Linear Satellite Radio 3089 User's Manual
Contents
1. OPERATIONAL CHECK To check operation move back a reasonable distance about 50 ft and press the transmitter button Operation should be reliable at this distance but environment and location of both the transmitter and receiver will affect the range If the transmitter is stowed well out of sight it may be necessary to remove it from its mounting and hold near the windshield Try different locations and positions If operation is still unsatisfactory the problem may be isolated by 1 Checking the door operator If the door will not open when the wall button is pressed the problem is likely to be the operator If the door will open by pressing the wall button but not when the radio control button is pressed the problem is probably in the radios 2 Replacing the transmitter battery lf after performing the above operational checks the controls still do not function they should be returned to your dealer for repair or replacement CAUTION Any changes or modifications in intentional or unintentional radiators which are not expressly approved by LINEAR LLC could void the user s authority to operate this equipment This applies to intentional and unintentional radiators certified per Part 15 of the F C C rules and regulations LINEAR LLC 800 421 1587 e 760 438 7000 www linearcorp com Copyright 2008 Linear LLC 215641 B N MULTI CODE a sy Linear INSTALLATION INSTRUCTIONS DIGITAL TRANSMITTER MODEL 3089 Congratulations2. You have just purchased a MULTI CODE Digital Transmitter which we believe to be the finest product of its kind on the market With a little care this transmitter should provide you with many years of excellent service Please take a moment to read the following instructions and you will find that setting your new transmitter will be quite an easy matter ACCESSING THE CODE SWITCH Insert a small coin into the slot located at the bottom end of the transmitter Twist the coin and remove the access cover to expose the code switch and battery compartment SELECTING A CODE You may set your transmitter to any code you desire but be sure that the code you set matches the code that has been set on your radio receiver The digital code is determined by the positions of the 10 small switches numbered 1 through 10 located in the receiver and transmitter Any combination of ON CLOSED or OFF OPEN positions can be selected by using a small screwdriver or ball point pen NOTE The switches are in the On position when the side next to the number is pressed in In setting your own personal code we strongly urge that several coding schemes be avoided ALL ON ALL OFF 2 4 6 8 10 ON 1 3 5 7 9 ON These positions are similar to our or other manufacturer s test positions or are frequently used Once the code has been set check the operation and replace the hatches TRANSMITTER INSTALLATION The transmitter is completely self contained including
3. battery and can be operated while mounted in the car It is supplied with a clip for attaching to the sun visor if desired If the clip is used attach to the case by sliding it into the recess provided on the back of the transmitter until the small dimples fit into the holes in the clip TRANSMITTER BATTERY REPLACEMENT Replacement battery 9 volt NEDA 1604 Eveready 216 or equivalent The battery in the transmitter can be checked or changed by removing the front lower half of the transmitter Refer to the directions under accessing the code switch for battery replacement TO REPLACE OR ADD A SET A replacement or new transmitter or receiver may be purchased by specifying the Model Number and the RF frequency designated on the identification label The RF frequency is set at the factory and must not be adjusted in the field The digital code can be matched to the companion receiver or transmitter by following the above procedure
Download Pdf Manuals
Related Search