Traulsen TD048HT User's Manual
Contents
1. Plug the Seafood Display Cabinet into properly sized outlet within 5 minutes 115V 20 amps Unlock the doors by sliding the Transport Latch to the right see fig 2 or O lt ce LL oY LL LU or REFRIGERATOR Daily Start Up Note Follow End of Day Cleaning Procedure Prior To First Use NOTE Do not load product above Load Limit Guides as indicated on the display area sides and dividers WARNING Pushing against the canopy or frame may result in damage fig 2 3 TRAULSEN TDO48HT amp TDO78HT TRAINING GUIDE Basic Operation Normal Operation Defrost Displayed product temps should remain safely cold for up to 8 hours Product stored in the cabinet base should remain safely cold as long as power is supplied to the cabinet No slacking or freezing should take place under normal circumstances Some products may exhibit drying after several hours and require wrapping to prevent Make use of product from the display area first Replace using product from the refrigerated base Be sure to rotate product and practice First In First Out Replace product in the refrigerated base using freshly loaded pans e Defrost WILL occur automatically every 3 hours e Food remaining in the display cabinet WILL remain safe during defrost e Defrost cycle in progress is indicated on the control by dEF e Time of defrost can be adjusted using the Defrost Lockout feature Please ref2. air flow over product Relocate cabinet to avoid source of air Door s open Close door s Coil iced up due to a excessive run time b excessive ambient temp and or humidity potential refrigeration issue Call for service only after discounting reasons A and G PROBLEM Cloudy Display Canopy a Upon start up condensation will often occur on the inside of the canopy Allow condensation to dissipate during pull down b Canopy cleaned with ammonia containing cleaner Replace canopy PROBLEM Water observed on floor a Drain valve not closed or not closed completely Close drain valve completely PROBLEM Seafood Display Cabinet difficult to move a One or more casters in locked position Unlock all casters before moving PROBLEM Excessive noise e Fan blade s not properly lubricated Clean and lubricate fan blade post s TR35922 rev 3 11 4401 Blue Mound Road Fort Worth TX 76106 800 825 8220 www traulsen com TRUSTED 2010 Traulsen All rights reserved
3. TRAULSEN SEAFOOD DISPLAY CABINETS Models TD048HT amp TD078HT m r TRUSTED 1 TRAULSEN TDO48HT amp TDO78HT TRAINING GUIDE Table of Contents Page IVAN OR PARIS ES Ense ee een 1 BE LS S e E E bat 2 Basic COD Cl WON aab rare nee rare 3 ERE OL DIY ee ae EE a ee 4 5 Routine Maintenance ccccccscccseeseeeceeeceesecseesueesueeseeesees 6 TTOUDIESNOOINIG meer nee nee 7 Rear Locking Bar Product Pan Fan Blade Front Locking Bar Air Air Baffle Product Divider Deflector Assembly TFT ee Plug Seafood Display Cabinet into properly sized outlet 115V 20 amps NOTE Allow display area and base temps indicated by r and c respectively on the control display see fig 1 to reach 38 F before loading Use of ice is optional If ice is to be used load to a depth of no more than 2 NOTE In lieu of ice parchment or some other foodsafe paper is suggested to line the display area pans Load product into refrigerated base first using clean 18 x 26 sheet pans NOTE Parchment or some other foodsafe paper is suggested to line the sheet pans Load display area with already cold or frozen product Use the plastic dividers supplied to seperate different products Lock the doors by sliding the Transport Latch to the left see fig 2 Remove from power and immediately move the Seafood Display Cabinet to the area where it will be used for the day
4. acket and up and away from the cabinet see fig 2 NOTE On 78 units the two canopy sections are connected by a plastic H Channel 4 Lift out canopy side pieces 5 Wash all canopy parts in hot soapy water WARNING Use of ammonia or ammonia containing cleaners such as windex will blur and or craze the plexiglass canopy 6 Allow to air dry and wipe away any water spots using a clean dry cloth fig 2 7 Reassemble by reversing steps 1 thru 4 Cleaning the Condenser required approx EVE 90 days Cleaning the condenser is critical to insuring proper performance and long compressor life 1 Disconnect power supply 2 Open the compressor access door 3 Vacuum or brush coil fins clear of any dust or debris present 4 Close the compressor access door 5 Restore power 7 TRAULSEN TDO48HT amp TDO78HT TRAINING GUIDE Troubleshooting PROBLEM Product temperature too warm a b Product placed in cabinet too warm Replace with properly cold product Cabinet not plugged in or plugged into incorrectly sized outlet Plug unit into properly sized outlet Product loaded above load limit guides Load product properly Too much water allowed to accummulate below display area Drain display area well e Fan s not properly lubricated Clean and lubricate fan blade post s h Air movement from other source ceiling register door draught fan etc blowing into display area disrupting cold
5. er to your owner s manual for instructions High Water Indicator when using ice Ice is expected to slowly melt Under typical conditions the Seafood Display cabinet will not require draining during use In the event water resulting from melting ice exceeds holding capacity approx 5 gal a float device will raise a red draining required indicator see fig 1 Drain cabinet as outlined in steps 1 thru 4 on Disassembly required after each use Remove product from display area first Remove sheet pans from refrigerated base Disconnect cabinet from power supply oe ys Position cabinet over a floor drain or have a large bucket handy On Remove product dividers see fig 1 6 Lift out product pans by grasping them by their front handle allowing any ice to slide into the display area see fig 2 Set aside 7 Remove rear locking bar by lifting it up and out from one side see fig 3 Set aside 8 Lift front of air baffle assembly s to close hinge and remove from one side see fig 4 Set aside 9 Remove front locking bar air deflector assembly by lifting it up and out from one side see fig 5 10 Remove fan blade s see fig 6 Set aside 11 Place all metal parts in the sink for sanitizing Follow procedure on page 5 for care of fan blade s End of Day TRAULSEN TDO48HT amp TDO78HT TRAINING GUIDE End of Day continued ll Cleaning the Cabinet required a
6. fter each use aa Ge 1 Open the compressor access door 2 Locate drain hose over a floor drain or large bucket see fig 1 3 Open drain valve by turning clockwise 4 Spray out the display well and sanitize thoroughly Allow all water to run out the drain 4 Close the drain valve by turning counter clockwise Close the compressor access door 5 Wipe out the refrigerated area behind the doors using a non abrasive non clorinated stainless steel safe cleanser Leave the door s open until next USE WARNING Spraying water inside the refrigerated area behind the doors may cause equipment damage and or injury lil Cleaning the Fan Blade s required after each use ms ai 1 Throughly clean fan post using alcohol or mineral spirits and a clean lint free cloth 2 Clean the bearing inside of the fan blade assembly using a cotton swap moistened with alcohol or mineral spirits see fig 1 3 Place a few drops of the lubricant supplied by Traulsen into the fan blade assembly rear 4 Replace the fan blade assembly on the post fig 2 IV Completion 1 Reassemble cabinet by reversing steps 1 thru 9 on page 4 NOTE Leave door s open until next use and power is restored Routine Maintenance Care of the Display Canopy required as needed 1 Disconnect power supply 2 Remove the screws securing canopy brackets see fig 1 3 Lift curved canopy section s towards front out of mounting bar br
Download Pdf Manuals
Related Search