Soleus Air MW-59 User's Manual
Contents
1. WARRANTY One Year Limited Warranty Soleus International Inc warrants the accompanying Soleus Air MW 59 to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE 1 year from the date of original retail purchase in the United States If the unit exhibits a defect in normal use Soleus International Inc will at its option either repair or replace it free of charge within a reasonable time after the unit is returned during the warranty period As a condition to any warranty service obligation the consumer must present this Warranty Certificate along with a copy of the original purchase invoice THIS WARRANTY DOES NOT COVER 1 Damage accidental or otherwise to the unit while in the possession of a consumer not caused by a defect in material or workmanship 2 Damage caused by consumer misuse tampering or failure to follow the care and special handling provisions in the instructions 3 Damage to the finish of the case or other appearance parts caused by wear 4 Damage caused by repairs or alterations of the unit by anyone other than those authorized by Soleus International Inc 5 Freight and Insurance cost for the warranty service ALL WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY ARE LIMITED TO ONE YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY SOLEUS INTERNATIONAL INC DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AN2. Aqua Sub Easy Load Water Cooler SOLEUSAIF5 MW 59 Owner s Manual n 3070556 PLEASE SAVE THESE INSTRUCTIONS WARNING READ THIS OWNER S MANUAL CAREFULLY BEFORE USE INTRODUCTION Thank you for choosing a Soleus Air Water Cooler This owner s manual will provide you with valuable information necessary for the proper care and maintenance of your new product If properly maintained your Soleus Air Water Cooler will give you many years of trouble free operation Please take a few moments and read the instructions thoroughly and familiarize yourself with all the operational aspects of this water cooler For your own records please attach a copy of your sales receipt to this manual Also write the store name location date purchased and serial number below Serial Number Date of Purchase Store Name Location IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances basic safety precautions should be followed to reduce the risk of fire electric shock and injury to persons or property Read all instructions before using any appliance l 10 11 12 Do not let hot water touch bare skin Keep combustible material such as furniture bedding pillows clothes and or papers away from the back of the unit Do not operate this or any other appliance with a damaged power cord No other appliance should be plugged into the same outlet Be sure that the plug is fully inserted into the
3. D IN NO EVENT SHALL SOLEUS INTERNATIONAL INC S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS UNIT As some states do not allow the limitation or exclusion of incidental or consequential damages or do not allow limitation on implied warranties the above limitations and exclusions may not apply to you This warranty gives you specific legal rights and you may also have other rights that vary from state to state For Warranty Technical Support Customer Service Missing or Defective Parts Please Call 888 876 5387 Or Write To Soleus International Inc 945 Telstar Ave El Monte CA 91731 USA www soleusair com
4. erse the unit in water when cleaning The water bottle cap hose and drip tray may be washed in a dishwasher Keep the water cooler 6 inches 15cm away from the wall so it can work properly Make certain all ventilation openings are clear of obstruction Do not damage the heating or cooling system paying particular attention to the black condenser or heat radiator on the back of the water cooler If you will not use the water cooler for a long period of time please unplug the power cord and drain the water cooler Drain the water from all faucets then remove the drain cap on back and allow it to drain Make certain the drain cap is fastened tightly when finished SPECIFICATIONS Model MW 59 Power Supply 115V 60Hz Electrical Rating 6 3A Refrigerant and Quantity R134a 37g Design Pressure High Side 188psig Design Pressure Low Side 88psig Dimensions 17 8 W x 13 9 D x 41 3 H TROUBLESHOOTING Please check the troubleshooting chart below It includes several common problems which you can correct at home making a customer service call unnecessary Problem Possible Cause Remedy Unit does not dispense hot and cold water Unit is unplugged Plug the power cord into an outlet Main power supply is off Reestablish main power supply The hose cap is not attached properly to the connector on the water cooler Connect properly There will be a give when the ho
5. ight turns on when the water bottle is empty Drip Tray Lower Cabinet Door Water Bottle Cap with Hose Water Bottle not included Tray with Wheel Cold Water Faucet blue color Tepid Water Faucet white color dispenses room temperature water Hot Water Faucet red color includes child safety faucet squeeze two levers together and push down to operate UNPACKING THE WATER COOLER Cut and remove the straps from the box DO NOT turn the box upside down or lay it on its side The bottom of the box is separate from the top section Lift straight up on the top box section to remove the top box section Remove the Styrofoam packaging and plastic bag Lift the water cooler off the bottom of the box Wipe it clean if necessary 2 Place the machine on a hard flat surface Make certain the unit is level The unit should not be close to direct sunlight or other source of heat 3 Itis best to place the water cooler in an area with good air circulation Make sure there is at least 4 inches 10cm of space between the back of your water cooler and the wall Keep a minimum distance of 2 inches 5cm on each side of your water cooler WARNING The drain cap on the back of the unit may become loose during shipping Fasten the drain cap tightly before you start to operate the unit If the drain cap is loose the unit may leak and cause floor damage PREPARING THE WATER COOLER FOR USE The Aqua Sub is different from a tradit
