Palm 3350WW User's Manual
Contents
1. the disposal of batteries in household or business trash may be prohibited For battery disposal instructions visit www palm com environment Q CARING FOR YOUR BATTERY CHARGER Important safety and legal information FCC statement This device complies with part 15 of the FCC rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Reorient or relocate the receiving antenna e Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a c2. Cha rger the smartphone battery is being charged To charge a smartphone battery with your Battery Charger do the following 1 Grasping both sides of the lid open the Battery Charger 2 Insert a smartphone battery into the Battery Charger so that the battery contacts align with the contacts in the Battery Charger 3 Close the lid until it lightly snaps shut 4 Connect the battery charger to the AC charger that came with your smartphone Use the AC charger included with your smartphone NOTE Connecting other power supplies to the Battery Charger may damage or destroy your smartphone battery Use only power supplies that are approved by Palm For more information go to www palm com 4 USING YOUR BATTERY CHARGER Indicator lights Solid red indicates that the smartphone battery is being charged Solid green indicates that the smartphone battery is charged Solid yellow indicates that the battery being charged has become too hot or too cold to safely charge Move the Battery Charger to a location that is at room temperature Flashing yellow indicates a damaged smartphone battery or a power supply error CAUTION If the indicator light is flashing yellow immediately disconnect your Battery Charger Be sure you are using a functional Palm smartphone battery as well as a functional Palm charger NOTE For additional troubleshooting information about your Battery Charger go to www palm com supp
3. m me si ces interf rences perturbent son fonctionnement Ce IMPORTANT SAFETY AND LEGAL INFORMATION C CE compliance statement This product was tested by Palm Inc and found to comply with all the requirements of the EMC Directive 89 336 EEC as amended Palm Take Back and Recycling Program This symbol indicates that Palm products should be recycled and not be disposed of in unsorted municipal waste Palm products should be sent to a facility that properly recycles electrical and electronic equipment For information on environmental programs visit palm com environment As part of Palm s corporate commitment to be a good steward of the environment we strive to use environmentally friendly materials reduce waste and develop the highest standards in electronics recycling Our recycling program keeps Palm handheld devices smartphones and mobile companions out of landfills through evaluation and disposition for reuse and recycling Palm customers may participate in the recycling program free of charge Visit palm com recycle for additional details and information about how you can help reduce electronic waste Static Electricity ESD and Your Palm Device Description of ESD Static electricity is an electrical charge caused by the buildup of excess electrons on the surface of a material To most people static electricity and ESD are nothing more than annoyances For example after walking over a carpet while scuffing you
4. Battery Charger Intellectual property notices 2008 Palm Inc All rights reserved Palm and the Palm logo are among the trademarks or registered trademarks owned by or licensed to Palm Inc All other brand and product names are or may be trademarks of and are used to identify products or services of their respective owners Disclaimer and limitation of liability Palm Inc assumes no responsibility for any loss or claims by third parties which may arise through the use of this device and any accompanying or associated software provided by Palm Inc Palm Inc assumes no responsibility for any damage or loss caused by deletion of data as a result of malfunction dead battery or repairs Be sure to make backup copies of all important data on other media to protect against data loss Palm Inc assumes no responsibility for any damage or loss resulting from the use of this manual v 1 0 ntrod uction Using the Battery Charger and the AC charger that came with your smartphone or another power supply approved by Palm The Palm Battery Charger is a convenient you can be sure that your smartphone pocket sized traveler s charger for various battery is ready to use whenever you Palm smartphone batteries need it NOTE To find compatible smartphone batteries go to www palm com INTRODUCTION 3 Using your Battery 5 Connect the AC charger to a wall outlet 6 Check the indicator light to confirm that
5. ircuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help The use of shielded I O cables is required when connecting this equipment to any and all optional peripheral or host devices Failure to do so may violate FCC rules IMPORTANT Changes or modifications not covered in this manual must be approved in writing by the manufacturer s Regulatory Engineering Department Changes or modifications made without written approval may void the user s authority to operate this equipment Responsible party Palm Inc 950 W Maude Avenue Sunnyvale CA 94085 2801 United States of America 408 617 7000 www palm com Battery Charger Tested to Comply With FCC Standard FOR HOME OR OFFICE USE C Canadian ICES 003 statement This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation Cet appareil num rique de la classe B respecte toutes les exigences du R glement sur le mat riel brouilleur du Canada Son utilisation est sujette aux deux conditions suivantes 1 Cet appareil ne doit pas produire d interf rences nuisibles et 2 il doit pouvoir supporter toute interf rence re ue
6. lf when you re holding your device by simultaneously touching a metal surface that is at earth ground For example if your computer has a metal case and is plugged into a standard three prong grounded outlet touching the case should discharge the ESD on your body e Increase the relative humidity of your environment e Install ESD specific prevention items such as grounding mats Conditions that enhance ESD occurrences Conditions that can contribute to the buildup of static electricity in the environment include the following e Low relative humidity e Material type The type of material gathering the charge For example synthetics are more prone to static buildup than natural fibers like cotton e The rapidity with which you touch connect or disconnect electronic devices While you should always take appropriate precautions to discharge static electricity if you are in an environment where you notice ESD events you may want to take extra precautions to protect your electronic equipment against ESD 8 IMPORTANT SAFETY AND LEGAL INFORMATION
7. ort Caring for your Battery Charger General information e Use only the AC charger that came with your smartphone a Palm Vehicle Power Charger or another power supply approved by Palm CAUTION Use only power supplies approved by Palm Unapproved power supplies could damage the Battery Charger or the battery being charged and may cause personal injury e Don t use the Battery Charger in areas where sparks could pose a hazard e Don t let the Battery Charger s metal contacts or electrical socket come in contact with metal objects e Don t expose the Battery Charger or your spare batteries to rain or other liquids e Avoid using the Battery Charger at high temperatures above 65 C 149 F such as in a hot vehicle or in direct sunlight CARING FOR YOUR BATTERY CHARGER G e Keep the metal contacts and the electrical socket on the Battery Charger clean and free from debris that could obstruct charging or could cause a short circuit Battery safety and disposal information e Keep the metal contacts on the battery clean e Don t attempt to disassemble or short circuit the battery CAUTION To avoid being burned do not handle a damaged or leaking lithium ion Li ion battery e Never dispose of a battery by incineration CAUTION Burning a battery may cause an explosion and personal injury e Be sure to dispose of your battery in an environmentally responsible and legal way NOTE In some areas
8. r feet building up electrons on your body you may get a shock the discharge event when you touch a metal doorknob This little shock discharges the built up static electricity ESD susceptible equipment Even a small amount of ESD can harm circuitry so when working with electronic devices take measures to help protect your electronic devices including your Palm device from ESD harm While Palm has built protections against ESD into its products ESD unfortunately exists and unless neutralized could build up to levels that could harm your equipment Any electronic device that contains an external entry point for plugging in anything from cables to docking stations is susceptible to entry of ESD Devices that you carry with you such as your Palm device build up ESD in a unique way because the static electricity that may have built up on your body is automatically passed to the device Then when the device is connected to another device such as a docking station a discharge event can occur Precautions against ESD Make sure to discharge any built up static electricity from yourself and your electronic devices before touching an electronic device or connecting one device to another The recommendation from Palm is that you take this precaution before connecting your Palm device to your computer placing a device in a cradle or connecting it to any other device You can do this in many ways including the following e Ground yourse
Download Pdf Manuals
Related Search