RIDGID R85009 User's Manual
Contents
1. full to zero and recharging the battery is required TO CHARGE A fully discharged battery pack with a temperature between 32 F 0 C and 150 F 65 C will charge in about an hour E Charge the 24 Volt lithium ion battery pack only with the charger provided E Connect the charger to a power supply NOTE If needed the charger can operate with most generators and inverters rated at 300 Watts or higher E Attach the battery pack to the charger by aligning the raised ribs on the battery pack with the grooves in the charger then slide the battery pack onto the charger See Figure 2 E Do not place the charger in an area of extreme heat or cold It will work best at normal room temperature E After charging is complete the continuous green light will come on and the charge level indicator lights on the battery will go off E The charger will keep the battery pack fully charged if left on the charger CHARGE LEVEL INDICATOR 24wXlL CHARGING A HOT BATTERY PACK If the battery pack is above normal temperature range the red LED will begin flashing and the green LED will be off When the battery pack cools down to approximately 150 F 65 C the charger will automatically begin fast charge mode NOTE Refer to CHARGING THE BATTERY PACK for normal recharging of batteries If the charger does not charge the battery pack under normal circumstances return both the battery pack and charger to your nearest repair center for el2. ICATOR EVALUATE INDICATOR DEFECTIVE INDICATOR RED GREEN LED LED N OFF Charging Fast charging Flashing Flashing ACTION Charges in 1 hour Charger pre charges battery until normal voltage is reached then begins fast charge mode May take longer than 1 hour to fully charge Fast charging is complete Charger maintains charge mode When battery pack reaches cooled temperature charger begins fast charge mode When battery pack reaches warmed temperature charger begins fast charge mode Battery pack or charger is defective FULL 3 4 CAPACITY CAPACITY 1 2 CAPACITY CHARGE LEVEL INDICATOR BUTTON 1 4 CAPACITY CHARGE LEVEL INDICATOR Fig 4 CHARGE LEVEL INDICATOR See Figure 4 The charge level indicator shows that the battery is charged at 1 4 1 2 3 4 or full capacity To display the amount of charge left in the battery press and hold the charge level indicator button NOTE When the battery pack contains less than 10 charge the 1 4 charge level indicator will flash MAINTENANCE A WARNING When servicing use only identical RIDGID replacement parts Use of any other parts may create a hazard or cause product damage A WARNING Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust If operation is dusty also wear a dust mask A WARNING To avoid serious personal injury always remove the battery pack from the tool whe
3. OPERATOR S MANUAL 24 VOLT LITHIUM ION BATTERY CHARGER 140315001 R85009 BATTERIES SOLD SEPARATELY NEW BATTERY PACKS MUST BE CHARGED BEFORE FIRST USE RIDGID Your charger has been engineered and manufactured to our high standards for dependability ease of operation and operator safety When properly cared for it will give you years of rugged trouble free performance A WARNING To reduce the risk of injury the user must read and understand the operator s manual before using this product Thank you for buying a RIDGID product SAVE THIS MANUAL FOR FUTURE REFERENCE IMPORTANT SAFETY INSTRUCTIONS A WARNING READ AND UNDERSTAND ALL INSTRUCTIONS Failure to follow all instructions listed below may result in electric shock fire and or serious personal injury E Before using charger read all instructions and cautionary markings in this manual on charger battery and product using battery to prevent misuse of the products and possible injury or damage A CAUTION To reduce the risk of electric shock or damage to the charger and battery charge only lithium ion rechargeable batteries as specifically designated in this manual Other types of batteries may burst causing personal injury or damage E Do not use charger outdoors or expose to wet or damp conditions Water entering charger will increase the risk of electric shock E Use of an attachment not recommended or sold by the charger manuf
4. acturer may result in a risk of fire electric shock or injury to persons Following this rule will reduce the risk of electric shock fire or serious personal injury E Do not abuse cord or charger Never use the cord to carry the charger Do not pull the charger cord rather than the plug when disconnecting from receptacle Damage to the cord or charger could occur and create an electric shock hazard Replace damaged cords immediately E Make sure cord is located so that it will not be stepped on tripped over come in contact with sharp edges or moving parts or otherwise subjected to damage or stress This will reduce the risk of accidental falls which could cause injury and damage to the cord which could result in electric shock Keep cord and charger from heat to prevent damage to housing or internal parts Do not let gasoline oils petroleum based products etc come in contact with plastic parts They contain chemicals that can damage weaken or destroy plastic Do not crush drop or damage battery pack Do not use a battery pack or charger that has been dropped run over received a sharp blow or damaged in any way A damaged battery is subject to explosion Properly dispose of a dropped or damaged battery immediately Do not operate charger with a damaged cord or plug which could cause shorting and electric shock If damaged have the charger replaced by an authorized serviceman Do not operate charger if it has r
