TIC WRS010 User's Manual
Contents
1. and remove the battery container Insert 6x AA batteries Switch on using the rocker switch and again note the Green operating LED light The unit should now be prepared to operate on batteries only Note At the base of the wireless rock speakers is a Red LED light Should the units receive power fluctuations or the batteries lose charge this red LED light should flash in warning of insufficient power to the units You may also experience a lessening in range and performance Note Batteries leak power and lose their charge Avoid leaving the batteries installed when using mains power or during periods of inactivity WRSO010 Remote Control l 1 Once the Transmitter and rock speakers are set up and ready for operation please study your WRS010 system Remote Control pad 2 On the back of the unit please slide off down the battery compartment cover plate Insert 1x MN21 23 or 1x 23A battery Replace the battery cover 3 Press the ON OFF button on the remote if powered you may hear a pop noise from the speakers notifying you they are receiving The Red LED light will flash on whenever you operate a remote control button 4 Ensure your transmitter and speakers are operational with the transmitter receiving an Audio Source Signal Press and hold the Vol button for a short time until the speakers reach an appreciable volume level Note It is possible for your speakers to be out of phase where switching2. cable supplied connects to many different audio sources including CD s MP3 s lpod s etc The 3 5mm jack to 2x phono RCA type red amp white plugs supplied connects to many devices through the audio out function of devices like TV s DVD s and receiver amplifiers Note It is possible that the supplied packaged batteries have lost their charge during the shipping process Please replace before troubleshooting 2 1 T j arene Rubber EE ere tena it ra or 5 a Mains 1200 in 4 bo 12v suppi g Composite abinci Set up the Wireless Rock Speakers 1 Carefully unpack tilt on their side and look carefully at the base of your new TIC wireless rock speakers 2 Note first the 110v mains connection input on the base plate covered by 6 a soft rubber protector Locate the supplied mains cable plug in connection cable and push in firmly then screw on its protective cover then plug in the connection at the wall mains plug Locate the silicone covered On amp Off switch Switch On the Red rocker switch and note the Green LED light comes on which shows the unit is operating and ready to receive a broadcast signal Note At this time you should test the operation of the units using the mains power only to ensure correct operation of the system so far Switch off the units rocker switch and disconnect the mains cable connection Note the Screw On Off Battery cover Carefully screw off this cover
3. to make sure the speaker is switched on Check the volume control on your Remote Control is switched high enough for volume to be heard Check the Green indicator light on your speakers to ensure they are receiving a signal Ensure you speakers are receiving power Red LED Check the balance control on your receiver amplifier is equal Check all connections and cable to and from or the integrity of the transmitter source to the inoperable speaker Check the batteries or power source s to the inoperable speaker Loudspeaker is flashing red or full light the battery of the loudspeaker or remote control will soon be out of power Please replace Check the range by temporarily bringing the exterior speakers closer to the transmitter Source Lift the transmitter height to see if this has any effect Follow same procedure as above for No Sound 11 Technical Specifications TIC WRSO10 wireless rock speakers Audio Inputs Analog digital CD s MP3 s lpod s receiver amplifiers 2x mic s Accessories Included 1x 3 5mm to 3 5mm digital cable 1x 3 5mm to 2x phono RCA type cable 2x rock speaker 120v to 9v transformer Selectable RF Channels 8 channels Broadcast Frequency Range 2400 2483 mHz Transmitter Voltage DC 7 5v 500mA Receiver Voltage DC 9v 800mA Power consumption 90mA Impedance 8 Ohms Sensitivity 1W 1M 84db 3db Continuous
4. Oumers Guide TIC WRSO10 Wireless Outdoor Rock Speakers TIC Outdoor Wireless Rock Speakers Weatherproof Design Pair of Stone Wireless Rock Speakers State of the art 2 4gHz operation Safe 9v speaker transformers power supply incl or uses 6xAA batteries Full featured remote control included Remote control power 1x23A battery Mini Rock transmitter unit included Transmitter power 3xAA batteries 300ft transmitter broadcast range 80ft Remote Control range 2x 5 Dual Cone Speaker Drivers Aerospace grade Teflon sealed multi layer composite cabinetry Canyon CN or Slate SL Stone finish Accent amp aesthetically enhance any exterior landscape setting without wires TIC Corporation U S A TICO1092009SR For your Records Manufacturer TIC Corporation www ticcorp com Contact g00 SPX OMNI Model WRS010 color Serial Dealer Name Dealer Contact Purchase Date Invoice Receipt We recommend you keep your sales receipt and warranty card together with this owners guide for safe keeping and future reference a T ite 7 Fe ROHS ae COMPLIANT This TIC product conforms to all applicable LISTED One World TIC Recycles Index Introduction Index Component LIST nxccsnecccoteuseceeee Pre Installation 00ceeeee Installation Prep s000 General Installation Exterior Installation Main
