Sony CDX1000RF User's Manual
Contents
1. Location of controls 1 AMS Automatic Music Sensor K lt button 2 AMS Automatic Music Sensor gt gt I button 3 Disc insertion slot 4 amp eject button 5 gt Il play pause button If pressed during playback the CD will pause If pressed again playback will continue Getting Started Reset button Display window SHUF shuffle play button REPEAT repeat play button DSPL display mode change button OFF button CO IN lo Resetting the unit Before operating the unit for the first time or after replacing the car battery you must reset the unit Press the reset button with a pointed object such as a ball point pen gt j2 e GF Reset button Notes e Pressing the reset button will erase the clock setting and some memorized program and memory functions e When you connect the power supply cord to the unit or reset the unit wait for about 10 seconds before you insert a disc If you insert a disc within these 10 seconds the unit will not be reset and you will have to press the reset button again Changing the transmitting frequency Because this unit processes CD playback sound through an FM tuner there may be interference noise during CD playback In this case change the frequ2. Repeat Play Press during playback REP appears in the display When the current track is over it will play again from the beginning To return to normal playback mode press again Playing tracks in random order Shuffle Play Press during playback SHUF appears in the display To return to normal playback mode press again Troubleshooting guide The following checklist will help you remedy the problems you may encounter with your unit Before going through the checklist below check the connection and operating procedures Problem Cause Solution e Another CD is already loaded CD cannot be loaded e The CD was forcibly inserted upside down Play does not begin Dirty disc CD is automatically ejected The ambient temperature exceeds 50 C 122 F CD will not eject Press the amp button for two seconds The operation buttons do not Press the reset button function The sound skips due to e The unit is installed at an angle of more than 60 vibration e The unit is not installed in a sturdy part of the car Error displays The following indications will flash for about five seconds Display Cause Solution core A CD is dirty or inserted upside Clean or insert the CD correctly CUT down T Q The CD player cannot be operated Press the reset button or amp E l because of some problem If the above mentioned solutions do not help improve the situation cons
3. 5 Elapsed playing time Note To play back an 8 cm 3 in CD use the optional Sony compact disc single adapter CSA 8 3 Adjust the volume with the volume control on the car audio To Press Stop playback or Eject the CD Notes e Be sure to press to turn this unit off when you want to listen to FM radio e When CD playback is stopped you may hear some noise from the speakers To prevent this from happening turn the volume down before stopping CD playback e If you leave the ejected disc in the disc insertion slot after you have pressed amp the disc will automatically retract into the unit after about 15 seconds in order to protect it Changing the display item Each time you press during CD playback the item changes as follows Elapsed playing time 4 gt Track number Locating a specific track Automatic Music Sensor AMS During CD playback press either side of for each track you want to skip To locate preceding To locate succeeding tracks tracks Locating a specific point in a track Manual Search During playback press and hold either side of for about two seconds Release when you have found the desired point To search backward To search forward Note If on oe oe or 4747 7 appearsin the display you have reached the beginning or the end of the disc and you cannot go any further Playing a CD in various modes Playing tracks repeatedly
4. SEEK AMS control momentarily and release Locate a specific point within a track Rotate the SEEK AMS control and release when the desired point is found Adjust the volume Rotate the volume control 3 An adaptor optional may be necessary for your car and car audio system Source selector In such a case consult your dealer 4mm 7 16 in CDX 1000RF
5. T of this unit Otherwise the volume of the connected Be sure to connect the black ground lead first tr Aue nj speakers cannot be adjusted to dashboard center console a to dashboard center console D max size 5 x 6 mm 7 32 x 1 4 in max size 5 x 6 mm Bracket A 132x 1 4 in Bracket CDX 1000RF To AUDIO IN one of the car audio CDX 1000RF RCA pin cord Bracket not supplied Bracket REMOTE IN Existing parts supplied with your car Existing parts supplied with your car Note From carantenna To prevent malfunction install only with the supplied screws 1 9 m 6 ft 3 in Rotary commander RM X4S not supplied 0 5 m Removing the unit 1 ft 8 in If you have a Sony car audio with the Sony BUS terminal the optional source selector Car audio Speaker system XA 107 can be used in your system Antenna connector 1 Insert the supplied tool betw een the unit and the frame and rotate 90 to 2 Insert a flathead screw driver betw een the bracket and mounting spring Gently release the hidden mounting spring Repeat on the opposite side and remove pry the spring toward the unit while pulling the unit out a little Repeat on the Sony car audio the frame opposite side and remove the unit 2 You can also control the following functions with the rotary cammander RM X4S Power on Press SOURCE Power off Press OFF Locate a specific track Rotate the