6. ing the unit If the water tank is not full no water will dispense from the tepid water faucet and the hot water faucet NOTE The second time the water bottle is changed after the light on the front panel is on switch RESET to OFF for 3 seconds OPERATION After the water bottle has been connected to the water cooler the unit is ready for use Turn the power switch on the back of the unit to ON The water cooler will start running First the unit will pump the water from the water bottle into the cooling and heating tanks and then the unit s compressor and heater will start to operate The first time the water cooler is used you will have to wait at least half an hour for hot and cold water When the indicator light on the front panel is on there is no water left in the water bottle The water bottle will need to be replaced Replace the water bottle and then press the RESET button located on the backside of the unit The water cooler will work again and the indicator light will be off CLEANING AND MAINTAINENCE To avoid accidents turn off and unplug the water cooler from the outlet before cleaning A soft damp cloth may be used to clean the surface of the water cooler When necessary a mild detergent may be used DO NOT use erosive chemical solvents to clean the unit as this may damage the surface of the water cooler DO NOT pour water on the exterior of the unit to avoid getting the internal electrical system damp DO NOT imm
7. ional water cooler The water bottle does not need to be placed upside down on the top of the unit The water bottle is placed in the lower cabinet of the unit and then a pump draws the water up to the dispenser Figure 1 1 Make sure the water dispenser is not plugged into an electrical outlet 2 Open the door of the lower cabinet and pull the tray out from the cabinet 3 Place a full water bottle on the tray Remove the plastic cover over the mouth of the water bottle 4 Putthe hose inside the water bottle and place the water bottle cap firmly over the mouth of the water bottle Figure 1 5 Push the tray inside the cabinet of the water cooler Attach the hose to the water cooler by pressing in on the knob of the hose cap and sliding over the connector at the top of the cabinet Push up firmly to assure the connection is tight Figure 2 6 Close the lower cabinet door 7 Plug the water cooler into a grounded power outlet and turn on the power switch located on the back 8 The unit will start to operate but you should wait at least half an hour before using the water cooler NOTE If there is not a secure connection between the hose cap and the connector on the water cooler the water pump will operate but the water cooler will not dispense water Make sure the hose is connected to the water cooler correctly NOTE Please wait until the water pump stops running before us
8. outlet Do not run the power cord over carpeting or other heat insulators Do not cover the cord Keep cord away from high traffic areas and do not submerge in water We do not recommend the use of extension cord as it may overheat and cause a risk of fire Exercise caution and use reasonable supervision when the appliance is used by or near children Do not use your water dispenser outdoors Place the water dispenser away from direct sunlight and make sure that there is at least 4 inches 10cm of space between the back of your unit and wall Keep a minimum of 2 inches 5cm on each side of your unit free Do not use this product to dispense anything other than water To avoid a hazard due to instability of the appliance it must be placed on even and flat surface If the supply cord is damaged the manufacturer or its service agent or a similarly qualified person must replace it in order to avoid a hazard This water cooler must be positioned so that the plug is accessible Disconnect the plug from the outlet when not in use Remove power plug or disconnect from the main power source before servicing the appliance PRODUCT DIAGRAM Top Cover Power Switch located on back used to power on off the unit Reset Button located on back press to restart the unit after replacing the water bottle Built in Handle one located on each side Condenser located on back do not touch hot during operation Indicator L
9. se cap slides properly over the connector Unit does not dispense cold water The cold water thermostat is Over consumption of cold water in a short time Adjust the thermostat set at too high a temperature Wait a moment for the water to cool The ventilation around the unit is insufficient The temperature of water in the water bottle is too high When the bottle is exposed to direct sunlight for a long time Space the unit from the wall by more than 15 cm Place the water bottle in a cool location out of direct sunlight Unit does not dispense hot water Over consumption of hot water in a short time Wait a moment for the water to heat Unit is noisy during operation The appliance is not level Place the unit on a level flat surface Unit is touching other objects Move the unit away from other objects Water leaks from the faucet The top portion of the faucet has become loose The faucet has been damaged Tighten the top threaded portion of the faucet Call the customer service telephone number to repair the faucet The bottle may have small pinholes Replace with a new water bottle Water is dripping out of the water cooler and onto the floor The drain cap on the back is not fastened properly Tighten the drain cap If the sealing silicon material inside the drain cap is torn or damaged then replace with a new one
Download Pdf Manuals
Related Search