Home

Lightolier LLP100 User's Manual

image

Contents

1. outward towards user Push LUMINAIRE up and pass SCREWS through KEYHOLE SLOTS and shift luminaire to left FIG 2 4 Insert SCREWDRIVER through hole in POWER SUPPLY COVER and tighten down screws to secure luminaire firmly against MOUNTING SURFACE FIG 3 5 Replace HOLE PLUGS into POWER SUPPLY COVER by pushing them back into place FIG 4 6 Make certain SWITCH is in OFF position plug LUMINAIRE into GROUNDED 120V RECEPTACLE by others FIG 4 1 4 MINIMUM LUMINAIRE MOUNTING SURFACE SCREW HEAD CENTER LINE MOUNTING SURFACE FLATHEAD SCREW SCREWDRIVER FIG 2 MOUNTING SURFACE GROUNDED 120V OUTLET BY OTHERS SCREWDRIVER 631 Airport Road Fall River MA 02720 508 679 8131 Fax 508 674 4710 We reserve the right to change details of design materials and finish www lightolier com 2008 Philips Group E0915 PHILIPS Lightolier is a Philips group brand LIGCHTOLIER Instruction Sheet Number IS LLP1 00 Page 3 of 3 Installation Template LED Undercabinet Lighting System 3 8 SHIFTED POSITION FRONT OF LUMINAIRE i FOR KEYHOLE MOUNTING 3 110 13 LUMINAIRE MOUNTING HOLE LOCATIONS Lu ce lt lt SSS SS i gt LL O Lu o Read and understand these instructions before installing luminaire This luminaire is intended for installation in accordance with the National Electrical Code and local regulations To assure full compliance with local cod
2. LICGSH TOLIER instruction Sheet Number IS LLP1 00 Page 1 of 3 Installation of LED Undercabinet Lighting System Read and understand these instructions before installing luminaire This luminaire is intended for installation in accordance with the National Electrical Code and local regulations To assure full compliance with local codes and regulations check with your local electrical inspector before installation To prevent electrical shock turn off electricity at fuse box before proceeding Retain these instructions for maintenance reference Mounting Procedure for Linear Low Profile LED Undercabinet Lighting System LLP100 WHEN USING ELECTRICAL EQUIPMENT BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING 1 DO NOT USE OUTDOORS 2 KEEP LUMINAIRE AWAY FROM CURTAINS DRAPERIES AND SIMILAR MATERIALS CAUTION TO REDUCE RISK OF FIRE ELECTRIC SHOCK OR INJURY TO PERSONS 1 USE ONLY INSULATED STAPLES OR PLASTIC TIES TO SECURE CORDS 2 MAKE SURE CORD IS NOT PINCHED BETWEEN CABINET AND FLOOR 3 ROUTE AND SECURE CORDS SO THAT THEY WILL NOT BE DAMAGED WHEN THE CABINET IS PUSHED TO THE WALL 4 DO NOT INSTALL THESE PRODUCTS ABOVE COOKING RANGES OVENS TOASTERS OR OTHER SOURCES OF HEAT 5 CAUTION THE 3 CONDUCTOR CORD WITH 3 PRONG PLUG MUST NEVER BE ALTERED DO NOT CUT OR ATTEMPT TO REMOVE GROUNDING PRONG USE ONLY IN GROUNDED OUTLET 631 Airport Road Fall River MA 02720 508 679 8131 Fax 508 674 4710 W
3. e reserve the right to change details of design materials and finish www lightolier com 2008 Philips Group E0915 Lightolier is a Philips group brand PH ILI PS LICGSIH TOLIER instruction Sheet Number IS LLP1 00 Page 2 of 3 Installation of LED Undercabinet Lighting System Read and understand these instructions before installing luminaire This luminaire is intended for installation in accordance with the National Electrical Code and local regulations To assure full compliance with local codes and regulations check with your local electrical inspector before installation To prevent electrical shock turn off electricity at fuse box before proceeding Retain these instructions for maintenance reference CAUTION TO PREVENT RISK OF FIRE DO NOT INSTALL IN A COMPARTMENT SMALLER THAN 12 X 18 2 X 12 Installation Instructions 1 Layout luminaire mounting hole locations as shown template enclosed Drive SCREWS provided into MOUNTING SURFACE if appropriate for MOUNTING SURFACE type If SCREWS provided are not appropriate use appropriate hardware for MOUNTING SURFACE type by others SCREWS provided are 8x1 Cross Recessed Pan Head Sheet Metal Tapping Screw Type AB Type IA Leave 1 4 minimum between bottom of SCREW HEAD and MOUNTING SURFACE FIG 1 2 Remove HOLE PLUGS by gently prying them out using a FLATHEAD SCREWDRIVER retain HOLE PLUGS FIG 2 3 Align luminaire s KEYHOLE SLOTS over SCREWS making sure SWITCH is facing
4. es and regulations check with your local electrical inspector before installation To prevent electrical shock turn off electricity at fuse box before proceeding Retain these instructions for maintenance reference 631 Airport Road Fall River MA 02720 508 679 8131 Fax 508 674 4710 We reserve the right to change details of design materials and finish www lightolier com 2008 Philips Group E0915 Lightolier is a Philips group brand PHILIPS

Download Pdf Manuals

image

Related Search

Related Contents

Samsung LE-32C350 32" Full HD Black  Entry Level LCD and DLP Projectors  Moto X Guide de l`utilisateur  Delta 58471-RB-PK Installation Guide  CompactGPS  43.000 COPIE anno XVII n° 06/2012  Vanguard Heating VSGF28PVA Indoor Fireplace User Manual  V5ISKY033-010 KEW 6010B.indd  Vinten Operating Manual  MAX S202_IT_v1.2.indd  

Copyright © All rights reserved.
DMCA: DMCA_mwitty#outlook.com.