Sears 42-34714 User's Manual
Contents
1. INSTALLATION INSTRUCTIONS Stock No 42 34713 42 34714 42 34715 Faucet TO ASSEMBLE FAUCET 1 If not already assembled install the escutcheon rubber washer spacer flat washer and hex nut onto the threaded faucet stud 2 Turn the tubing adapter onto the stud and hand tighten then wrench 1 4 turn only BE CAREFUL NOT TO CROSS THREAD 3 CONNECT TUBING TO FAUCET AS FOLLOWS Note For ease of tubing attachment feed the tubing through the mounting hole and attach to faucet above the counter a Take the separate length of 3 8 black tubing put an end through the hole in the rubber washer Slide the end onto the larger barb fitting on the bottom of the faucet Note To soften end of tubing hold under hot water b Route 1 4 red tubing from RO up through the sink hole and slide end onto the smaller barb fitting heat end if needed on the faucet c Route 3 8 blue tubing from RO up through the sink hole and connect to the push in tubing adapter fitting on the bottom of the faucet Be sure it is held firmly in the adapter fitting See your owners manual for tubing connection instructions 4 Lower the faucet into the sink or countertop hole 5 On the underside of the sink or countertop insert the large steel washer between the mounting hole and the spacer on the faucet stud see assembled view Then turn the hex nut up to the spacer and tighten Tighten the hex nut so the faucet cannot move bu2. t do not overtighten and break the faucet 6 Wet the o ring seals on the faucet spout Then remove and discard the short piece of tubing from the faucet body and insert the spout in its place Hex Nut Insert Spout Remove Faucet amp Tubing Piece a Spout rl Tubing Barb Fittings Escutcheon Plumber s D Rubber Putty Washer ASSEMBLED IN Steel MOUNTING HOLE Rubber Spacer ye Washer a E Hex Nut Washer Tubing Adapter 1 4 Red Tubing from 3 8 Black Tubing _ gt Drain Point to Drain Point 3 8 Blue TUBING FROM Tubing RO SYSTEM Installation Questions Call 1 800 426 9345 7254715 Rev B 9 19 07
Download Pdf Manuals
Related Search