Smeg KSEC6 User's Manual
Contents
1. If the supply cord is damaged it must be replaced by a special cord or assembly available from the manufacturer or its service agent INSTALLATION 2 INSTALLATION INSTRUCTIONS 2 1 2 2 a Some installation systems require the opening and removal of the metal grille panel Instructions for opening and removing the metal grille panel To open the grille panel press inwardly on the two slider catches at each side of the grille panel and the grille will pivot down To remove the metal grille pull forward on the right hand side so that the hinge pin on the back of the grille will be released from the slot in the side of the casing Wall cabinet fixing Predrilled wall cabinet fix the hood onto the wall cabinet base panel using the four screws 4 2 x 45 mm supplied with the fixing kit It is not necessary to open the metal grille b No predrilled wall cabinet b 1 If the hood is provided with a paper fixing template follow the instructions b 2 If the hood is not provided with a paper fixing template position the hood on the wall cabinet base panel and pilot drill the 3 5 x 16 mm screws not supplied with the fixing kit from the inside onto the wood Wall mounting Drill two 8 mm holes on the wall using the paper template insert two rawl plugs and two 4 2 x 44 4 mm screws leaving 5 mm untightened Open the metal grille panel hook the hood on and fully tighten the screws If the hood is not provided w2. ese Omeg Libretto di Istruzioni Instructions Manual Manuel d Instructions Bedienungsanleitung Gebruiksaanwijzing KSEC6 Instructions Manual GENERAL INFORMATION SAFETY WARNINGS lai 10 INSTALLATION Rea aa aa ete testo arl Ua 11 USES MAINTENANCE creo 12 GENERAL INFORMATION SAFETY WARNINGS GENERAL INFORMATION This canopy hood 15 designed to be fixed to any rigid vertical surface over a gas or electric hotplate and can be used either in the extraction mode ducted to the outside or in the recircu lation mode internal recycling All cookers hood perform better when used in evacuation mode During winter time it may be convenient to use the hood in the recycling mode to avoid heat loss from the kitchen Before starting the installation consideration should be given to the difficulties to be found dur ing installation The installation work must be undertaken by a qualified and competent person in conformity to the rules concerning the evacuation of contaminated air The manufacturer disclaims all liability for any damage or injury caused as a result of not follow ing the instructions for installation contained in the following text 1 SAFETY WARNINGS 1 1 12 1 3 1 4 1 5 1 6 17 18 19 1 10 1 11 1 12 When used in the extraction mode the cooker hood ducting must not be connected to a flue which is used for exhausting fumes from appliances supplied with energy
3. le produit Das Symbol A auf dem Produkt oder seiner Verpackung weist darauf hin dass dieses Produkt nicht als normaler Haushaltsabfall zu behandeln ist sondern an einem Sammelpunkt f r das Recycling von elektrischen und elektronischen Ger ten abgegeben werden muss Durch Ihren Beitrag zum korrekten E ntsorgen dieses Produkts schutzen Sie die Umwelt und die Gesundheit Ihrer Mitmenschen Umwelt und Gesundheit werden durch falsches Entsorgen gefahrdet Weitere Informationen Uber das Recycling dieses Produkts erhalten Sie von Ihrem Rathaus Ihrer M llabfuhr oder dem Geschaft in dem Sie das Produkt gekauft haben Het symbool A op het product of op de verpakking wijst erop dat dit product niet als huishoudafval mag worden behandeld Het moet echter naar een plaats worden gebracht waar elektrische en elektronische apparatuur wordt gerecycled Als u ervoor zorgt dat dit product op de correcte manier wordt verwijderd voorkomt u mogelijk voor mens en milieu negatieve gevolgen die zich zouden kunnen voordoen in geval van verkeerde afvalbehandeling Voor meer details in verband met het recyclen van dit product neemt u het best contact op met de gemeentelijke instanties het bedrijf of de dienst belast met de verwijdering van huishoudafval of de winkel waar u het product hebt gekocht 436003294 verl
4. other than electric such as a central heating flue or water heating flue Before connecting to the mains supply ensure that the mains voltage corresponds with the volt age on the rating plate inside the hood Connect the cooker hood to the mains via a bipolar switch which has 3mm clearance between the contacts For cooker hoods featuring an earth cable make sure the electric plant of your house is cor rectly earthed Appliance in class Il are provided with a double insulation therefore do not connect then through earthed plugs but through simple bipolar plugs When installed the hood must be positioned at least 65cm above the hotplate Never do flamb cooking under this cooker hood Never leave frying pans unattended during use as overheated fat and oil may catch fire Before carrying out any kind of maintenance or cleaning disconnect the hood from the mains Supply If the room where the cooker hood is to be used contains a fuel burning appliance such as a cen tral heating boiler then this must be of the room sealed or balanced flue type If other types of flue or appliance are fitted ensure that there is an adequate supply of air into the room When the cooker hood is used in conjunction with appliances supplied with energy other than electric the negative pressure in the room must not exceed 0 04 mbar to prevent fumes being drawn back into the room by the cooker hood The appliance must be positioned so that the plug is accessible
