Home
        Pioneer DE-7001 User's Manual
         Contents
1.  702 magneto optical disk and  DEC 502  WORM optical disk     The DE H7101 series optical drives fit into industry standard 5 25 inch half height drive bays  They  conform to ISO 9171 and ISO 10089  Format B  standards for true Write Once and Rewritable media  and are compatible with DE 7001 series multifunction drives  The DE H7101 series support SCSI 2     The 7101 series drives must be set to Mode 0 or Mode 2 when using Rewritable media and to Mode 1 or  Mode 2 when using WORM media  The drives must be set to Mode 2 when used as a SCSI 2 device   The drive mode is determined by the settings of the dip switch bits 4 and 5  The dip switch is located on  the rear of the drives     NOTE  The DE UH7101 has jumper settings instead of a dip switch  The jumper is set by shorting the  pins  Pins 7 and 8 correspond to bits 4 and 5  respectively     NOTE  The bit settings are read by the controller at Power ON and RESET  If the settings of the bits    have changed  the unit must be reset or turned OFF and then ON before the new setting will take place   IMPORTANT  You should only change the bit settings when power to the device is OFF     Page 2of5       Pioneer New Media Technologies  Inc   Engineering Support  310  952 2111       PRO DUCTINFORMATION BULLETIN No  PB  0198          The Modes are set as described in the table below  factory default is Mode 0      OFF OFF Rewritable   Read and write operations are enabled only with ISO  standard  sampled servo format  rewritable disks 
2.  Read and  write operations with WORM disks are disabled   DE   C7001     1 ON OFF WORM Read and write operations are enabled only with ISO  standard  sampled servo  SS  format WORM disks  Read  and write operations with rewritable disks are disabled   SCSI specifications are same as that of DD 5101 series  except DE SH7101 enables RDBC  Read Blank Check  as  default   DD C5001    2 OFF ON SCSI 2 Read and write operations are enabled with both ISO  standard  sampled servo  SS  format  rewritable and  WORM disks  SCSI specifications are based on SCSI 2    DE C7101     IMPORTANT  Because Mode 2 supports both WORM and MO type media as well as SCSI 2  command set  it is recommended that the user use the drive in Mode 2        The 7101 series has a dual color BUSY LED  The meaning of the light indications of the LED is listed in  the table below     Drive Status Rewritable Mode WORM Mode  Mashing green flashing yellow  MO disk present ame yellow    WORM media present fashing   green  BUSY ia yellow       Note  The two colors of the LED are yellow and green  When both colors are lit  the result is orange     DE SH9101   The DE SH9101 is a half height external multifunction optical disk drive subsystem that can handle large  capacity  1 7 GB  utilizing the sampled servo format Multiplexed Address Sampled Servo  MASS    MASS is a high density data recording system     Page 3 of 5       Pioneer New Media Technologies  Inc   Engineering Support  310  952 2111       PRO DUCTINFORMATION 
3.  device is OFF     The Modes are set as described in the table on the next page  factory default is Mode 0      Page 4o0f5       Pioneer New Media Technologies  Inc   Engineering Support  310  952 2111             Rewritable   Read and write operations are enabled only with ISO  standard  sampled servo format  rewritable disks  Read and  write operations with WORM disks are disabled   DE     PRODUCTINFORMATION BULLETIN No  PB  0198  OFF    rp  ee    The DE SH9101 series has a dual color BUSY LED  The meaning of the light indications of the LED is  listed in the table below     Drive Status  no disk inserted flashing green flashing yellow  MO disk present   dim      many yellow    C7001     Bits  WORM Read and write operations are enabled only with ISO  standard  sampled servo  SS  format WORM disks  Read  and write operations with rewritable disks are disabled   SCSI specifications are same as that of DD 5101 series  except DE SH7101 enables RDBC  Read Blank Check  as  default   DD C5001     SCSI 2 Read and write operations are enabled with both ISO  standard  sampled servo  SS  format  rewritable and  WORM disks  SCSI specifications are based on SCSI 2    DE C7101        WORM media present flashing green  BUSY   yellon    overheat orange orange       Note  The two colors of the LED are yellow and green  When both colors are lit  the result is orange     Page 50f5       Pioneer New Media Technologies  Inc   Engineering Support  310  952 2111    
