Marvel Industries Refrigerated Wine Chiller User's Manual
Contents
1. Refrigerated Wine Chiller Installation Operation amp Maintenance Instructions Part of AGA Foodservice Group 1 Inspection Remove Packaging Your wine cabinet has been packed for shipment with all parts that could be damaged by movement securely fas tened Before using be sure all packing materials and tape have been removed Important Keep your carton packaging until your wine cabinet has been thoroughly inspected and found to be in good con dition If there is damage the packaging will be needed as proof of damage in transit Note to Customer This merchandise was carefully packed and thoroughly inspected before leaving our plant Responsibility for its safe delivery was assumed by the carrier upon accept ance of the shipment As directed on the side of your packing carton claims for loss or damage sustained in transit must be made on the carrier as follows Exterior Damage Make thorough damage notation on your delivery receipt and have driver acknowledge by signature and date Send a written request asking for an inspection report from carrier Include the name of carrier representative and the date the inspection was requested Retain inspection report and receipt for filing of a claim Concealed Damage This must be reported to the carrier within fifteen days Obtain inspection report from the carrier Retain the inspection report for filing the claim DO NOT RETURN DAMAGED MERCHANDISE TO M2. Before calling for service check the trouble shooting table on this page This table lists possible problems that you can remedy without difficulty to avoid an unnec essary service call If you do need service contact your dealer or the manu facturer In any correspondence refer to the model number and serial number of your unit which is located on the lower front cabinet flange Retain you proof of purchase You may want to record these numbers in the space provided on this page Follow the procedure out lined on page 6 Problem Odor in cabinet Possible Causes Solutions eInterior needs cleaning Noisy operation Cabinet not level Weak floor Cabinet vibrates Cabinet light not working Cabinet not level Weak floor Tube burned out No power at outlet Appliance will not run Temperature control turned to OFF eLine cord not plugged in No power at electrical outlet eHouse fuse blown Appliance runs too long Prolonged door openings Control set too cold Condenser needs cleaning Moisture collects inside Too many door openings Prolonged door openings Hot humid weather increases condensation Moisture collects on outside surface Hot humid weather increases condensation As humidity decreases moisture will disappear Control improperly set Interior too hot too cold Control improperly set Faulty thermometer Relocate thermometer to
3. Industrial Parkway P O Box 997 Richmond IN 47375 0997 41008880 Rev A
4. adjustable from the low forties to the mid sixties The range allows flexibility of temperature preferences and provides the ideal wine aging and storing temperatures Interior Light and Switch The interior light makes it easy to view your wine labels and enhances the dis play of your collection When the switch is in the OFF position the light will come on when the door is opened Roll out Racks The six roll out wine racks may be pulled out approximately 14 inches to facilitate adding or removing bottles Do not lean on or press down heavily on the wine shelves Doing so may damage the shelves and the wine bottles stored on them Pull the wine racks out gently and carefully to minimize unsettling your wine collection Avoid pulling out more than one rack at any time to maintain stability Single Bottle Racks Because bottles are not stacked on top of each other you can easily view and access your inventory without disturbing other bottles E z Under Counter Wine Chiller Specifications Dimensions W x H x D in 23X 34x 24 Weight 156 Ibs Capacity 54 Wine Bottles Temperature 41 63 F Power Supply 115V supplied with a 15 amp plug 4 Before Calling for Service
5. plug How to Operate Your Refrigerated Wine Cabinet Set the Control The total available temperature range of the unit is from the low forties to the mid six ties The middle range on the control is approximate ly 55 F The temperature can be lowered or raised by turning the control clockwise or counterclockwise respectively As with any Control Knob refrigeration product there X is a slight temperature vari ance at different locations within the cabinet For example the coolest bottles will be in the rear of the four Figure 2 middle shelves The bottles on the top two shelves will be 3 to 7 warmer This is the warmest location The bottles in the front of the middle fours shelves will be 1 to 4 warmer than the rear of the shelves Position your wine inventory accordingly To start your appliance use a screwdriver to turn the control clockwise to the middle thermostat setting see figure 2 Once the bottles are loaded allow at least 48 hours for the unit to stabilize before making any adjustments to the initial setting Insert Wine Bottles The six roll out shelves each hold eight bottles The bottom rack holds six bottles that are loaded with necks facing the rear Tall bottles should not be loaded on the bottom rack because they may prevent the door from closing Rear Bottles Necks Facing Front Front Bottles Necks Facing Rear NANANA NANANA Figure 3 Loading Tips and Sugg