5. e clips to one side and removing b Thin synthetic filter 1 mm thick It should not be washed and should be replaced every two months If the filter is provided with a saturation indicator replace when b 1 The violet colour of the dots which are visible through the metal grille is spread over the whole surface of the filter b 2 The red colour of the stripes which is not visible through the metal grille when the filter is clean becomes visible from the outside of the metal grille c Multi layer metal filter It should be washed once a month in hot water using mild detergent or liquid soap It can be washed in a dish washer It should not be bent and should be left to drain dry WARNING An excess of grease in the filter not only would affect the performance of the hood but it is also a possible fire risk We strongly recommend therefore to clean and replace filters in accordance with the manufacturer instructions Cleaning Metal self supporting Grease Filters The filters are washable and must be cleaned at least every 2 months of operation or more frequently for particularly heavy usage e Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time e Wash the filters taking care not to bend them Allow them to dry before refitting When refitting the filters make sure that the handle is visible on the outside Charcoal filter The charcoal filter is a chemical filter to be used
6. ith a paper fixing template drill two 8 mm holes see draw insert the plugs and screws proceeding as directed under paragraph a For wall mounting using wallbrackets optional follow the instructions of the fixing tem plate Pay attention to the safety regulation of point 1 6 Choice of operating mode Evacuation mode To check that the hood is set up for evacuation open the grille panel and make sure that the conversion lever or the change over knob on the centrifugal unit is in the DUCTING position The charcoal filter is not required For ducting to the outside the hood is supplied with a rear and top outlet A flange spigot of 100 mm diameter 120 mm in certain models is usually fitted on the top outlet and a blanking plug on the rear outlet If you choose to duct the hood from the rear of the casing you should invert the position of the flange and of the blanking plug Pay attention to the safety regulation 1 1 Internal recirculation mode To check that the hood is set up for recycling open the grille panel and make sure that the conversion lever or the change over knob on the centrifugal unit is in the RECYCLING po sition The charcoal filter is to be fitted To fit the charcoal filter support the filter with one hand and turn the thumb screw through the centre of the charcoal filter If the filter is of the interlocking type turn the filter clockwise The hood can remain connected to the outside Electrical connec
7. only when the hood is in the recycling position To re place the charcoal filter open the grille and remove the thumb screw through the centre of the charcoal filter If the filter is of the interlocking type turn the filter anticlockwise Replace by reversing the opera tion For a good performance replace the charcoal filter on average every three months Worktop illumination If a lamp fails to function at any time open the metal grille panel and check that the lamp is fully screwed into the holder When changing the lamp an identical replacement must be fitted to ensure a Safe working of the hood Cleaning The metal work should be cleaned regularly at least once a month using mild household cleaner and polish Never use abrasives For all operations from point 4 1 to point 4 4 and in particular for point 4 3 pay special attention to the safety regulation 1 9 CE Dir 89 336 CEE 73 23 CEE 93 68 CEE Il simbolo A sul prodotto o sulla confezione indica che il prodotto non deve essere considerato come un normale rifiuto domestico ma deve essere portato nel punto di raccolta appropriato per il riciclaggio di apparecchiature elettriche ed elettroniche Provvedendo a smaltire questo prodotto in modo appropriato si contribuisce a evitare potenziali conseguenze negative per l ambiente e per la salute che potrebbero derivare da uno smaltimento inadeguato del prodotto P er informazioni pi dettagliate sul riciclaggio di questo prodotto con
8. tattare l ufficio comunale il servizio locale di smaltimento rifiuti o il negozio in cui stato acquistato il prodotto The symbol R on the product or on its packaging indicates that this product may not be treated as household waste Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health which could oth erwise be caused by inappropriate waste handling of this product For more detailed information about recycling of this product please contact your local city office your household waste disposal service or the shop where you purchased the product Le symbole A sur le produit ou son emballage indique que ce produit ne peut tre trait comme d chet m nager Il doit plut t tre remis au point de ramassage concern se chargeant du recyclage du mat riel lectrique et lectronique En vous assurant que ce produit est limin correctement vous favorisez la pr vention des cons quences n gatives pour l environnement et la sant humaine qui sinon seraient le r sultat d un traitement inappropri des d chets de ce produit Pour obtenir plus de d tails sur le recyclage de ce produit veuillez prendre contact avec le bureau municipal de votre r gion votre service d limination des d chets m nagers ou le magasin o vous avez achet
9. tion and working test The safety measures 1 2 1 3 1 4 and 1 5 of paragraph 1 are to be strictly observed Once the electrical connection has been completed check that the worktop illumination motor and speeds work properly USE MAINTENANCE 3 OPERATION 3 1 Controls are located on the right hand side of the front to operate worktop illumination and select the most suitable working speed for your cooking To increase the area of extraction the glass visor should be pulled open The top speed should be used when frying or cooking foods with strong odours while a lower speed can be used for normal cooking To obtain the best performance from your hood turn it on before you start cooking and leave it running for a few minutes after your cooking is over to clear the air 3 2 Pay attention to safety regulations 1 7 and 1 8 4 MAINTENANCE AND CLEANING 41 4 2 4 3 44 4 5 Regular maintenance and cleaning will ensure good performance and reliability while extending the working life of the hood Special attention should be reserved to the grease filter and to the charcoal fil ter recycling mode Grease filter This retains the solid grease particles and can be supplied in different types It is fitted onto the reverse side of the metal grille panel Maintenance of the grease filter varies according to the used type a Whatever type of filters used the filter is easily removed from the grille by pushing the metal wir
Download Pdf Manuals
Related Search