Sunpentown Intl MICRO-COMPUTER RR-9215 User's Manual
Contents
1. BR A A WD NOD DD OW STRUCTURE DESCRIPTION amp FUNCTION OPERATION 8 power levels wattage 100 300 500 700 900 1100 1300 1500 1 Plug power cord to power source and place cookware centered on Wire cooktop Once power is connected the LOCK button will illuminate 2 To turn on press LOCK followed by ON OFF button If ON OFF is not pressed within 30 seconds unit will return to locked mode Air Outlet Ceramic Panel 3 Press or button to set cooking level press LOW button to jump to lowest setting 100W or press HIGH button for highest setting 1500W Note Factory default setting is at 900W CAUTION When the Warning indicator is on the ceramic plate is OPAN OnE ane extremely hot DO NOT TOUCH as Air Inlet TIMER SETTING 1 Press TIMER button 2 Press or button to set cooking time Each single press is increment of 1 minute Press and hold for increments of 10 minutes Timer Timer Cook LED Cook Warning Press LOW button to jump to 1 minute on the timer button indicator display button indicator Press HIGH button to jump to the maximum 8 hours Note factory default is 2 hours SPT sexe A mi O LOCK BUTTON TIMER cook 1 Press LOCK button to lock in settings When locked display will jump between time left and setting Lock ON OFF No changes can be made level or time Lock Power level Timer Power button controls button 22. Press LOCK button again to unlock KEY POINTS When the Warming indicator is on this means the ceramic plate is extremely hot DO NOT TOUCH Cooker will automatically shut off after 2 hours of inactivity when not set on timer Place cooktop on flat surface but keep a clearance of 4 inches all around for proper ventilation If air inlet or outlet is blocked the internal temperature will rise and cause unit to overheat and shutoff during cooking Never power on unit without cookware May cause ceramic plate to overheat and crack Keep away from water source Never immerse unit in water or clean under running water Do not place paper or cloth in between the cooktop and cookware To prevent damage to your cookware do not heat an empty pan Do not place one cooktop on top of another Do not place on or near a hot gas or electric burner or in a heated oven If the surrounding temperature is high unit will shut off Do not use cookware consisting of inferior enamel synthetic material china or aluminum DO NOT USE PLASTIC WRAP Never heat an unopened can on the cooktop as it may explode Plug cooktop in a dedicated 15 amp outlet Do not share the outlet with other appliances Do not damage the ceramic plate Be careful not to drop anything onto the ceramic plate If the plate is broken or cracked stop using immediately Turn unit off and unplug Deep fry is prohibited This cooktop is not intended for use b
3. SPT Micro Computer Radiant Cooktop RR 9215 INSTRUCTION MANUAL Thank you for your purchase Please read thoroughly before initial use and keep in a safe place for future reference IMPORTANT SAFEGUARDS INDEX Read all instructions Do not touch hot surfaces To protect against electrical shock do not immerse cord or appliance in water or any other liquid Close supervision is necessary when any appliance is used by or near children Unplug from outlet when not in use and before cleaning Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any way Return appliance to the Sunpentown for examination repair or adjustment The use of accessory attachments not recommended by the manufacturer may cause injuries Do not use outdoors Do not allow cord to hang over the edge of table or counter or touch hot surfaces Do not place on or near a hot gas or electric burner or in a heated oven Do not use appliance for anything other than intended use Use of an extension cord is not recommended If needed use an extension cord of 14 gauges on diameter not longer than 10 feet Key points before USC 0ceeee ee reren Selecting the proper cookware Care and maintenance 0 ceeeeeeeee Specifications cec eee eeeeee ee neor neee Trouble ShOOting cece ee eee nent eee eeees Warranty
4. r code E5 Check if unit reached set timer Unit has been operating and idle for 2 hours Safety feature automatically shuts unit off after 2 hours with no setting changes Is the Display indicating any of the above error code Unit suddenly stops heating during normal operation This device complies with part 15 of the FCC rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment NOTE This equipment has been tested and found to comply with the limits for a consumer ISM equipment pursuant to Part 18 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged
5. r failure to perform the necessary maintenance This GUARANTEE is in addition to your Statutory Rights SUNPENTOWN INTERNATIONAL INC 1 800 330 0388 service sunpentown com www sunpentown com
6. to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help SPT Your Guarantee If this product is found to be faulty as a result of faulty materials or workmanship within one year from date of purchase it will be repaired free of charge This guarantee is subject to the following terms e Sunpentown must be notified of the fault e Proof of purchase must be presented to Sunpentown s nominated representative e The warranty will be void if the product if modified misused or repaired by an unauthorized person e The warranty after repair will not be extended beyond the original one year period All replacement parts will be new or reconditioned Parts which are replaced become the property of Sunpentown e The warranty applies for the use of the product in the USA only What is NOT COVERED e Warranty does not include freight charges e Incidental or consequential damage caused by possible defects with this product e Damage to product caused by improper power supply voltage accident fire floods or acts of nature e Failure of product resulting from unauthorized modifications to the product e Improper installation o
7. y persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless supervised by person responsible for their safety SELECTING THE PROPER COOKWARE This radiant cooktop is not selective with cookware However cookware with a flat bottom and matte finish will have the best heat conductivity It is not suggested to use pressure cooker on the cooktop If you do use one please use with caution CARE amp MAINTENANCE Unplug unit from power source Wipe ceramic plate and exterior surface with a soft damp cloth If excessively dirty soak cloth in a mild detergent and water mixture SPECIFICATIONS Model RR 9215 Voltage 120V 60Hz Power consumption 1500W max Dimension 12 25 Lx 15 5 Wx 2 75 H in Weight 6 6 Lbs Power range 100 1500 W Cord length 4ft TROUBLESHOOTING ERROR CODES PROBLEM CHECK POINTS Unit is plugged in Is cooktop firmly plugged into a correct but power indicator outlet does not come on Was there a power shortage Power indicator is lit but not heating Please contact Sunpentown Unstable voltage detected please wait until Error code E2 voltage returns to normal Error code E4 Blown fuse please contact Sunpentown Internal temperature is too high Please check if fan is running if ambient temperature is high or if air inlet or outlet is blocked Erro
Download Pdf Manuals
Related Search