6. all point en etc FN Bend these claws if necessary Note To prevent malfunction install mAs x4 With the TOP marking up only with the supplied screws cO CSP Lorr J Caution To support the unit Fire wall Cautionary notice for handling the bracket Handle the bracket carefully to avoid injuring your fingers Dashboard Reset button max size M4 x 6 mm 2 16 x 1 4 in Connection example With the TOP marking up To a metal point of the car Black Blue White First connect the black ground lead then connect the yellow zum and red power input leads 0 5m 0 5m AMP REMOTE OUT 1 ft 8 in 1 ft 8 in Max supply current 0 3 A gt To AMP REMOTE IN of the car audio Mounting the unit in a J apanese car You may not be able to install this unit in some makes of Japanese cars In such a case consult your Sony dealer To the 12 V power terminal which is energized in Red the accessory position of the ignition key Be sure to connect the black ground lead first 0 5 m k 1 ft 8 in TOYOTA NISSAN max size 5 x 6 mm max size 5 x 6 mm 1 You can only connect a car audio which has both a remote 7 32 x 4 4 in 7 32 x Ya in amplifier input AMP REMOTE IN and an audio input AUDIO IN Car audio with FM tuner To the 12 V power terminal which is energized at Yellow Note Car audio with FM tuner Iti Do not connect an external amplifier to the audio output AUDIO all times 05 OU
7. e discs explained below the sticky residue can cause the CD to stop spinning and may cause malfunction or ruin your discs Do not use second hand or rental CDs that have a sticky residue on the surface for example from peeled off stickers or from ink or glue leaking from under the stickers There are paste residue Ink is sticky Do not use rental CDs with old labels that are beginning to peel off Stickers that are beginning to peel away leaving a sticky residue Do not use any discs with labels or stickers attached The following malfunctions may result from using such discs Inability to eject a disc due to a label or sticker peeling off and jamming the eject mechanism Inability to read audio data correctly e g playback skipping or no playback due to heat shrinking of a sticker or label causing a disc to warp Labels are attached When you play 8 cm 3 in CDs Use the optional Sony compact disc single adapter CSA 8 to protect the CD player from damage Notes on moisture condensation On a rainy day or in a very damp area moisture may condense on the lenses inside the CD player Should this occur the unit will not operate properly In this case remove the disc and wait for about an hour until the moisture evaporates Maintenance Fuse replacement When replacing the fuse be sure to use one matching the amperage rating stated on the original fuse If the fuse blows check th
8. e power connection and replace the fuse If the fuse blows again after replacement there may be an internal malfunction In such a case consult your nearest Sony dealer Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit Specifications CD player section System Compact disc digital audio system Signal to noise ratio 90 dB Frequency response 10 20 000 Hz Wow and flutter Below measurable limit Laser Diode Properties Material GaAs GaAlAs Wavelength 785 815 nm Typ 800 nm Emission Duration Continuous Laser output power Less than 0 5 mW This output isthe value measured at a distance of 0 7 mm from the objective lens surface on the Optical Pick up Block General Outputs Line output Power requirements 12 V DC car battery negative ground Current drain 2 A at disc loading Dimensions Approx 178 x 50 x 173 mm 7 sx2x67 s in w h d Mounting dimensions Approx 182 x 53 x 159 mm 7 4x 21 8 x 63 s in w h d Mass Approx 1 1 kg 2 Ib 7 oz Parts for installation and connections 1 set Compact disc single adapter CSA 8 Rotary commander RM X4S Source selector XA 107 BUS cable supplied with an RCA pin cord RC 61 1 m RC 62 2 m Supplied accessories Optional accessories Design and specifications are subject to change without notice SONY 3 045 044 13 1 Compact Disc Player Operating Instr
