Maytag MGR7662W User's Manual
Contents
1. PRODUCT MODEL NUMBERS MGR7662W Type of Gas Natural Gas This range is design certified by CSA International for use with Natural gas or after proper conversion for use with LP gas e This range is factory set for use with Natural gas See Gas Conversions section The model serial rating plate located on the oven frame behind the top left side of the oven door has information on the types of gas that can be used If the types of gas listed do not include the type of gas available check with the local gas supplier LP gas conversion Conversion must be done by a qualified service technician No attempt shall be made to convert the appliance from the gas specified on the model serial rating plate for use with a different gas without consulting the serving gas supplier See Gas Conversions Section Gas Supply Line Provide a gas supply line of 34 1 9 cm rigid pipe to the range location A smaller size pipe on longer runs may result in insufficient gas supply With LP gas piping or tubing size can be Ya 1 3 cm minimum Usually LP gas suppliers determine the size and materials used in the system NOTE Pipe joint compounds that resist the action of LP gas must be used Do not use TEFLON tape e f local codes permit a new CSA design certified 4 to 5 ft 122 to 152 4 cm long 12 1 3 cm or 3 4 1 9 cm I D flexible metal pon connector may be used for connecting range to the gas supply line e A2. 1 2 1 3 cm male pipe thread is needed for connection to the female pipe threads of the inlet to the appliance pressure regulator e Must include a shutoff valve The supply line must be equipped with a manual shutoff valve This valve should be located in the same room but external to the range opening such as an adjacent cabinet It should be in a location that allows ease of opening and closing Do not block access to shutoff valve The valve is for turning on or shutting off gas to the range Electrical A 120 volt 60 Hz AC only 15 amp fused electrical circuit is required A time delay fuse or circuit breaker is also recommended It is een that a separate circuit serving only this range be provided TEFLON is a registered trademark of E l Du Pont De Nemours and Company CABINET OPENING DIMENSIONS 30 76 2 cm Freestanding Gas Range PRODUCT DIMENSIONS A 272 69 9 cm max depth with handle B 36 91 4 cm cooktop height max with leveling legs screwed all the way in C 467 119 1 cm overall height max with leveling legs screwed all the way in D 29 75 9 cm width E 25 63 9 cm F Model serial rating plate located on the oven frame behind the top left side of the oven door Range can be raised approximately 1 2 5 cm by adjusting the leveling legs Cabinet opening dimensions shown are for 25 64 0 cm countertop depth Because Whirlpool Corporation policy includes a continuous comm
3. form and the bottom of an uncovered wood or metal cabinet Ref W10413013A
4. itment to improve our products we reserve the right to change materials and specifications without notice Dimensions are for planning purposes only For complete details see Installation Instructions packed with product Specifications subject to change without notice 5 20 11 24 61 0 cm base cabinet depth and 36 91 4 cm countertop height IMPORTANT If installing a range hood or microwave hood combination above the range follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface A 18 45 7 cm upper side cabinet to countertop B 13 33 cm max upper cabinet depth C 30 76 2 cm min opening width D For minimum clearance to top of cooktop see NOTE E 30 76 5 cm min opening width F The shaded areas are recommended for installation of rigid gas pipe G 4 11 4 cm H 8 20 3 cm 1 17 43 2 cm J 2 5 7 cm K 42 11 4 cm L 2 5 1 cm min clearance from both sides of range to side wall or other combustible material M Grounded outlet N Cabinet door or hinges should not extend into the cutout NOTE 24 61 0 cm minimum when bottom of wood or metal cabinet is covered by not less than 14 0 64 cm flame retardant millboard covered with not less than No 28 MSG sheet steel 0 015 0 4 mm stainless steel 0 024 0 6 mm aluminum or 0 020 0 5 mm copper 30 76 2 cm minimum clearance between the top of the cooking plat
Download Pdf Manuals
Related Search