Maytag 12001908 User's Manual
Contents
1. 2 MAYTAG TOP LOAD WASHER LID SWITCH KIT 12001908 Instruction anne S heet 6 2612390 1201 This instruction sheet is to be used with REPAIR PART NO 42001908 MPN 6 2306250 DESCRIPTION LID SWITCH KIT TOOLS REQUIRED Phillips Screwdriver PLUNGER ip Y A p LID SWITCH The purpose of this instruction is to inform you of changes made to the switch making the switch no longer adjustable The lid switch mechanism is designed to shut off the machine if the lid is lifted no more than 1 7 8 and will allow the machine to start when the lid is less than 1 4 high The plunger is only used with Atlantis washers Note The new lid switch identified with a grey button is now non adjustable You cannot adjust by pulling on the lid switch button Procedures Disconnect power Remove console to gain access to lid switch Lift lid slightly to remove pressure on the lid switch Remove lid switch and install new Reverse the afore mentioned steps Verify proper lid opening per measurements in the first paragraph N O 9 A y No If machine continues to not operate properly please follow information shown on the follow ing page 240 Edwards Street Cleveland TN 37311 Dependable Care Performa L Washers the enclosed lid switch is interchangable with the lid switch used on those machines Checking lid switch performance 1 Ifthe switch functions then you may need to adjust bend the unbalance2. lever slightly backward 2 Verify proper lid opening again If the switch shuts off the machine after the lid is opened more than 1 7 8 bend the unbalance lever toward the back if the switch shuts off the machine when the lid is lower than 1 4 bend the unbalance lever toward the front Atlantis washers In addition to the new lid switch a change was also made to the length of the plunger 1 Verify proper lid opening again If the switch shuts off the machine after the lid is opened more than 1 7 8 check the items listed below If the switch shuts off the machine when the lid is lower than 1 4 use the enclosed plunger and check the items listed below Other items that could be interpreted as a problem related to the lid switch are as follows Lid oil canning or chipped porcelain where the lid interfaces with the switch or cam for Atlantis The lid may need to be replaced Lid hinges or hinge balls either not inserted into the lid properly or cracked tations ann Hinge bushings mounted into the top may be cracked or worn ende only Check the cam on the back flange of the lid to make sure it is not worn or roken
Download Pdf Manuals
Related Search