5. dated sales receipt The authorized service center will repair any faulty workmanship and either repair or replace any part covered under the warranty at our option at no charge to you WHAT IS NOT COVERED This warranty applies only to the original purchaser at retail and may not be transferred This warranty only covers defects arising under normal usage and does not cover any malfunction failure or defect resulting from misuse abuse neglect alteration modification or repair by other than an authorized service center for RIDGID branded hand held and stationary power tools Consumable accessories provided with the tool such as but not limited to blades bits and sand paper are not covered RIDGID INC AND ONE WORLD TECHNOLOGIES INC MAKE NO WARRANTIES REPRESENTATIONS OR PROMISES AS TO THE QUALITY OR PERFORMANCE OF ITS POWER TOOLS OTHER THAN THOSE SPECIFI CALLY STATED IN THIS WARRANTY ADDITIONAL LIMITATIONS To the extent permitted by applicable law all implied warranties including warranties of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE are disclaimed Any implied warranties including warranties of merchant ability or fitness for a particular purpose that cannot be disclaimed under state law are limited to three years from the date of purchase One World Technologies Inc and RIDGID Inc are not responsible for direct indirect incidental or consequential damages Some states do not allow limitations on ho
6. eceived a sharp blow been dropped or otherwise damaged in any way Take it to an authorized serviceman for electrical check to determine if the charger is in good working order Do not disassemble charger Take it to an authorized serviceman when service or repair is required Incorrect reassembly may result in a risk of electric shock or fire Unplug charger from outlet before attempting any maintenance or cleaning to reduce the risk of electric shock Disconnect charger from the power supply when not in use This will reduce the risk of electric shock or damage to the charger if metal items should fall into the opening It also will help prevent damage to the charger during a power surge Risk of electric shock Do not touch uninsulated portion of output connector or uninsulated battery terminal Save these instructions Refer to them frequently and use them to instruct others who may use this tool If you loan someone this tool loan them these instructions also to prevent misuse of the product and possible injury IMPORTANT SAFETY INSTRUCTIONS 1 SAVE THESE INSTRUCTIONS This manual contains important safety and operating instructions for the charger part number 140315001 2 Before using charger read all instructions and cautionary markings on charger battery and product using battery 3 CAUTION To reduce the risk of injury charge only lithium ion rechargeable batteries Other types of batteries may burst causin
7. ectrical check For the location of your nearest repair center please call 1 866 539 1710 CHARGING A COOL BATTERY PACK If the battery pack is below normal temperature range the red LED will begin flashing and the green LED will be off When the battery warms to a temperature of more than 14 F 10 C the charger will automatically begin charging COLD WEATHER OPERATION The lithium ion battery pack can be used in temperatures down to 4 F 20 C When the battery pack is very cold it may buzz for the first minute of use to warm itself up Put the battery pack on a tool and use the tool in a light duty application After about a minute the pack will have warmed itself up and begin operating normally OPERATION LED FUNCTION OF CHARGER See Figure 3 LED INDICATOR BATTERY PACK Charging En charge Cargando Charging Deeply Discharged Full l Charge max Full Maintenance Completo charging Hot battery pack Cold battery pack e f defective try to repeat the conditions a second time by removing and reinstalling the battery pack If the LED status repeats a second time try charging a different battery e f a different battery charges normally dispose of the defective pack see Maintenance section e f a different battery also indicates Defective the charger may be defective Evaluer Evaluar Defective D fectueux Defectuoso RED LED GREEN LED CHARGING INDICATOR FULL IND
8. g personal injury or damage 2 SYMBOLS Some of the following symbols may be used on this tool Please study them and learn their meaning Proper interpretation of these symbols will allow you to operate the tool better and safer SYMBOL NAME DESIGNATION EXPLANATION Wet Conditions Alert Do not expose to rain or use in damp locations Read The Operator s Manual To reduce the risk of injury user must read and understand operator s manual before using this product Always wear safety goggles or safety glasses with side shields and as necessary a full face shield when operating this product Safety Alert Precautions that involve your safety Eye Protection FEATURES PRODUCT SPECIFICATIONS Charger VOMAGG cs tesesseedetege cee cveden ras eR ER ERA EE e EE 24 Volt DC Charger INPUT parasaan a aaiae aa a back a N ve AAE UE aE E E EEUN ENEE 120 V 60 Hz AC only Gare Rate E E bec eb beue saeedee toes E E ieee eed Gane A E eee 1 hour E 4 1 8 in KEY HOLE CHARGER HANGER Fig 1 KNOW YOUR CHARGER KEY HOLE HANGER See Figure 1 The charger has a key hole hanging feature for convenient The safe use of this product requires an understanding of space saving storage Screws should be installed so that the information on the tool and in this operator s manual as the center distance is 4 1 8 in well as a knowledge of the project you are attempting Before use of this product familiarize yourself
