Metra Electronics DODGE 99-6540 User's Manual
Contents
1. A Strip wire ends back 72 B Twist ends together C Solder D Tape Locate the factory wiring harness in the Locate the upper dash tab in the sub dash and dash Metra recommends using the bend the tab down A proper mating adaptor and making connections as shown Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit Re connect the battery terminal and test the unit for proper operation Mount the head unit kit assembly to the sub dash with 2 screws Place the Faceplate into the dash trim bezel and mount with 3 3 8 Phillips screws supplied rev 100103 KIT FEATURES Mela Pa Metra Division of METRACORP me Shalt and DIN unit provisions o m amp 5 4 Q KIT COMPONENTS IN STALLATI ON INSTRUCTIONS APPLICATIONS CAR PAGE DODGE Van full size 1990 97 c ceccecceccessessessessessesseseeseee 1 3 mas 3 3 8 Phillips Qu Screws a TOOLS REQUIRED a e Phillips screwdriver es Cutting tool 1 800 221 0932 www metraonline com COPYRIGHT 2001 METRA ELECTRONICS CORPORATION Disconnect the negative battery terminal to prevent an accidental short circuit Open the glove box and remove 2 Phillips screws securing the right edge of the dash trim bezel Remove 5 screws from the bottom of the dash trim bezel Pull out on the upper edge of the bezel and remove 2 SHAFT H2. EAD UNITS Slide the aftermarket head unit into the kit and secure with shaft nuts see Fig A DIN HEAD UNITS Cut and remove the shaft supports from the Radio Housing Slide the DIN cage into the kit and secure by bending the metal locking tabs down Slide the aftermarket head unit into the cage until secure see Fig B Using the dimensions above cut and remove the rear portion of the factory pocket from the radio trim bezel Locate the recessed slots on the top of the Faceplate and drill 1 3 16 hole into each slot
Download Pdf Manuals
Related Search