Metra Electronics 99-3101 User's Manual
Contents
1. metal bracket housing and remove the controls 2 SHAFT HEAD UNITS Slide the aftermarket head unit into the kit and secure with shaft nuts see Fig A DIN HEAD UNITS Cut and remove the shaft supports from the Replacement Bezel Slide the DIN cage into the kit and secure by bending the metal locking tabs down Slide the aftermarket head unit into the cage until secure see Fig B connections as shown Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit Re connect the battery terminal and test the unit for proper operation Mount the head unit kit assembly to the sub dash with 4 screws previoulsy removed in step 12. rev 271202 KIT FEATURES f ACORP 99 3101 w Incorporates factory climate N S TALLATI ON vim INSTRUCTIONS em Shaft and DIN unit provisions KIT COMPONENTS APPLICATIONS Replacement CAR PAGE CHEVROLET Beretta 1988 90 models equipped with AC 0 c sssss 1 2 Corsica 1988 90 models equipped With AC 0 c sss 1 2 TOOLS REQUIRED Phillips screwdriver a Cutting tool J 1 800 221 0932 www metraonline com Adjustable wrench COPYRIGHT 2001 METRA ELECTRONICS CORPORATION A Strip wire ends back 7 B Twist ends together C Solder D Tape Locate the factory wiring harness in the Mount the climate controls to the back of the dash Metra recommends using the Replacement Bezel with 4 screws previously proper mating adaptor and making removed in step 1 Disconnect the negative battery terminal to prevent an accidental short circuit Unclip the trim bezel surrounding the factory head unit and climate controls Remove 4 screws securing the head unit climate control assembly Reach under the dash and remove the colored tubing assembly connected to the mode control on the climate control panel Pull the head unit climate control assembly from the dash and disconnect the wiring Remove 4 screws securing the factory head unit to the metal bracket housing and remove the unit Remove 4 screws securing the climate controls to the
Download Pdf Manuals
Related Search