6. ANUFACTURER FILE THE CLAIM WITH THE CARRIER How to Install Your Refrigerated Wine Cabinet Select Location The proper location will ensure peak performance of your appliance Choose a location where the unit will be out of direct sunlight and away from heat sources Best performance will be main tained when installed within the following parameters Ideal Ambient Temperature Range Built in 65 80 F Free Standing 65 90 F Cabinet Clearance Ventilation is required from the bottom front section of the unit Keep this area open and clear of any obstructions Electrical Connection Use nominal 115 volt 60 cycle AC only DO NOT USE AN EXTENSION CORD Power Supply Cord with 3 Prong Grounding Plug Grounding Type Wall Receptacle Figure 1 Grounding Method This product is factory equipped with a power supply cord that has a three pronged grounded plug It must be plugged into a mating grounding type receptacle in accordance with the National Electrical Code and applicable local codes and ordinances see figure 1 If the circuit does not have a grounding type receptacle it is the responsibility and obligation of the customer to exchange the existing receptacle in accordance with the National Electrical Code and applicable local codes and ordinances The third ground prong should not under any circumstances be cut or removed All U L listed refrigerated products are equipped with this type of
7. center of cabinet and recheck If You Do Need Service In the event that you do need service be sure to report the model number serial number and proof of purchase to your service representative Model number and serial number are found on the serial plate which is located on the lower front cabinet flange For your convenience you may want to record the following information for your records Date of purchase Dealer s Name Dealer s Address Dealer s City Dealer s State Zip Appliance Serial Number Model Number Date Warranty Card Sent Must be within 10 Days of Purchase How to Obtain Service Your refrigerated wine chiller requires little service because the best and most up to date materials equip ment and quality methods are employed throughout the manufacturing process If trouble occurs during normal operation first check the troubleshooting chart on this page to see if any of these simple steps may correct the problem If service becomes necessary Contact the dealer where your appliance was purchased or the manufacturer for the name of your nearest authorized service representative The service represen tatives will have full authority tom make any repair deemed necessary If you are in an area where there is no service repre sentative write or call the manufacturer directly We will make recommendations as to the proper proce dure for correction Service work and rep
8. estions Bottom rack may be removed for storing jug wines You may store magnums and other large bottles on the upper right and left positions of the cabinet shelving or on any of the middle racks by removing the rack directly above them Position white wines on the middle or lower racks and red wines on the upper racks The bottles on the top rack directly under the light will be exposed to a slightly higher temperature when the light is on Position you wines accordingly and REMEMBER TO TURN OFF THE LIGHT WHEN IT IS NO LONGER NEEDED Keep wines that you plan to use for everyday drinking and entertaining on the front half of the racks where labels are completely visible Place wines for aging or longer term storing in rear 2 3 How to Clean and Maintain Your Wine Chiller Condenser The condenser tubing inside the cabinet does not require frequent cleaning however satis factory cooling depends on adequate ventilation over the coils Be sure that nothing obstructs the required air flow openings in front of the cabinet At least once or twice a year brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grille on the bottom front of the cabinet Cabinet The painted cabinet can be washed with mild soap and water and thoroughly rinsed with clear water Never use abrasive scouring powders Interior Wash interior compartment with mild soap and water Do not use an abrasive powder
