Milan Technology MiLAN MIL-GBIC-LX10 User's Manual
Contents
1. ferrules of the optical connector 90000427 _A2. BIC into the bay until you hear a click The click indicates the GBIC is locked into the bay Step 5 When you are ready to attach the fiber optic cable remove the rubber plugs from the GBIC and save for future use GBIC Removal Caution When removing or inserting a GBIC it is recommended to wear an ESD wrist strap Note GBICs are hot swappable To remove a GBIC perform these following steps Step 1 Disconnect the fiber optic cable from the front of the GBIC Step 2 Release the GBIC from the bay by simultaneously squeezing the plastic tabs one on each side of the GBIC and pull gently towards you Note For SFP GBICs locate the release arm at the front of the GBIC and swing the release arm down Pull the arm gently towards you this will release the locking mechanism on the bottom of the GBIC Step 3 Slide the GBIC out of the bay Step 4 Install the rubber plugs back into the GBIC optical bores and place the GBIC in anti static protective packaging GBIC Care and Handling Follow these GBIC care and handling guidelines GBICs are static sensitive To prevent ESD damage follow your normal board and component handling procedures GBICs are dust sensitive When the GBIC is stored or when a fiber optic cable is not plugged in always keep plugs in the GBIC optical bores The most common source of contaminants in the optical bores is debris picked up on the ferrules of the optical connectors Use an alcohol swab or Kim Wipe to clean the
3. Gigabit Interface Converters Release Note 1 0 MiLAN Technology Release Note 7 6 2004 Thank you for purchasing MiLAN s Gigabit Interface Converter GBIC This release note applies only to the following models MiLAN Part Numbers MIL GBIC SX 1000BaseSX SC type connecter GBIC module multi mode 2km MIL GBIC LX10 1000BaseLX SC type connecter GBIC module single mode 10km MIL SFP SX 1000BaseSX LC type connecter SFP module multi mode 2km MIL SFP LX10 1000BaseLX LC type connecter SFP module single mode 10km This Release Note describes how to install remove and maintain Gigabit Interface Converters GBICs Caution Unnecessary removal insertion of a GBIC could lead to premature failure of the GBIC A GBIC has an approximate lifetime of 100 to 500 removals insertions GBIC Installation Caution When removing or inserting a GBIC it is recommended to wear an ESD wrist strap Note GBICs are hot swappable To install a GBIC perform these following steps Step 1 Remove the GBIC from its protective packaging Step 2 Verify that the GBIC is the correct type for your network by checking the part number The number indicates whether it is 1000BaseSX multi mode 1000BaseLX single mode Step 3 Grip the sides of the GBIC with your thumb and forefinger insert the GBIC into the GBIC bay Note For SFP GBICs keep the release arm in up position and insert the module into the SFP GBIC bay Step 4 Slide the G
Download Pdf Manuals
Related Search