LifeStride GK26-00002-0023 User's Manual
Contents
1. CLIP TABS of the LOCKING CLIP 90 degrees to secure the NUT into position and prevent it from rotating It may be necessary to back off the NUTslightly to insure that the tabs come in contact with a flat spot on the NUT The LOCKING CLIP TABS can sustain being bent several times to insure a tight lock Step 10 Insert the SWITCH into the SWITCH BODY taking special note to orient the two parts so the SWITCH PLUNGERS make contact upon assembly DO NOT bend the CONNECTOR TABS on the switch NOTE VERIFY THAT THE PLUNGERS ARE MAKING CONTACT BY PRESSING THE STOP BUTTON AND VISUALLY INSURING THEY TOUCH EACH OTHER A CLICKING SOUND WILL BE HEARD FROM THE SWITCH IF THE ASSEMBLY HAS BEEN INSTALLED PROPERLY Step 11 Reconnect the wiring being extremely careful not to bend or break the connecting tabs of the switchand reverse Steps 1 through 3 to return all parts to their proper position M051 00K26 A1612. Lifestride 7500 and 9000 Series How To REMOVE AND REPLACE THE STOP SWITCH Stop Switch Service Kit No GK26 00002 0023 Step 1 Turn the power OFF by unplugging the machine at the wall outlet Step 2 Remove the DISPLAY CONSOLE from the machine Step 3 Remove the BEZEL FACE PLATE from the DISPLAY CONSOLE Step 4 Disconnect the wiring from the worn STOP SWITCH Step 5 Remove the worn STOP SWITCH from the BEZEL ASSEMBLY Depending on the type of switch previously used it may be necessary to damage the existing STOP SWITCH to acccomplish this task Take special care not to cause damage to the BEZEL ASSEMBLY during this procedure BEZEL LOCKING CLP LOCKING CLIP TABS PLUNGER BEND TO SECURE NUT ORIENTATION PLUNGER ORIENTATION SWITCH INSERTED IN BODY SWITCH BODY PLUNGERS MUST BE l SWITCH PROPERLY ORENTED L OCKING TAB SIDE VIEW ASSEMBLED VIEW TOP Step 6 Insert the STOP SWITCH BODY through the opening in the front of the BEZEL ASSEMBLY taking note to orient the SWITCH BODY so the word STOP is readable from the face of the BEZEL Step 7 Slide the locking CLIP from the rear of the BEZEL over the SWITCH BODY Step 8 Install the plastic NUT on to the threaded portion of the SWITCH BODY with the flat side toward the BEZELand tighten 1 8 of a turn past hand tight Torque 10 15 in Ibs CAUTION OVERTIGHTENING THE NUT MAY CAUSE DAMAGE TO THE SWITCH BODY OR THE BEZEL Step 9 Bend each of the two LOCKING
Download Pdf Manuals
Related Search