9. horized by the Company will be payable at the Company s discretion Additional 2nd Through 5th Year Limited Warranty During the four years following the First Year Limited Warranty the company will supply replacement parts for the sealed refrigeration system that are proven to the Company s satisfaction to be defective due workman ship or material Other parts labor costs and freight charges will be the responsibility of the owner Normal Responsibilities of the Owner Include All freight charges Damage sustained in transit see page 1 Mileage charge s for service calls Proper installation Alterations to original equipment Removal or installation of additional equipment IN NO EVENT SHALL THE COMPANY BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES INCLUDING BUT NOT LIMITED TO CONTENT LOSS Some states do not allow limitations on length of time implied warranty may last so the above limitations may not apply to you This warranty gives you specific legal rights You may also have other rights which very from state to state Help prevent tragedies Each year children die because they climb inside a discarded refrigeration product get trapped inside and suffocate Take precautions to prevent such tragedies by removing the door taping or chaining it shut before discarding 6 WWW MARVELINDUSTRIES COM Phone 765 962 2521 Fax 765 962 2493 Marvel Industries Part of AGA Foodservice Group 233
10. lacement parts if required will be provided as covered by your limited warranty IT IS IMPORTANT THAT YOU SEND IN YOUR WARRANTY RECORD CARD IMMEDIATELY AFTER TAKING DELIVERY OF YOUR REFRIG ERATION APPLIANCE Every new refrigeration appliance that leaves the factory contains this Owner s Guide in a safe place for conven ient reference Five Year Limited Warranty This limited warranty is given by the manufacturer here in after referred to as the Company to the original pur chaser of the equipment supplied by the Company as long as the equipment remains the possession of the original purchaser First Year of Limited Warranty The mechanical system of you refrigerator is warrant ed against defects in workmanship or material for a period of one year from date of purchase under the following provisions Warranty card must be filled in and mailed back to the Company within 10 days from the purchase date Defects must be proven to the satisfaction of the Company to have been caused by defects in workman ship or material It may be requested that defective parts be returned to the Company for inspection at the pur chaser s expense The owner is responsible for all items as detailed as the normal responsibilities of the owner In warranty repair should be performed by factory authorized service centers If there is no service center in your area contact your dealer of the manufacturer In warranty repair charges not aut
11. onnectors Make sure they are secure and fully inserted Carefully realign the light tube s electrical terminals back into the rear of the light enclosure channel mak ing sure not to crimp them Gently insert the light tube along the length of the light enclosure channel Press the light tube gently into the light enclosure channel Only a small part of the light tube should project below the ceiling of the wine chiller DO NOT USE A HAMMER TO FIT THE LIGHT TUBE Place the light tube terminal cover plate back in its original position on the light enclosure s flange Re use the original two screws to secure it in place Plug the wine chiller into the electrical socket Check to see if the light tubes operate properly Your light tube s replacement is complete The light tubes are not covered by your guarantee Replacement tubes can be obtained from your serv ice provider or from Marvel Industries What to do in the Event of a Power Failure Most power failures are corrected within two hours and will not affect the unit s temperature providing you minimize the number of door openings while the power is off A gradual rise in temperature should not have any adverse effect on your wine if power is out for a longer period If it is extremely hot you may want to move your wines to the coolest location you can find until power is restored Appliance Features Adjustable Temperature Control The temperature control is fully
12. solvent polish cleaner or undiluted detergent Glass Door Use a glass cleaner or mild soap and water and soft cloth to clean the glass door model Do not use any abrasive powders Door Gasket The vinyl gasket may be cleaned with mild soap and water a baking soda solution or a mild scouring powder Light Tube Replacement WARNING DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT TUBE REPLACEMENT Failure to do so may result in an electrical shock that could severely injure you This product uses two 6 watt light tubes to illuminate the interior of the wine chiller The light tubes are very reliable electrical components but should either or both light tubes not function properly please call the dealer you purchased your wine chiller from for replacement light tubes Use only original equipment light tubes from your dealer or manufacturer Light tube replacement consists of using a small phillips head screwdriver to remove the two screws that hold a cover plate over the back section of the light tube Set the screws and cover plate aside for re assembly later Using a small flat blade screwdriver gently lever the front section of the light tube down to allow it to be pulled clear of the light housing Disconnect the two insulated electrical connectors from the cabinet s electrical cable and discard the old light tube Reconnect the insulated electrical connec tor of the new light tube to the cabinet s electrical cable c
Download Pdf Manuals
Related Search