9. emperatures such as from direct sunlight or a gE hot air from the heater or where it would be subject to dust dirt or excessive vibration e Use only the supplied mounting hardware for a safe and secure installation e Connect the yellow and red power input leads only after all other leads have been connected e Be sure to connect the red power input lead to the positive 12 V power terminal which is energized when the ignition key is in the accessory position e Run all ground wires to a common ground point e Connect the yellow cord to a free car circuit rated higher than the unit s fuse rating If you connect this unit in series with other stereo components the car circuit they are connected to must be rated higher than the sum of the individual component s fuse rating If there are no car circuits rated as high as the unit s fuse rating connect the unit directly to the i battery Mounting example If no car circuits are available for connecting this unit connect the unit to a car circuit rated higher re than the unit s fuse rating in such a way that if the unit blows its fuse no other circuits will be cut Installation in the dashboard off e The use of optical instruments with this product will increase eye hazard cy max size 5 x 6 mm 7 32 x 4 4 in x2 Reset button When the installation and connections are complete be sure to press the reset button with a b
10. ency of the modulated RF signal transmitted from the unit The initial setting is 88 3 MHz 1 Press for two seconds until frequency appears 2 Press either the left or right side of to select the frequency Each time you press AMS the frequency changes as follows Pri 88 3 MHz 88 5 MHz 88 7 MHz gt 88 9 MHz 89 1 MHz 89 3 MHz gt 89 5 MHz 89 7 MHz 89 9 MHz gt kea 88 3 MHz 89 9 MHz 89 7 MHz gt 89 5 MHz 89 3 MHz 89 1 MHz gt 88 9 MHz 88 7 MHz 88 5 MHz gt 3 Press for more than two seconds Note Be sure to set the frequency of your FM tuner to the newly selected frequency es Changing the output level You can select the output level of the CD player Normally the initial output level is adequate change the level if necessary 1 Press for two seconds 2 Press again a Initial setting 3 Press either the left or right side of to select the output level To decrease the output level LeveL f m gt To increase the output level PP 7 gt 33 me 4 Press for more than two seconds Operation Listening to a CD 1 Adjust the selected transmitting frequency with an FM tuner 88 3 MHz 88 5 MHz 88 7 MHz 88 9 MHz 89 1 MHz 89 3 MHz 89 5 MHz 89 7 MHz 89 9 MHz 2 Insert a CD Playback starts automatically Label side up If a CD is already inserted press Pll to start playback MIN m s H t
11. ou are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment CAUTION The use of optical instruments with this product will increase eye hazard Welcome Thank you for purchasing the Sony Compact Disc Player This unit lets you enjoy a variety of features Features e Easy connection to any car audio with an FM tuner Dashboard installation for easy CD disc changing 8X digital sampling filter for clear CD audio e Quick recovery function to minimize disturbance from skips e Repeat play function for playing tracks repeatedly Shuffle play fucnion for playing tracks in random order http www sony net Connections Installation EEEE Parts for Installation and Connections g Caution The numbers in the list are keyed to those in the instructions Precautions e This unit is designed for negative ground 12 V DC operation only Do not tamper with the four holes on the upper surface of the unit They are for tuner adjustments to be Mounting angle adjustment e Before making connections disconnect the ground terminal of the car battery to avoid short circuits done only by service technicians Adjust the mounting angle to less than 60 e Choose the installation location carefully so that the unit will not hamper the driver during driving e Avoid installing the unit where it would be subject to high t
12. uctions Owner s Record The model and serial numbers are located on the bottom of the unit Record the serial number in the space provided below Refer to these numbers whenever you call upon your Sony dealer regarding this product Model No CDX 1000RF Serial No COMPACT DIGITAL AUDIO CDX 1000RF Sony Corporation 2000 Printed in Korea Warning This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Y
13. ult your nearest Sony dealer Additional Information Precautions e This unit cannot be used with a car audio without an FM tuner e If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car allow the unit to cool off before operating it e If no power is being supplied to the unit check the connections first If everything is in order check the fuse e Connecting this unit may cause some car battery wear when your car has no ACC accessory position on the ignition key switch If you have any questions or problems concerning your unit that are not covered in this manual please consult your nearest Sony dealer Notes on handling CDs A dirty or defective disc may cause sound dropouts while playing To enjoy optimum sound handle the disc by its edge To keep the disc clean do not touch the surface E Do not stick paper or tape on the labeled surface Do not expose the discs to direct sunlight or heat sources such as hot air ducts or leave them in a car parked in direct sunlight where there can be a considerable rise in temperature inside the car x oes Before playing clean the discs with a commercially available cleaning cloth Wipe each disc from the center out Do not use solvents such as benzine thinner commercially available cleaners or antistatic spray intended for analog discs yy EX 6 C Notes on discs If you use th
Download Pdf Manuals
Related Search