Home

Peavey DEP-16 User's Manual

image

Contents

1. TYPICAL OPERATING One eg AMPLIFER pclae DEP 16 SPECIFICATIONS La All specifications ore typical unless otherwise noted GUITAR System Architecture _ Logarithmic Compression with 12 bits A D A Quantizing System naona h Kiso eel D JELI i Kal AC ADAPTOR pase Oto 100 Delay Time Maximum 800mS Minimum 1 0 mS Delay Select Flange 1 amp 2 AMPIN Dynamic Range Delay Signal Patch Greater than 100 dB BA EN Dry Direct Signal Path 4 3 dB 20 60 000 Hz O fF Delay Signal Path 1 3 dB 30 9 000 Hz Signal Level 2V RMS 6 dBV 1 kHz Footswitch Functions Effect on off Power Requirements 9 V DC Dry Cell Battery NEDA 1604A IEC 6LR61 Peavey AC Adaptor Part 70900666 Under normal extended playing time use battery operation of this unit is not recommended Power Consumption 80 mifiamps MA Due to our efforts for constant improvements features and specifications are subject to change without notice _ EFFECTS LOOP OPERATION DEP 16 REGARDING EFFECTS LOOPS Stereo Effects Time delay based effects such as choruses flangers and echo should be Placed vnc in the amplifier s rt Processor loop A SPECIAL PRECAUTIONS 8 When using the effects unit with an AC adaptor use only a Peavey supplied 9 volt adaptor or equivalent When the unit is not in use disconnect the instrument or signal source from the Input jack fo prolong battery life When the unit is not to be use
2. 16 to be patched into high level effects loops for the best in post delay effects Rugged die cast construction along with silent FET soft touch effects switching and effect on LED indication complete the very musical DEP 16 DEPTH SPEED This control provides a dual adjustment of the LFO modulation depth and speed frequency in the full counterclock wise position the modulation is off Rotating this control clockwise increases the depth from 0 to 100 a 4 1 sweep and simul taneously decreases the speed from 10Hzto0 1 Hz This synchronized _ parameter control greatly simplifies the operation of this unit and allows the operator a wide variety of musically pleasing effects EFFECT LEVEL Controls the relative volume of the delayed signal or the delay dry mix Maximum delayed signal level is obtained by rotating the control fully clockwise In this position the level of the delayed signal is equal fo that of the direct signal NOTE This control affects only the delayed signal REGENERATION LEVEL Controls the number of repeats or the delay time for the delayed signal A single repeat is available with the control set fully counterclockwise Increasing numbers of repeats or longer delay times are obtained as the control is rotated clockwise SELECT Selects one of sixteen delay ranges The available delay increases with clockwise rotation of this control with the maximum mail being at the 6 o clock posit
3. d for an extended period of time disconnect and remove the battery from the battery com partment to avoid any possible leakage 6 When the LED becomes dim or the perfomance of the unit seems less than optimum replace the battery For extended time use it is advisable to use a Peavey AC adaptor to power the effects unit PEAVEY ELECTRONICS CORP 711 A SIREET MERIDIAN MS 39301 USA sa lh nek TELEPHONE 601 483 5365 TELEX 504115 OPERATING r axe L Jf INSTRUCTIONS DEP 16 STEREO EFFECTS PROCESSOR o Full bandwidth frequency response Studio Quiet 42 bit A D A Expanded dynamic range 46 position Delay Select Switch o Proprietary custom VLSI design Stereo outputs Silent FET effects switching The DEP 16 Stereo Effects Processor is an ultra quiet studio quality digital effects processor Sixteen delay ranges along with LFO regeneration and effect level controls allow the creation of a variety of effects including chorus flanging delay and vibrato Full 12 bit A D quantization is made possible by Peavey s proprietary VLSI custom IC along with subminiature surface mount techniques Superior sound quality and no compromise attention to detail have made the DEP 16 one of today s finest and most flexible floor delay pedals Many large rack mount delays fall short of the sparkling crystal clean delay sound of the DEP 16 High headroom line level capability allows the DEP
4. ion the DEP 16 delay ranges include Position 4 Flange 1 Position 9 200mS Delay Position 2 Range 2 Position 40 250mS Delay Position 3 Chorus 4 Position 44 300mS Delay Position 4 Chorus 2 Position 12 350mS Delay Position 5 50ms Delay Position 43 400mS Delay Position 6 75mS Delay Position 44 500mS Delay Position 7 100mS Delay Position 15 650mS Delay Position 8 150mS Delay Position 46 800mS Delay FUNCTIONS OUTPUT A JACK AC ADAPTOR JACK INPUT JACK PRE 6 i EFFECT ON BATTERY ACCESS ON BOTTOM INPUT JACK Used as a signal input to the effects unit This jack also acts as a power switch for the unit when an instrument is plugged in When the effect is not in use the instrument should be dis connected from this jack to maximize battery life AC ADAPTOR JACK Used as an altemative 9 volt power source when battery operation is not the most desirable Use only Peavey 9 volt AC adaptor or equivalent OUTPUT A JACK Used as a low impedance signal output for the out of phase chorus signal in normal stereo operation If a Gry direct output is desired from this output simply use a stereo RTS phone plug in this jack with the ring contact disconnected and the chorus effect will be disabled from this output The chorus effect will still be available in the Output B jack in this mode of OUTPUT B JACK Used as a low impedance signal output for the in phase chorus signal in normal operation Thi
5. s jack is also recommended for monaural operation EFFECT ON LED INDICATOR Indicates when the effect is enabled When the effect is on the LED is illuminated This LED also provides a visible indication of the battery status If the LED fails to light or appears dim replace the battery EFFECTS SWITCH Enables and disables the DEP 16 effect Depressing this dome switch with the foot or hand tums the effect on or off Silent FET effects switching minimizes any pops or clicks when the effect is enabled or disabled a BATTERY ACCESS The battery compartment is located on the bottom of the effects unit A captive thumb screw is provided for easy access fo the cushioned rubber compartment LED INDICATOR

Download Pdf Manuals

image

Related Search

Related Contents

取扱説明書  StarTech.com SAT3510U3VGB storage enclosure  WD420 - ImageBank  取扱説明書ダウンロード  MOPSIC – An Extended Version of MOPSI  Sample Tender paper for 100 mA Mobile X-ray 50 KW Static  

Copyright © All rights reserved.
Failed to retrieve file