Lightolier IS:49126LS User's Manual
Contents
1. track The STEM LEVER must be on the same side as the track bead See fig 2 a ana Rotate suspension stem 90 clockwise using STEM LEVER STEM LEVER ae should be parallel to TRACK To remove rotate SUSPENSION STEM 90 counterclockwise using STEM LEVER Repeat steps 2 and 3 with POWER STEM 5 I i es TO l fs R LIGHTOLIER A Gicennr THomas COMPANY 631 Airport Road Fall River MA 02720 ai Fig 4 E CAP NUTS2. READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE INSTRUCTION SHEET NO This luminaire is intended for installation in accordance with the National Electrical Code and local regulations To assure full compliance with local codes and regulations check with your local electrical inspector before IS 49 1 26 LS installation To prevent electric shock turn off electricity at fuse box before proceeding m Retain these instructions for maintenance reference A0105 Page 1 of 1 INSTRUCTIONS FOR 9 12 amp 16 PENDALYTE SERIES TRACK MOUNT TO LYTESPAN TRACK SYSTEM SUSPENSION KITS FOR USE WITH LYTESPAN TRACK SYSTEMS ONLY Note This instruction sheet covers several luminaire styles Powerhead assembly lamp type and reflector style may vary slightly from that shown although installation is the same CAUTION MAXIMUM WATTAGE AS MARKED ON LUMINAIRE MUST NOT BE EXCEEDED POWERHEAD INSTALLATION fig 1 IN A Note On 9 unit MOUNT PLATE must be oriented correctly to clear DOOR SCREW head see fig 1 M j pl y Attach CABLE ADJUSTER to MOUNT PLATE with PANEL NUT q Pass POWERCORD through relief bushing hole in MOUNT PLATE While supporting POWERHEAD ASSEMBLY wire luminaire using WIRE NUTS local POWER SUSPENSION STEM hardware item black luminaire lead to hot black POWERCORD lead white luminaire lead STEM to neutral white POWERCORD lead Attach luminaire ground wire s gre
3. en and or bare to C green ground wire from POWERCORD Height adjustment to raise luminaire push excess POWERCORD down into POWERHEAD Make certain CABLE does not interfere with internal wiring or components both POWERCORD and CABLE may be cut inside POWERHEAD Remove DOOR SCREW and pull DOOR away from POWERHEAD CABLE is inserted into CABLE ADJUSTER Raise luminaire by providing slack in CABLE and pushing through CABLE ADJUSTER Lower POWERCORD luminaire by depressing PLUNGER Secure POWERCORD to MOUNT PLATE with RELIEF BUSHING Attach MOUNT PLATE to POWERHEAD with 8 32 SCREWS CAUTION MAKE CERTAIN WIRES Spe CABLE ADJUSTER SCREW HEAD LANCED TAB ARE NOT PINCHED BETWEEN PARTS BUSHING 8 32 SCREWS iw i DECO TUBE INSTALLATION fig 3 1 Slip bottom of TUBE CLIP over TAB on bottom of POWERHEAD 2 Pivot top of DECO TUBE assembly until X top of TUBE CLIP snaps over SCREW E PANELE NUT HEADS 9 units or LANCED TABS DOOR 12 amp 16 units SOREW Repeat for remaining tube WIRE NUTS p _ poor POWERHEAD ASSEMBLY _ STEM LEVER DIFFUSER DISC INSTALLATION fig 4 1 Install DECO TUBE assemblies to POWERHEAD first 2 Align holes in DISC with ends of DECO NOTE Not for use with ProSpec track TUBES WARNING TO PREVENT ELECTRIC SHOCK TURN OFF POWER TO TRACK INSTALLATION INTO TRACK fig 2 1 Turn off power to TRACK Insert SUSPENSION STEM into
Download Pdf Manuals
Related Search