9. low 80 F and away from moisture E Store battery packs in a 30 50 charged condition E Every six months of storage charge the pack as nor mal BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING To preserve natural resources please recycle or dispose of batteries properly This product contains lithium ion batteries Local state or federal laws may prohibit disposal of lithium ion batteries in ordinary trash Consult your local waste authority for information regarding available recycling and or disposal options A WARNING Upon removal cover the battery pack s terminals with heavy duty adhesive tape Do not attempt to destroy or disassemble battery pack or remove any of its components Lithium ion batteries must be recycled or disposed of properly Also never touch both terminals with metal objects and or body parts as short circuit may result Keep away from children Failure to comply with these warnings could result in fire and or serious injury WARRANTY RIDGID HAND HELD AND STATIONARY POWER TOOL 3 YEAR LIMITED SERVICE WARRANTY Proof of purchase must be presented when requesting warranty service Limited to RIDGID hand held and stationary power tools purchased 2 1 04 and after This product is manufactured by One World Technologies Inc The trademark is licensed from RIDGID Inc All warranty communications should be directed to One World Technologies Inc attn RIDGID Hand Held and Statio
10. n cleaning or performing any maintenance GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use Use clean cloths to remove dirt dust oil grease etc A WARNING Do not at any time let brake fluids gasoline petroleum based products penetrating oils etc come in contact with plastic parts Chemicals can damage weaken or destroy plastic which may result in serious personal injury Only the parts shown on the parts list are intended to be repaired or replaced by the customer All other parts should be replaced at a RIDGID authorized service center BATTERIES The battery pack for this tool is equipped with lithium ion rechargeable batteries Length of service from each charging will depend on the type of work you are doing The batteries in this tool have been designed to provide maximum trouble free life However like all batteries they will eventually wear out Do not disassemble battery pack and attempt to replace the batteries Handling of these batteries especially when wearing rings and jewelry could result in a serious burn To obtain the longest possible battery life we suggest the following E Remove the battery pack from the charger once it is fully charged and ready for use For battery pack storage longer than 30 days E Store the battery pack where the temperature is be
11. nary Power Tool Technical Service at toll free 1 866 539 1710 90 DAY SATISFACTION GUARANTEE POLICY During the first 90 days after the date of purchase if you are dissatisfied with the performance of this RIDGID Hand Held and Stationary Power Tool for any reason you may return the tool to the dealer from which it was purchased for a full refund or exchange To receive a replacement tool you must present proof of purchase and return all original equipment packaged with the original product The replacement tool will be covered by the limited warranty for the balance of the 3 YEAR service warranty period WHAT IS COVERED UNDER THE 3 YEAR LIMITED SERVICE WARRANTY This warranty on RIDGID Hand Held and Stationary Power Tools covers all defects in workmanship or materials and normal wear items such as brushes chucks motors switch es cords gears and even cordless batteries in this RIDGID tool for three years following the purchase date of the tool Warranties for other RIDGID products may vary HOW TO OBTAIN SERVICE To obtain service for this RIDGID tool you must return it freight prepaid or take it in to an authorized service center for RIDGID branded hand held and stationary power tools You may obtain the location of the authorized service cen ter nearest you by calling toll free 1 866 539 1710 or by logging on to the RIDGID website at www ridgid com When requesting warranty service you must present the original
12. w long an implied warranty lasts and or do not allow the exclusion or limitation of incidental or consequential damages so the above limitations may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from state to state One World Technologies Inc Hwy 8 Pickens SC 29671 RIDGID 983000 945 03 06 06 REV 00 OPERATOR S MANUAL 24 VOLT LITHIUM ION BATTERY CHARGER 140315001 R85009 Customer Service Information For parts or service contact your nearest RIDGID authorized service center Be sure to provide all relevant information when you call or visit For the location of the authorized service center nearest you please call 1 866 539 1710 or visit us online at www ridgid com The model number of this tool is found on a plate attached to the bottom of the charger Please record the serial number in the space provided below When order ing repair parts always give the following information Model No ___ 140315001 R85009 Serial No
13. with all operating features and safety rules OPERATION APPLICATIONS You may use this tool for the following purpose E Charging 24 Volt RIDGID lithium ion batteries CAUTION If at any point during the charging process none of the LEDs are lit remove the battery pack from the charger to avoid damaging the product DO NOT insert another battery Return the charger and battery to your nearest service center for service or replacement CAUTION Charge in a well ventilated area Do not block charger vents Keep them clear to allow proper ventilation CHARGING THE BATTERY PACK NOTE New 24 Volt lithium ion battery packs will not work without first being charged Before first time use charge the battery pack to activate it It is not necessary to drain the battery pack completely before recharging Lithium ion battery packs have no memory and can be recharged at any time It is therefore possible to charge the battery pack before extended usage even if the battery pack is not completely drained of charge Use the charge level indicator to determine the amount of charge in the battery pack Lithium ion batteries deliver fade free power for their entire run time 24 Volt lithium ion tools will not gradually lose power due to decreasing battery charge Instead power from the battery pack will drop from full to zero once the full charge has been drained from the battery Once this happens your tool s power drops from
Download Pdf Manuals
Related Search