Sanus Systems TV13 User's Manual
Contents
1. R Kit TV VCR Kit will not work with the TV13 Turntable TV Turntable sold separate Contents 1 Base 2 Support Pillars 4 Plastic Dowels Support 4 Allen bolts Pillar Support 1 Allen Wrench Pillar Base Sanus Systems 2221 Highway 36 W St Paul MN 55113 800 359 5520 www sanus com 7 6 04 Step 1 Remove the swivel from the TV Turntable by removing the Phillips Screw in the center of the swivel as shown in the Dia gram to the right Step 2 Use the same Phillips Screw removed from Step to fasten the swivel to the base of the TV VCR Kit Insert the Phillips screw through the center hole of the swivel and proceed to thread it into the appropriate pilot hole in the center of the TV VCR Kit as shown in the Diagram on the right Tighten the Phillips Screw with a phillips screw driver until tight NOTE When using the TV 20 use the front Pilot Hole When Using the TV27 or TV32 use the rear Pilot Hole Step 3 Insert the Plastic Dowels into the larger holes in the Support Pillar as shown in the Diagram on the right Gently tap the Plas tic Dowels in with a hammer if needed Repeat step for the other Support Pillar Step 4 Thread the Allen Bolts up through the Base of the TV VCR Kit and into the corresponding holes in the Support Pillar Tighten Allen Bolts with the provided Allen Key until they are tight Step 5 Add the TV Turntable to the TV VCR Kit by setting the Turn table on top of the Support Pi2. SAN US S YSTEMS THE UNION OF FORM AND FUNCTION Assembly Instructions for Television Turntables TV13 TV20 TV27 TV32 Congratulations on your purchase Sanus Systems Television Turntables are functional attractive and inexpensive They are finished with a black powder that is both durable and beautiful Please check carefully to make sure there are no miss ing or defective parts Never use defective parts Improper assembly may cause damage or injury If you do not understand these directions or have any questions about this assembly please contact Sanus at 800 359 5520 or www sanus com We can quickly assist you with installation questions and missing or damaged parts Supplied Parts 1 Television Turntable 1 Self Adhesive Protective Feet pad of 4 Diagram 1 Step 1 T Circle Adhesive 7 Position the Turntable so the black nylon swivel is facing Foot i up Locate the circles at the end of each spoke Next place a Adhesive Foot inside each circle as shown in Diagram 1 Bottom of Turntable NOTE If you are going to use the optional TV VCR Kit Proceed to the instructions for those at the bottom of the page otherwise proceed to Step 2 Diagram 2 Step 2 Top of Turntable Flip the Turntable over and place it in the desired position on a shelf or cabinet so the Adhesive Feet are facing down and are in direct contact with the shelf or cabinet as shown in Diagram 2 Assembly Instructions for Optional TV VC
3. llars so the dowels in the Support Pillars line up with the holes in the bottom side of the turntable Press the Turntable down firmly until the bottom of the Turn table is flush with the top of the Support Pillars Support Pillar Bottom of Turntable n ATNI E gt T Rear Pilot Hole Front Pilot Hole Plastic Dowels l BS Nylon Swivel is Allen Bolts Located on the Bottom Top of TV Turntable Plastic Dowel Front of Assembl Sanus Systems 2221 Highway 36 W St Paul MN 55113 800 359 5520 www sanus com 7 6 04
Download Pdf Manuals
Related Search