Soleus Air HM2-15R-32 User's Manual
Contents
1. To keep the heater clean the outer shell may be cleaned with a soft damp cloth You may use a mild detergent if necessary After cleaning dry the unit with a soft cloth CAUTION DO NOT let liquid enter the heater 3 DO NOT use alcohol gasoline abrasive powders furniture polish or rough brushes to clean the heater This may cause damage or deterioration to the surface of the heater 4 DO NOT immerse the heater in water 5 Wait until the unit is completely dry before use STORAGE Store the heater in a cool dry location when not in use To prevent dust and dirt build up use the original packaging to repack the unit TROUBLESHOOTING If the heater will not operate please check the following before seeking repair of service 1 Check if the power cord is plugged into an electrical outlet if not plug in 2 Check if electricity to the main fuse is working 3 Make certain the unit is turned on and either the HIGH LOW or ECO mode is selected If not turn the heater on and choose a setting NOTE The heater may not be operating if the thermostat is set higher than the room temperature To begin operation increase the thermostat temperature for a higher heat setting WARRANTY One Year Limited Warranty Soleus International Inc warrants the accompanying Soleus Air HM2 15R 32 to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE 1 year from t2. Flat Panel Micathermic CSOLEUSAID Heater with Remote Control OWNER S MANUAL Model HM2 15R 32 PLEASE SAVE THESE INSTRUCTIONS WARNING READ THIS OWNER S MANUAL CAREFULLY BEFORE USE FLAT PANEL MICATHERMIC HEATER w REMOTE CONTROL Thank you for choosing a Soleus Air heater This owner s manual will provide you with valuable information necessary for the proper care and maintenance of your new product Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater For your own records please attach a copy of your sales receipt to this manual Also write the store name location date purchased and serial number below Store Name Location Date Purchased Serial Number located on back of unit IMPORTANT INSTRUCTIONS When using this electric unit basic safety precautions should always be followed to reduce the risk of fire electric shock and injury to persons including the following 1 Read ALL instructions before using this unit 2 CAUTION Risk of Electric Shock DO NOT open or try to repair the heater yourself 3 This heater may get hot when in use To avoid burns DO NOT let bare skin touch hot surfaces If provided use handles when moving this heater 4 Keep combustible materials such as furniture pillows bedding paper clothes and curtains at least 3 ft from the front of the heater and keep them aw
3. ay from the sides top and rear DO NOT place towels or other objects on the heater 5 Extreme caution is necessary when any heater is used by or near children or the disabled or when the heater is left operating and unattended 6 DO NOT operate any heater with a damaged cord or after the heater malfunctions has been dropped or damaged in any manner Return heater to authorized service facility for examination electrical or mechanical adjustment or repair 7 This heater is not intended for use in bathrooms laundry areas and similar indoor locations NEVER locate heater where it may fall into a bathtub or other water container To protect against electrical hazards DO NOT immerse in water or other liquids 8 DO NOT touch the control panel or plug with a wet hand 9 DO NOT run cord under carpeting DO NOT cover cord with throw rugs runners or similar coverings Arrange cord away from traffic area and where it will not be tripped over 10 DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater 11 To prevent a possible fire DO NOT block the air intakes or exhaust in any manner DO 2 12 13 14 15 16 17 18 19 20 2 22 NOT use on soft surfaces like bed where openings may become blocked A heater has hot and arcing or sparking parts inside DO NOT use in areas where gasoline paint explosive a
4. he cord has a plug as shown in A An adapter as shown in C is available for connecting three blade grounding type plugs to two slot receptacles The grounding lug extending from the adapter must be connected to a permanent METAL SCREV T COVER OF GROUNDED OUTLET BOX GROUNDING PIN a gt ground such as a properly grounded outlet box gt The adapter should not be used if a three slot E grounded receptacle is available GROUNDING DO NOT DEFEAT THE SAFETY PURPOSE OF THE GROUNDED PLUG SPECIFICATIONS Voltage Rating 120 V 60Hz Power Consumption 750 1500W Unit Size 18 in W x 8 5 8 in D x 26 in H Unit Weight 11 Ibs PRODUCT DIAGRAM oo Carrying Handle Control Panel Wheel Base Remote Control ASSEMBLY 1 Remove the heater body two wheelbases wheels screws and washers from the box Remove the packaging materials and keep for future storage 2 Attach the wheels to each wheelbase with the supplied wheel screws small black spring washers and small grey washers Wheel Screw _f Wheel e Small Black Spring Washer 3 Be certain the heater is unplugged and the controls are set to off Set the heater on the floor upside down Small Grey Washer 4 Attach a wheel base with wheels attached to each end of the heater body using the supplied standard screws large black spring washers and large grey washers Standa
