Mistral MEC1R User's Manual
Contents
1. disconnected before cleaning The appliance must only be stored and operated in a horizontal position Before use always ensure the Evaporative Cooler contains water After cleaning water should be replaced e Where humidity is high the Evaporative Cooler should be operated at normal fan type e Do not use corrosive liquids when cleaning COMPULSORY WARNING If the supply cord is damaged it must be replaced by the manufacturer or its service agent ora similarly qualified person in order to avoid a hazard This product has not been designed for any uses other than those specified in this booklet Save These Instructions Features of your Evaporative Cooler Water Box Cover Front Control Panel Automatic Louvre Vertical Manual Louvre Horizontal Water Level Indicator Water Box Water Box Cover Legs Back Evaporated Net Holder inside Dust Proof Net inside Evaporated Net Rubber Plug Legs Getting to know your Evaporative Cooler Congratulations on the purchase of your new Evaporative Cooler by Mistral Before first using your new Evaporative Cooler it is most important that you read and follow the instructions in this use and care booklet2. even if you feel you are familiar with this type of appliance Your attention is drawn particularly to the section dealing with IMPORTANT SAFEGUARDS Find a safe and convenient place to keep this booklet handy for future reference This appliance has been designed to operate from a standard domestic power outlet It is not intended for industrial or commercial use Your Evaporative Cooler uses energy efficient technology to bring fresh air into your home or office The air cooling efficiency value is greater than that of traditional air conditioners It also has zero impact on the ozone layer helping to reduce the greenhouse effect In addition to the fan and timing operations your Evaporative Cooler has natural air fan and sleep functions Operation of your Evaporative Cooler Before first use remove all packaging material and ensure your Evaporative Cooler is in good condition Add cold or iced water by opening the water box cover and filling it to the highest level indicated Control Panel on unit Note The functions on the control panel are the same as those on the remote control On off Pressing the on off switch will turn the Evaporative Cooler on at medium speed After 3 seconds it will revert back to low speed or to the pre programmed memory settings When the Evaporative Cooler is in operation pressing this switch will turn it off The memory function will remember the settings in u
3. N JSN 0 mistral Evaporative Cooler 8 Litre a e mistral Important Safeguards When using electrical appliances in order to reduce the risk of fire electric shock and or injury these basic safety precautions should always be followed For Your Safety Read all instructions carefully even if you feel that you are familiar with the appliance The appliance is not intended for use by children or infirm persons without supervision Children should be prevented from playing with the appliance Switch off the power outlet and remove the plug when the appliance is not in use Do not operate any appliance with a damaged cord or plug if the appliance malfunctions or if it is dropped or damaged in any manner Do not use outdoors Do not use any appliance for anything other than its intended use This product is intended for household use only This appliance is intended to be plugged in a 240v power outlet only Do not misuse the cord Never carry the appliance by the cord or pull to disconnect it from the outlet Instead grasp the plug and pull to disconnect Do not attempt to repair disassemble or modify the appliance There are no user serviceable parts Arrange the power cord away from traffic areas where it will not be tripped over Do not insert or allow foreign objects to enter the grille openings as this may cause damage to the appliance and or user The Evaporative Cooler must be
4. g the above procedure Wheel Blade Pump s Mouth Top Cover e Pump Body Rotor Pump Screw Water Water Box Box Cover Note If the Evaporative Cooler stops working efficiently drain the water from it and operate it on normal fan type at high speed for 1 2 hours to allow the evaporated net to dry Specifications Product Code MEC1R Product Name 8L Evaporative Cooler Rating Voltage 220 240V Rating Freguency 50Hz Total Rated Input 60W CFM 5m3 Noise Lp lt 54Db Lw lt 65Db Maximum Water Capacity 8L Net Weight 8kg Size 400 w x 270 d x 680 h For indoor use only Troubleshooting Problem Possible Cause Possible Solution The indicator is not lighting The Evaporative Cooler is not connected toa power outlet or the power outlet is not switched on The circuit board is damaged Insert the plug into a power outlet and make sure the outlet is switched on Do not attempt to fix the circuit board Send it to a qualified repair centre for servicing The Evaporative Cooler is not operating The motor has over heated Allow the Evaporative Cooler time to cool before turning it on The louvre won t oscillate The direction key has not been touched The louvre motor is damaged Press the direction key once Press it again to turn the oscillating feature off Do not attempt to fix the louvre motor Send itt