5. Peak 2 5 5W Frequency Response 90Hz 18kHz Transmitter Range 100m 300ft unobstructed Remote Control Range 30m 80ft unobstructed Battery use Approx 6 8 hrs Unit size 9 4 x 9 4 x 7 4 in Pack size 18 x 10 x 8 5 in pair Pack Weight 15 2 Lbs TIC Corporation engages in continual product research and development new materials production methods and design improvements TIC Corporation their agents representatives and distributors therefore reserves all rights to change or improve products specifications without notice TIC Corporation 15224 East Stafford Street City of Industry CA 91744 4418 U S A Tel 626 968 0211 5 lines Fax 626 968 1363 Email info ticcorp com Web www ticcorp com 12
6. on the remote switches on one speaker but not the other In this case completely power down the system removing any batteries in the speakers then power up and switch on again regaining balance Exterior Installation Some general notes and tips for when you install your new TIC Wireless Outdoor Rock Speakers in an Exterior environment Whi f AN S Lo 4 MAAD My 1 Don t forget to test your new product prior to exterior installation 2 Carefully unpack your new TIC WRS010 outdoor wireless rock speakers and inspect all components as previously described 3 Carefully connect your Mini Rock broadcast transmitter to a working sound source Attach any output devices CD s MP32 s Ipod receiver amplifier etc Ensure it has power and is switched On Green LED 4 Locate your new exterior rock speakers using the previously described placement techniques ensure no architectural or other broadcast signal obstructions 5 Power up your speakers ensuring the Green signal light is lit 6 Using your remote control switch On then adjust the volume of your outdoor speakers 7 Be aware of the Red LED light flashing when battery power is low Once connected properly sit back and enjoy Enjoy a quality outdoor music room Disclaimer TIC Corporation will in no way be held responsible for the improper misuse or unsecured installation of this product Any and all damage s arising from the installation or
7. ssion or area where water pools or in the direct path of garden sprinklers 4 Whenever possible avoid long term exposure of your new TIC outdoor speakers to excessive high temperatures chlorinated solvents acids such as those often contained in fertilizers and other solvents which potentially could wear your speaker components prematurely 5 There is no requirement for customers to open this unit far any kind of operation or maintenance Doing so may void the warranty 6 Please ensure the base plate silicone covered power switch is in the off position when not in use The unit consumes power including battery power even in the stand by mode 7 Avoid any shocks high vibration collisions or sudden impacts to the speaker unit or its electronic components General Installation WRS010 Outdoor Rock Speakers Set up the Transmitter iara ta aes 1 Power the Transmitter a fmm jack o Power SON LED In the base of the Audija Source aa i inet a transmitter remove the Ena S Paai Chansel Change retain cover plate and insert button 3x AA batteries to power the transmitter 2 Check the Green LED light is on showing the transmitter has power 3 Connect the transmitter to an Audio Source using either the 3 5mm jack or 2x phono RCA type red amp white plugs supplied Note The TIC WRS010 is capable of working with the Audio Output of many different sound sources The 3 5mm to 3 5mm jack
8. tenance cceeeeeees Customer ServiCe 005 Waran eara O E A O Oo O O N A A A O Installation Notes 00 A Trouble Shooting 000000aaan Technical Specifications 12 Contact TIG sirrin 12 Thank You for purchasing another high quality outdoor audio product from TIC Corporation Please read the enclosed installation guidelines carefully and thoroughly to ensure years of trouble free service from your new TIC exterior audio products Carefully unpack your new TIC exterior product and save all packaging materials for possible future use Check that your new TIC product contains all system parts detailed in your components list Do not attempt to operate install or use your new TIC product if any components appear missing or damaged if so please notify TIC Corporation or your TIC product Dealer as soon as possible WARNING To avoid possible suffocation or injury please keep all plastic bags away from children or pets Component List Check all components carefully before use 2x Outdoor Wireless Rock Speakers 2x Battery compartment modules and mains AC transformers 120v house mains AC to 9v DC base of units 1x Broadcast Transmitter unit 3x AA batteries 1x 3 5mm to 2x phono RCA type audio output connection cable 1x 3 5mm to 3 5mm digital audio CD MP3 Iphone etc Output cable 1x Full featured Remote Control unit 1x 24A battery 1x Instruc