5. he date of original retail purchase in the United States If the unit exhibits a defect in normal use Soleus International Inc will at its option either repair or replace it free of charge within a reasonable time after the unit is returned during the warranty period As acondition to any warranty service obligation the consumer must present this Warranty Certificate along with a copy of the original purchase invoice THIS WARRANTY DOES NOT COVER 1 Damage accidental or otherwise to the unit while in the possession of a consumer not caused by a defect in material or workmanship 2 Damage caused by consumer misuse tampering or failure to follow the care and special handling provisions in the instructions 3 Damage to the finish of the case or other appearance parts caused by wear 4 Damage caused by repairs or alterations of the unit by anyone other than those authorized by Soleus International Inc 5 Freight and Insurance cost for the warranty service ALL WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY ARE LIMITED TO ONE YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY SOLEUS INTERNATIONAL INC DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT SHALL SOLEUS INTERNATIONAL INC S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS UNIT This warranty covers only new products purchased from our authorized dealers or retailer
6. nd or flammable liquids are used or stored Keep unit away from heated surfaces and open flames Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire However if you have to use an extension cord the cord shall be No 16 AWG minimum size and rated not less than 1500W To avoid fire or shock hazard plug the unit directly into a 115 V AC electrical outlet To disconnect heater turn controls to OFF then remove plug from outlet Pull firmly on the plug DO NOT unplug by pulling on the cord Always unplug the unit before moving or cleaning or whenever the heater is not in use Use only for intended household use as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons The use of attachments not recommended or sold by unauthorized dealers may cause hazards Always use on a dry level surface Use on floor only DO NOT use outdoors WARNING To reduce the risk of fire or electric shock DO NOT use this unit with any solid state speed control device DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit Doing so will void your warranty The inside of the unit contains no user serviceable parts Qualified personnel should perform all servicing only Connect to properly grounded outlets only 23 SAVE THESE INSTRUCTIONS WARNING This heater has a voltage rating of 120 volts T
7. rd Screw 1 aon Large Grey Washer Large Black Spring Washer Wheel Base Heater Body OPERATING INSTRUCTIONS Place the heater on a firm level surface and plug into a grounded 120V 60Hz power outlet Only operate heater in upright position with caster wheels attached Temperature Display _ Receiver for Remote Control Timer Button Temperature Buttons Indication Lights Hoge Mode Select Button On Off Button 1 Turn the heater on by pressing the On Off button on the control panel or the supplied remote control 2 Select a heat setting Press the MODE button to toggle between the three heat settings LOW 750W HIGH 1500W and ECO mode When using the remote control press either MODE button to select the preferred power setting NOTE ECO mode is an Economic Energy Saving Function When ECO mode is chosen the heater will consume one third less power once the room temperature reaches a certain point 3 Adjust the thermostat by pressing the arrows on the control panel or remote control The digital readout will display the selected temperature 4 Once you have chosen the desired temperature the heater will remain on until the room temperature increases to the temperature on the digital display The heater will cycle on and off to maintain the desired room temperature 5 This heater is equipped with a 12 hour automatic shut off timer To activate the timer press the TIMER button on the cont
8. rol panel or remote control Each press of the timer button will increase the heater operating time by one hour The digital readout will display the number of hours you have selected To turn off the timer simply press the TIMER button until the digital readout displays your current selected temperature 6 The indication lights on the control panel communicate how the product is operating The POWER light will turn on when the unit is operating The TIMER light will turn on when the timer has been activated When choosing between High Low and ECO modes the corresponding lights will turn on according to the mode that has been selected 7 Unplug the heater when not in use NOTE For safety if the heater s internal temperature rises above a certain point the heater is designed to automatically shut off To restart the heater in this situation 1 Turn the Heater off by pressing the On Off button 2 Unplug the power cord from the outlet and allow the heater to cool for at least 10 minutes 3 Plug the power cord back into the outlet and select the desired heat setting WARNING It is normal for the power cord to feel warm to the touch however a loose fit between the outlet and the plug may cause overheating of the plug If this occurs try inserting the plug into a different outlet Contact a qualified electrician to inspect the original outlet for damage 1 Unplug the unit and let it cool completely 2
9. s It does not cover used salvaged or refurbished products As some states do not allow the limitation or exclusion of incidental or consequential damages or do not allow limitation on implied warranties the above limitations and exclusions may not apply to you This warranty gives you specific legal rights and you may also have other rights that vary from state to state For Technical Support and Warranty Service Please Call 888 876 5387 Or Write To Soleus International Inc 9451 Telstar Ave El Monte CA 91731 USA www soleusair com
Download Pdf Manuals
Related Search