holding scre2. m on The computer will automatically reconfigure itself to recognize the additional memory The new memory can be verified during the POST routine at start up and at the SETUP utility The installation is now complete Copyright 1998 Viking Components Inc
3. ws on the left side of this cover Remove only these three screws with a small Phillips head screwdriver Then remove the cover by lifting it up Memory Expansion Slots Standard Memory Module 4 Locate the single memory expansion slot in the open compartment Also locate the off center key on the slot There will be a standard memory module occupying the expansion slot Off Center Key Memory Expansion Slot 5 In order to upgrade your system past 32MB of memory its standard memory module will need to be removed To remove a memory module locate the retaining clips on both sides of the memory module Gently pull both clips away from the module and then lift the module out of its expansion slot Retaining Clip 6 To install a memory module insert the module into an expansion slot at an angle and then push it down until it clicks into place To be certain that the module is installed correctly ensure that the off center notch on the module is aligned with the off center key of the expansion slot The module can only be installed one way due to the position of the notch Off Center Key 7 Replace the memory expansion cover back to its original position and be sure to secure its three holding screws 8 Insert the battery back into its compartment and turn the system right side up 9 Replace the AC power supply and any other cables you may have dis connected 10 Open the display screen and turn the syste
Download Pdf Manuals
Related Search