Sanyo TRC9010 User's Manual
Contents
1. SANYO Memo Scriber Operating Instructions CONTROLS 0 om 4 eo N es ae Ne aga 19 1 Cassette compartment 11 BACKSPACE control 2 REW rewind button 12 SPEED control 3 STOP button 13 SEARCH ON OFF button 4 RESET button 14 POWER switch 5 FOOT CONTROL receptacle 15 SPKR ON OFF speaker button 6 COUNTER tape counter 16 PLAY button 7 EAR eraphone jack 17 EJECT knob 8 TONE control 18 FFWD fast forward button 9 ERASE button 19 Foot control 10 VOLUME control 20 Headset 18 17 16 15 14 13 12 11 10 Preparation for Use 1 3 4 Plug the power cord into any standard 120 volt AC outlet and press the POWER switch The POWER in dicator will light Slide the EJECT knob in the direction of the arrow or facing you Insert recorded cassette with the full reel to the left and side to be played up Plug the Foot control into its receptacle on the lower left side of the unit with the cord running toward the rear of the unit Plug the headset into EAR jack then push the SPKR ON OFF button to disconnect the built in speaker Now you are ready to begin transcription Transcription 1 To begin transcription press the right side of the Foot control marked PLAY and adjust the VOLUME TONE SPEED and BACKSPACE controls to the desired level P2. nds when the end of the tape is reached in all operating modes Maintenance CAUTION For your personal safety be sure to disconnect the AC line cord before you proceed with cleaning the machine Head Cleaning To assure continued high performance periodically clean the heads the pinch roller and the capstan whenever dust and red brown oxide particles have accumulated These particles may be removed with a cotton swab mois tened in isopropyl alcohol or special head cleaning fluid To do this properly slide the EJECT knob toward you The cassette compartment lid will open Carefully rub the face of the heads and also the surface of the capstan and the pinch roller Heads Capstan Pinch Roller Cabinet Cieaning Be ae areas Use a clean soft cloth moistened with plain lukewarm water Never use benzol benzine alcohol or other strong chemical cleaners since these could damage the finish of your unit It is important that no liquid penetrates inside the unit 1426 4119 31620 SANYO ELECTRIC CO LTD Osaka Japan Model TRC9010 REV 0 Printed in Japan
3. ress the FFWD button then press the STOP button when a beep tone is heard The unit will automatically have scanned to the note or correction Listen to the note or correction then rewind the tape to the original portion on the tape Should you wish to review dictation release pressure on the right side marked PLAY of the Foot control and depress it again By doing this the tape will automati cally backspace according to where the auto back space control on the unit will allow you to adjust this automatic backspace feature for your convenience For longer review of dictation press the left side marked BACK of the Foot control and the tape will backspace continuously until the Foot control is released To pause release the pressure on the right side of the Foot control Continue in this start and stop method until the transcription is completed After transcription has been completed the cassette can be erased by simultaneously pressing both REW and ERASE buttons When the end of the tape is reached while erasing a beep tone will be heard Then press the STOP to stop erasing Forward erasing can also be made by pressing both FFWD and ERASE buttons To turn the unit OFF depress the POWER switch and release Warning Beep Tone A warning beep tone will be heard in the following cases 1 No cassette warning A beep tone sounds if there is no cassette in operating mode End of tape warning A beep tone sou
Download Pdf Manuals
Related Search