4. BULLETIN No  PB  0198          The DE SH9101 uses both MASS format optical disks and ISO standardized Type B format  SS  optical  disks  MO and WORM   It is upward compatible with the DE SH7101 optical drive     The media types used by the DE SH9101 are the DEC 17GMO rewritable  MO  1 7GB capacity  magneto optical disk  DC 17GWO 1 7 GB capacity WORM  write once read many  optical disk  DEC   702 654 MB capacity MO disk  and DC 502  654 MB capacity WORM disk     The SCSI command set for the 9101 conforms to the 7101 series SCSI specifications  upward  compatible Mode 0  Mode 1 and Mode 2   It has plug in compatibility with DE 7001 or DD 5101  Mode  0 and Mode 1      The 9101 supports both synchronous and asynchronous data transfers     The DE SH9101 drive must be set to Mode 0 or Mode 2 when using Rewritable media and to Mode 1 or  Mode 2 when using WORM media  The drive must be set to Mode 2 when used as a SCSI 2 device  The  drive mode is determined by the settings of the dip switch bits 4 and 5  The dip switch is located on the  rear of the drive     IMPORTANT  Because Mode 2 supports both WORM and MO type media as well as SCSI 2  command set  it is recommended that the user use the drive in Mode 2     NOTE  The bit settings are read by the controller at Power ON and RESET  If the settings of the bits  have changed  the unit must be reset or turned OFF and then ON before the new setting will take place     IMPORTANT  You should only change the bit settings when power to the
5. U PIONEER       The Art of Entertainment       PRODUCTINFORMATION BULLETIN No  PB    _t  0198  Optical Drive Summary          There have been five  5  series of Pioneer optical drives  5000  5100  7000  7100 and 9100  The 5000   5100 and 7000 series were all SCSI 1 type devices and are no longer in production  The 7100 and 9100  series are switchable SCSI 1 and SCSI 2 devices and are still being produced     NOTE  SCSI 2 is the current prevalent industry standard     DE 7001 Series   The DE 7001 series includes the DE S7001 and DE U7001 models  The DE S7001 is an external  subsytem including drive unit  SCSI controller and DC power supply  The DE U7001 is an internal full  height drive unit with SCSI controller  Both models use the DEC 702 rewritable  MO  magneto optical  disk media and the DC 502  WORM  Write Once Read Many  optical disk media     The 7001 series drives must be set to Mode 0 when using Rewritable media and to Mode   when using  WORM media  The settings of the dip switch bits 7 and 8 determine which mode the drive is set to  The  dip switch is located on the rear of the DE S7001 and on the controller board of the DE U7001     The bit settings are read by the controller at Power ON and RESET  If the settings of the bits have  changed  the unit must be reset or turned OFF and then ON before the new setting will take place   IMPORTANT  You should only change the bit settings when power to the device is OFF     NOTE  The Mode setting may also be changed by sendin
6. g the SCSI command CHANGE MODE  Refer  to the SCSI specifications for the corresponding drive for more details     The Modes are set as described in the table below     OFF OFF   Rewritable Mode   Read and write operations are enabled only with ISO  standard  sampled servo format  rewritable disks  Read  and write operations with WORM disks are disabled        1 OFF ON WORM Mode   Read and write operations are enabled only with ISO  standard  sampled servo  SS  format WORM disks   Read and write operations with rewritable disks are  disabled     Page 1of5       Pioneer New Media Technologies  Inc   Engineering Support  310  952 2111       PRO DUCTINFORMATION BULLETIN No  PB  0198          The 7000 series drives have two BUSY LEDs  One is labeled RW for Rewritable and the other is labeled  WO for WORM     When the drive is in Mode 0  Rewritable   WO is OFF and RW blinks when no disk in inserted  If WO is  blinking  the drive detects the presence of a WORM disk  If RW is ON  the disk detects a rewritable disk     When the drive is in Mode 1  WORM   RW is OFF and WO blinks when no disk in inserted  If RW is  blinking  the drive detects a rewritable disk  If WO is ON  the drive detects a WORM disk     DE H7101 Series   The DE H7101 series includes the DE UH7101 and DE SH7101 models  The DE UH7101 is an internal  5 25 inch half height multifunction optical disk drive  The DE SH7101 is an external half height  multifunction optical disk drive subsystem  Both use the media types DEC
    
Download Pdf Manuals
 
 
    
Related Search
    
Related Contents
The Revolutionary Video Wall Controller - ISEMC  A Programming Flash Memory through the Intel386™ EX Embedded  Nokia 32 - Microsoft  Philips Portable video player PV7005  Einhell TH-US 240 - Stand-Bandschleifer    "取扱説明書"  Kawai SR70 User's Manual  twist - Centro Style  76kb    Copyright © All rights reserved. 
   Failed to retrieve file