9. the battery compartment and function of the unit Do not leave the batteries installed when operating on AC power Please dispose of all batteries in accordance with local amp federal regulations General While TIC tries to offer its customers the most adaptable unit possible for ease of use and this product does offer a wide variety of connection methods we thought we should point out that there is a preference Whenever possible please try to use outputs or adjust volume using only the supplied remote control volume buttons and not use the volume controls on the output devices used Please make any installation notes you feel important here 10 Troubleshooting No Sound No Sound from one speaker Speaker has intermittent or rough sound the distance of the remote control volume controller becomes nearer One speaker sounds distorted lower volume Transmitter is not initialized Re check the power is on at the transmitter and try changing channels at the transmitter Check the audio signal source both to and from the transmitter Try another cable to ensure integrity Check the receiver amplifier if used is powered on at the mains is not on mute has no headphones attached and that the Channels used for the transmitter exterior soeakers usually A or B is in operation Refer to the owners guide that came with your receiver amplifier Check the on switch at the Remote Control
10. tion manual amp Warranty card A A 3 E Li TIC WRSO010 connector components Pre Installation Need Professional Help Please read this owners guide carefully before installation Failure to follow these instructions fully or incorrect installation may damage your new TIC products and any third party equipment used in your new system installation This may also void any warranty for your new TIC products If you are unsure of your ability to fully understand and fully complete the installation of this TIC product please consult a professional installer Installation Prep Before you begin the installation of your new TIC outdoor product please carefully select the locations of your new TIC outdoor products Please select your placement 4 location carefully try to avoid 2 obstructions to the transmitter 1 Select a reasonably level surface for the installation of your new TIC outdoor speakers For surface speakers this will prevent movement or excessive vibration during use This will also ensure more uniform sound dispersion 2 For Wireless Speaker Broadcasts in normal circumstances we suggest placing the transmitter at a height of 1 meter above the receiving units rock speakers because land will absorb radio waves produced by the transmitter Within the maximum area of coverage the zero boundary is 100m unobstructed or approx 300ft 3 Do not place your TIC outdoor speakers in a depre
11. use of this product is the purchaser end user and final installers sole responsibility Please see Warranty for other conditions Maintenance Occasional maintenance of your TIC exterior products cannot hurt and may help greatly Inspect the installation area regularly removing any twigs dirt or impediments from building up around the output grill area The units may be cleaned using very mild detergents like dishwashing liquid if desired A hose using clean water may be used but please avoid using high pressure or forcing water into the grill or acoustic ports In very cold climates with heavy snowfall an old trick from the many theme parks which use our products is to place a plastic bag over the unit outdoors until spring Customer Service For any additional help please contact TIC Corporation at 800 SPX OMNI or online at www ticcorp com or by email at support ticcorp com where we would be happy to assist you Also please visit our website for FAQ frequently asked questions and for full Contact information Warranty Period TIC Corporation offers a full UCC approved one year full parts and labor warranty on all its exterior outdoor products Note Please see the full 12 months limited warranty card for fuller description of terms and conditions that apply to the warranty with this product Installation Notes Note Do not mix Battery types alkaline zinc etc This could be detrimental or damage the unit and
Download Pdf Manuals
Related Search