5. ights are lit the timer is not set Flow Press this key to turn on or off the automatic vertical louvre function The direction can also be adjusted by using the manual horizontal louvre Cool Air Press this key to start and stop the flow of cool air Care and Cleaning Always disconnect electrical appliances before cleaning them Never spray with liguids or submerge the Evaporative Cooler in water or any other liguid Note If the cordset of this appliance becomes damaged discontinue use Repairs should be undertaken only by a gualified technician Cleaning the Dust Proof and Evaporated Nets To clean the dust proof and evaporated nets ensure the Evaporative Cooler is turned off and disconnected from the power outlet Press the dust proof net and pull it out of the main unit Twist off the two screws on the back cover and take them out Twist off the two screws between the evaporated net holder and the wind channel then remove the evaporated net from its holder Clean both using a damp sponge or cloth Cleaning the Pump Before cleaning the pump ensure the Evaporative Cooler is turned off and disconnected from the power outlet remove the rubber plug from the back ofthe unit and drain the water Remove the back cover twist off the two screws of the pump and remove the rotor Clean it with a damp sponge or cloth and dry thoroughly before reinstalling it by reversin
6. o a gualified repair centre for servicing The temperature of air being expelled from the Evaporative Cooler is not cold enough The pump is damaged The dust proof net is blocked The pump needs to be cleaned Follow the directions under Care and Cleaning to clean the pump Do not attempt to fix the pump Send it o a gualified repair centre for servicing The timer is not operating Follow the directions under Care and Cleaning to clean the dust proof net The fantype can t be operated The evaporated netis blocked Follow the directions under Care and Cleaning to cleanthe evaporated net The speed can t be operated The circuit board is damaged Do not attempt to fix the circuit board Send itto a gualified repair centre for servicing Warranty The benefits conferred by this warranty are in addition to all implied warranties other rights and remedies in respect of the product which the consumer has under the Trade Practices Act and similar State and Territory Laws The original purchaser of this Mistral product is provided with the following warranty subject to the following conditions Linda Australia Pty Ltd warrant this product for a period of 2 years from the date of purchase for all parts defective in workmanship or materials The product or defective parts will be replaced free of charge WARRANTY CONDITIONS 1 This warranty is only valid for appliances used according
7. se when the Evaporative Cooler is turned off and re use the same settings when it is switched on again Speed Press this key to choose between low medium and high fan speeds Fan Type Use the fan types key to choose between normal nature and sleep fan types Normal Normal settings are high medium or low depending on speed selected Nature Nature settings provide a soft and comfortable environment with a choice of high medium or low fan speeds Sleep The sleep function uses the natural fan type and slowly lowers the speed of the Evaporative Cooler before finally turning it off altogether At high speed the Evaporative Cooler will operate at the highest speed for 30 minutes the medium speed for 30 minutes and the low speed for 30 minutes before turning off At medium speed the Evaporative Cooler will operate at the medium speed for 30 minutes and the low speed for 30 minutes before turning off At low speed the Evaporative Cooler will operate at low speed for 30 minutes before turning off Timer The timer settings are for 0 5 1 2 or 4 hours When the timer is set the indicator LED will show it is in use Press it once and the 0 5 indicator will illuminate Press it again and the 1 indicator will illuminate having both the 0 5 and the 1 hour indicators lit indicates the timer is set for 1 5 hours Pressing the timer button four times in total will set the timer for 7 5 hours When none of the timer l
8. to that shown Cat No MEC1R June 2003 Product of Linda Australia Pty Ltd ABN 60 079 923 130 A member of the Mistral International Pty Ltd group of companies 324 Frankston Dandenong Road Dandenong South Victoria Australia 3175 Telephone 03 9212 1333 Facsimile 03 9212 1340 Customer Service 1300 654 488 Internet Address www mistral com au RINGGRIP NZ Pty Ltd ACN 006 771 922 PO Box 51317 Pakuranga Auckland NZ Telephone 0800 328 280 Facsimile 0800 328 238 Manufactured for Linda Australia 2003 Linda Australia Pty Ltd
9. to the manufacturer s instructions 2 This appliance must not be modified or changed in any way 3 Connection must be to the voltage reguirements as specified in the ratings label located on the product 4 The manufacturer does not accept liability for any direct or conseguential damage loss or other expense arising from misuse or incorrect installation and operation of the appliance 5 Warranty will only be given where proof of purchase is provided e g original invoice 6 Notdesigned or warranted for industrial or commercial use DO NOT SEND IN THIS WARRANTY Fill out the following details and file with your purchase invoice RETAIN amp FILE WITH YOUR RECEIPT Your Purchase Receipt Invoice is proof of date of purchase You must be able to present it at the place of purchase to obtain a replacement or service under warranty Linda Australia Pty Ltd reserves the right to discontinue items modify designs and change specifications without incurring obligation Whilst every effort is made to ensure that descriptions specifications and other information in this publication is correct no warranty is given in respect thereof and the company shall not be liable for any errors therein Purchased from Co Name Address Date of Purchase NOTE Consistent with our continuing product development policy improvements may have been made which render the contents of this package slightly different
Download Pdf Manuals
Related Search