Lightolier IS:MHTR User's Manual
Contents
1. REFLECTOR SLOT with the LENS HOLDING TAB and install REFLECTOR as shown in FIG 3 Reinsert REFLECTOR SPRING TABS into SPRING SLOTS on track head the same way it was removed in step 2 Install T4 or T6 lamp as shown on IS 83S Reinsert LENS by placing it behind HOLDING TAB first then positioning it inlo opening Slide LENS SPRINGS into CLOSED position See FIG 1 and 4 LENS HOLDING TAB LIGHTOLHER siete moan2. READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE INSTRUCTION SHEET NO This luminare is intended for installation in accordance with the National Electrical Code and local regulations To assure full compliance with local codes and regulations check with your local elecirical inspector z before installation To prevent electric shock tum off electricity at fuse box before proceeding Retain these instructions for maintenance reference A0803 Page 1 of 1 INSTRUCTIONS FOR INSTALLING A PowerArc MODULAR SPOT REFLECTOR TO A SPOT LUMINAIRE round or square front INSTRUCTIONS FOR INSTALLING A T4 OR T6 PowerArc MODULAR SPOT REFLECTOR See chart below for compatible luminairesreflector combinations LUMINAIRES COMPATIBLE REFLECTORS Cat No DESCRIPTION Cat No DESCRIPTION 8304 T4 OPEN SQUARE SPOT MHT4RS 8314 T4 CLOSED ROUND SPOT MHTZRE 8306 T6 OPEN SQUARE SPOT MHTORS 8316 T6 CLOSED ROUND SPOT MHT6RE CAUTION If used improperly these lamps can cause serious skin burn and eye inflammation from shortwave ultraviolet radiation DO NOT OPERATE LUMINAIRE WITHOUT PROTECTIVE LENS IN PLACE NOTE After reflector is installed see IS 83S for luminaire installation lamping and operating instructions 1 Support LENS and slide LENS SPRINGS into OPEN position Remove LENS See FIG 1 2 Remove REFLECTOR SPRING by depressing spring as shown in FIG 2 unti SPRING TABS are removed from SPRING SLOTS Align
Download Pdf Manuals
Related Search